ATD ATD3698 - Manual
ATD ATD3698 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Sensor with Filter; Product Specifications
- Page 3 – Polarity Mark; Operating Instructions
- Page 4 – Low Battery Indicator; Maintenance; Adjusting Sensitivity Levels; Remove the plastic seal cap on top of the Leak Test Vial
RETURN FOR REPAIR POLICY
Every effort has been made to provide reliable, superior quality
products. However, in the event your instrument requires repair,
forward unit to Service Center freight prepaid to the address below
with return address, phone number and/or email address.
SERVICE CENTER
2651 W 81st Street
Hialeah, FL 33016
WARRANTY POLICY
The ATD3698 Refrigerant Gas Leak Detector is warranted to be
free of defects in materials and workmanship for a period of two
years from the date of purchase including an industry first two year
warranty on the sensor. This warranty applies to all repairable
instruments that have not been tampered with or damaged through
improper use including unauthorized opening of the unit. Please
ship warranty units that require repair freight prepaid to Service
Center along with proof of purchase, return address, phone number
and/or email address.
Model ATD3698
Refrigerant Gas Leak Detector
User Manual
Detects all CFC, HFC, HCFC
Refrigerants including blends
J2791
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
INTRODUCTION The ATD3698 features a long life heated sensor technology that is designed to detect the more current and difficult HFC refrigerants such as R-134a in addition to all HCFC (R22) and CFC (R12) refrigerants including SNAP approved hydrocarbon blends. The ATD3698 does not require rechargea...
Maintenance Polarity Mark Filter Keyway alignment Pull straight out (do not twist) to remove sensor Unscrew tip to replace filter Push straight on (do not twist) to install sensor Batteries: Install Batteries : Remove screw located at rear end of unit and pull down hinged battery door to open as sho...
Low Battery Indicator Replace the 4 AA Alkaline batteries when the red LED on the control panel is lit. Follow battery installation instructions under Maintenance section. Adjusting Sensitivity Levels The Leak Detector will default to the NORM sensitivity level automatically once the unit comes out ...
