Audiovox AA-RS20CS - Manual
Audiovox AA-RS20CS – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION OF THE MAJOR COMPONENTS:
- Page 5 – YELLOW START WIRE DETAIL
- Page 8 – General Motors VATS By-Pass Diagram; key's value from the resistor pack supplied.
- Page 12 – Channel 2 Relay Wiring Detail; requirement is more than 300 mA.
- Page 13 – Wire Ground Switched Door Lock/Unlock Wiring Detail
- Page 14 – Wire Positive Switched Door Lock/Unlock Wiring Detail; between steps, or the programming mode will be terminated.
- Page 16 – REMOTE START SELECTABLE FEATURES; RF Programmable Features:; verifying you are in the feature program mode.
- Page 18 – the ignition switch off. DO NOT attempt to remove the key.
- Page 20 – METHOD 1
- Page 21 – METHOD 2
- Page 23 – WIRING DIAGRAM; CONTROL MODULE
This Unit is Intended for Installation in Vehicles with
12 Volt Negative Ground Electrical Systems,
Gasoline Engines, and Automatic Transmissions Only.
Kit Contents:
AA-RS20CS Control Module
(2) - Three Button Anti Code Grabbing Transmitters
4 Channel Code Learning Receiver
On Board Extended Range Antenna
Six Tone Multi Tone Siren
(1) - Multi Pin Input/Output Harness
(1) - Six Pin Power Harness
(1) - Four Pin Auxiliary Output Harness
(1) - Two Pin LED Indicator
(1) - Two Pin Valet / Programming Switch
(1) - Two Pin Control Switch
(1) - Four Pin Shock Sensor Harness
(1) - Two Pin Door Lock Harness
(1) - Dual Stage Shock Sensor
(1) - Starter Inhibit Relay and Socket
(2) - 30 Amp In-line Fuse Holders With Fuses
(1) - Pin Switch Hardware Bag
(2) - Under Hood Caution Labels
(1) - Installation Manual
(1) - Operator's Manual
(1) - Limited Warranty
(2) - Window Decals
Model AA-RS20CS
Installation Manual
4 Channel Remote Car Starter
With Full Feature Alarm System
Installation Instructions
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
The AA-RS20CS Remote Start/Alarm System is designed to be used with Automatic Transmission Ve-hicles Only! The unit provides no output for glow plug pre-heat and may not be desirable for dieselvehicles. If the diesel engine has a instant fire, (no glow plug pre-heat system), a tach signal input, and...
YELLOW START WIRE DETAIL 5 GREEN Wire: Ignition 2 OutputConnect this wire to the ignition 2 wire from the ignition switch. This wire will show + 12 volts when theignition key is turned to the "ON" or "RUN" position and is some cases the "START" or CRANK" position.This wir...
General Motors VATS By-Pass Diagram 8 Start unit is activated, the relay contacts will open, preventing the shock sensor's operation until theRemote Start unit shuts off. B. Ignition 3 Output: Some newer vehicles use a third ignition wire which is required to start and keep the vehicle's enginerunni...
