ATD 10515 - Manual - manualsarea.com

Page 2 - Table of contents; left

E G A P N O I T C E S I. Technical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 II. General safety rules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 III. Specific safety rules ...

Page 3 - TO AVOID MISTAKES THAT COULD CAUSE SERIOUS INJURY, DO NOT; SAVE THESE SAFETY INSTRUCTIONS; II. General safety rules

Safety is a combination of common sense, staying alert, and knowing how your cut-off sawworks. 1. READ and become familiar with this entire instruction manual. Learn the tool’s applications, limitations, and possible hazards. 2. AVOID DANGEROUS CONDITIONS. DO NOT use power tools in wet or damp areas...

Page 4 - PLEASE OBSERVE ALLSAFETY

SAVE THESE SAFETY INSTRUCTIONS II. General safety rules ... continued 4 17. CHECK FOR DAMAGED PARTS. Check moving parts for alignment, jamming, breakage, improper mounting, or any other conditions that may affect the tool's operation. Any partthat is damaged should be properly repaired or replaced b...

Page 5 - III. Specific safety rules for the cut-off saw

1. If you are not thoroughly familiar with the operation of a cut-off saw, obtain advice from a supervisor, instructor, or other qualified person. 2. ALWAYS WEAR SAFETY GOGGLES. Wear hearing protection during periods of extended operation. 3. REPLACE CRACKED METAL CUTTING DISC IMMEDIATELY. Handle di...

Page 6 - IV. Electrical information; GROUNDING INSTRUCTIONS; THIS CUT-OFF SAW IS FOR INDOOR USE ONLY. DO NOT EXPOSE TO

SAVE THESE SAFETY INSTRUCTIONS IV. Electrical information GROUNDING INSTRUCTIONS IN THE EVENT OF A MALFUNCTION OR BREAKDOWN, grounding provides the path ofleast resistance for electric current to reduce the risk of electric shock. This tool is equippedwith an electric cord that has an equipment grou...

Page 7 - GUIDELINES FOR USING EXTENSION CORDS; THIS CUT-OFF SAW MUST BE GROUNDED WHILE IN USE TO PROTECT

GUIDELINES FOR USING EXTENSION CORDS Make sure your extension cord is in good condition. When using an extension cord, be sureto use one heavy enough to carry the current your product will draw. An undersized cord willcause a drop in line voltage resulting in loss of power and overheating. The table...

Page 9 - VI. Assembly and adjustments

VI. Assembly and adjustments Unpacking (Fig. 1) 1. Remove the cut-off saw (1) from the carton by lifting it by the carrying handle. 2. Place the cut-off saw on a secure surface and examine it carefully. Ensure that youhave: • 14" cut-off saw assembly (1) • Vise clamp handle (2) • Threaded bolt a...

Page 11 - Installation and removal of metal cutting disc

VII. Operation ... continued Installation and removal of metal cutting disc (Fig. 8 and 9) 1. Unplug the cut-off saw.2. Push the arbor lock lever (1) towards the metal cutting disc (2) and slowly turn the disc (eitherdirection) until the disc locks. (Fig. 8) 3. Push back the lower blade guard (3) an...

Page 14 - IX. Replacement parts; ALL ELECTRICAL OR MECHANICAL REPAIRS SHOULD BE ATTEMPTED

IX. Replacement parts WARNING: ALL ELECTRICAL OR MECHANICAL REPAIRS SHOULD BE ATTEMPTED ONLY BY A QUALIFIED SERVICE TECHNICIAN. USE ONLY IDENTICAL REPLACEMENT PARTS. ANY OTHER PARTS MAY CREATE A HAZARD. 14

ATD 10515 - Manual

Table of Contents:

Summary

Other ATD Models