Audiovox APS-56 - Manual

Audiovox APS-56

Audiovox APS-56 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
Page: / 16

Table of Contents:

  • Page 2 – INSTALLATION OF THE MAJOR COMPONENTS:; PROGRAM SWITCH
  • Page 3 – Starter Output
  • Page 5 – Accessory Output; WIRING CONNECTIONS: 12 Pin Input / Output Harness; Black Wire: Chassis Ground Source; Control Switch; GRAY WIRE: Negative Inhibit Input 1
  • Page 6 – BROWN w/ BLACK Tracer Wire: Positive Inhibit Input 2; Brake Switch Positive Shutdown Detail; Switch
  • Page 7 – LIGHT BLUE Wire: Ignition 3 / Shock Disable Output; from the resistor pack supplied.; General Motors VATS By-Pass Diagram
  • Page 8 – Tachometer Input Wiring Detail; Green/Yellow Wire: Diesel Wait To Start Input
  • Page 9 – Wire Ground Switched Door Lock Circuits:; Wire Ground Switched Door Lock/Unlock Wiring Detail; Wire Positive Switched Door Locks:; Wire Positive Switched Door Lock/Unlock Wiring Detail
  • Page 10 – Pin Blue Connector : Programming Switch; To program these selectable features:
  • Page 12 – switch off. DO NOT attempt to remove the key.
  • Page 14 – METHOD 1
  • Page 15 – under the dash board or in the engine compartment areas.; point these out to the customer.
Loading the manual

128-7451

1 of 16

Kit Contents

(1) - Control Module

(2) - 3 Button High Frequency Transmitters

(1) - 3 Channel Code Learning Receiver

(1) - Multi Pin Input/Output Harness

(1) - Six Pin Power Harness

(1) - Two Pin I/O Harness Factory Alarm By-Pass and Diesel Wait To Start Input

(1) - 2 Pin Door Lock Harness

(1) - 2 Pin Trunk Release Harness (1 Wire Loaded)

(2) - 30 Amp In-line Fuse Holders With Fuses

(1) - Control Switch

(1) - Programming Switch

(1) - Ring Terminal

(4) - 1/2" Long Screws

(1) - Pin Switch

(1) - Remote Start Warning Label

(1) - Literature Package

Model APS-56

Installation Manual

3 Channel Remote Start / Keyless Entry System

Installation Instructions

This Unit Is Intended For Installation In Vehicles With

12 Volt Negative Ground Electrical Systems,

Gasoline or Diesel With True Tach Reference

And Automatic Transmissions Only.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - INSTALLATION OF THE MAJOR COMPONENTS:; PROGRAM SWITCH

128-7451 2 of 16 This Remote Start/Keyless Entry System is designed for use with Automatic Transmission Vehicles Only! Theunit provides wait to start input for glow plug pre-heat which will be used for all diesel applications. If this wire isnot connected, then the unit will remain in the Gasoline m...

Page 3 - Starter Output

128-7451 3 of 16 3 THE RECEIVER/ANTENNA ASSEMBLY: The Superheterodyne Receiver Antenna Assembly provided with this unit allows routing from below the dashboardfor maximum operating range. Choose a location above the belt line (dashboard) of the vehicle for best reception.Special considerations must ...

Page 5 - Accessory Output; WIRING CONNECTIONS: 12 Pin Input / Output Harness; Black Wire: Chassis Ground Source; Control Switch; GRAY WIRE: Negative Inhibit Input 1

128-7451 5 of 16 VIOLET WIRE: Accessory Output Connect this wire to the Accessory wire from the ignition switch. This wire will show + 12 volts when the ignitionswitch is turned to the "ACCESSORY" or "ON" and "RUN" positions and will show 0 volts when the key is turned to the...

Other Audiovox Models