ATD fpm-12 - Manual
ATD fpm-12 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – California Prop 65 WARNING:; Wash hands after handling.; General Safety Warnings:; for future reference.
- Page 4 – PUMP CONSTITUENTS; ELECTRICAL INSTALLATION - DC MOTORS
- Page 5 – ASSEMBLY & INSTALLATION
- Page 6 – PRIMING; minutes continuously in 1 hour; PUMP OPERATION; MAINTENANCE
- Page 9 – PUMP SPECIFICATION
- Page 10 – TROUBLESHOOTING
1
INSTRUCTION MANUAL
S1590, Rev B
ATD-50012
Electric Fuel Pump
(FPM-12)
Congratulations on purchase of this World Class Electric Fuel Pump!
This is an Electric Fuel Pump. Pump uses 2 Sintered Powder
Metal gears for suction & is designed for use with Gasoline,
Diesel, E15 Fuel, Kerosene, Bio Diesel (B20) etc. In ideal
laboratory conditions, pump dispenses up to 15 GPM (57 LPM)
at the pump outlet. The actual discharge varies depending on
fuel being used, temperature, Hose Length, power supply etc.
ATD-50012 is a 12V DC Pump
Rating is marked on the pump motor.
Pump uses an Explosion Proof motor & the motor is UL ,
cUL, ATEX & IECEx listed.
Inside of
Pump
LISTED MOTOR
Elbow
Nozzle
Holder
Pad Lock
Lever
Motor
Fuel
Control
Nozzle
Switch
ON
OFF
Swivel
Nut
Pump
Outlet
Hose
12’ x 3/4” I.D.
Suction Tube
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
California Prop 65 WARNING: Batteries contain lead and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. Wash hands after handling. General Safety Warnings: WARNING: The instructions and warnings contained in this manual should be read and u...
4 ELECTRICAL DIAGRAM FOR DC MOTOR 5 PUMP CONSTITUENTS 1. Pump & Motor Assembly 2. Nozzle Holder 3. Elbow 4. Suction Tube (2 parts) 5. Bung Nut 6. Hose Assembly (12’ Long x ¾” ID Anti Static Hose) 7. Fuel Control Nozzle 8. Power Cord complete with Fuse & Clamps 9. PTFE Tape 5 4 7 3 8 9 6 ELEC...
5 4. Take the Bung Nut & fasten it onto the 2” opening on the Drum/ Tank. Bung Nut has a large 2” thread & a small 1-1/2” thread. 2” thread goes into the drum/ tank, whereas the 1-1/2” thread is for connecting bung to the pump 5. In case the Bung Nut does not fit onto your drum/ tank, use a ...
