Audiovox AA-RS5CS - Manual
Audiovox AA-RS5CS – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 5 – WIRING CONNECTIONS: 12 Pin Input / Output Harness
- Page 6 – Brake Switch Positive Shutdown Detail; IT IS PRESENTLY CONNECTED TO IN THE VEHICLE.; Switch
- Page 7 – General Motors VATS By-Pass Diagram
- Page 8 – DARK GREEN Wire: Tach Sensor Input; Tachometer Input Wiring Detail
- Page 9 – Wire Positive Switched Door Lock/Unlock Wiring Detail
- Page 10 – To program these selectable features:
- Page 11 – TESTING YOUR INSTALLATION:
- Page 13 – KEY IN SENSOR CIRCUITS:
- Page 14 – METHOD 1; METHOD 2
- Page 15 – COMPLETING THE INSTALLATION:
- Page 16 – WIRING DIAGRAM
Kit Contents
AA-RS5 Control Module
(2) - 2 Button High Frequency Transmitters
(1) - 3 Channel Code Learning Receiver
(1) - Multi Pin Input/Output Harness
(1) - Six Pin Power Harness
(1) - Two Pin I/O Harness Factory Alarm By-Pass & Diesel Wait To Start Input
(1) - 2 Pin Door Lock Harness
(2) - 30 Amp In-line Fuse Holders With Fuses
(1) - Control Switch
(1) - Programming Switch
(1) - Ring Terminal
(4) - 1/2" Long Screws
(1) - Pin Switch
(1) - Remote Start Warning Label
(1) - Literature Package
Model AA-RS5CS
Installation Manual
3 Channel Remote Start / Keyless Entry System
Installation Instructions
This Unit Is Intended For Installation In Vehicles With
12 Volt Negative Ground Electrical Systems,
Gasoline or Diesel With True Tach Reference
And Automatic Transmissions Only.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
WIRING CONNECTIONS: 12 Pin Input / Output Harness Black Wire: Chassis Ground SourceConnect the Black wire to a known vehicle ground source or to a solid clean metal part of the chassis. Be certain toremove any paint or grease and secure this wire with a self tapping screw and ring terminal. BLACK w/...
the Brown w/ Black trace wire to the output of the brake light switch. If the brake light switch in the vehicle switches ground,do not use the Brown w/ Black wire; see Grey w/ Black tracer wire. Brake Switch Positive Shutdown Detail YELLOW w/ BLACK Tracer Wire: + 12 Volt Alarm By - Pass OutputNOTE: ...
LIGHT BLUE Wire: Ignition 3 / Shock Disable OutputThis wire provides a 300mA ground output that becomes active 3 seconds before the Remote Start Unit initializes, andremains grounded while running plus an additional 4 seconds after the Remote Start Unit turns off. In all of theapplications described...
