ATD ATD-8696 - Manual
ATD ATD-8696 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Disassembly; until the first bearing is removed.; Assembly; Clean all dirt and oil from the yoke area.; Ball Joint Removal and Installation; joints without the need to remove the control arm from the vehicle.; Removal
- Page 3 – until the ball joint is removed.; Installation
- Page 4 – De scription; Receiving Tubes
ATD-8696
4 IN 1 BALL JOINT SERVICE TOOL SET
WARNING: TO HELP PREVENT PERSONAL INJURY
Always wear ANSI approved goggles when using this product. Normal use of this
product is likely to expose the user to dust and/or microscopic particles containing
chemicals known to the State of California to cause cancer, birth defects or other
reproductive harm. Always wear appropriates safety equipment and clothing when
using this product.
Study, understand, and follow all instructions provided with this product.
Before repairing vehicle, block the wheels to prevent the vehicle from moving.
Check the final alignment of the C-frame press and all tooling with components
before exerting pressure to remove or replace a ball joint.
OPERATING INSTRUCTIONS
Brake Anchor Pin Removal and Installation
1. Remove all lock ring retainers from the brake anchor pins.
2. Position the C-frame press over the brake spider as shown in Figure 1.
3. Tighten the forcing screw until the anchor pin is removed.
"U"Joint Assembly And Disassembly
The basic C-frame press is used to service the "U" joints on most cars and light
trucks.
The "U" joints can be serviced either on or off the vehicle.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Disassembly 1. Remove any external and/or internal lock rings. 2. Position the C-frame press around the drive shaft yoke, and tighten the forcing screw until the first bearing is removed. 3. Reposition the C-frame and remove the second bearing. Assembly 1. Clean all dirt and oil from the yoke area. ...
refer to Figure 3. 2. Tighten the forcing screw until the receiving tube contacts the control arm. Check the alignment of all tooling and components, and continue tightening the forcing screw until the ball joint is removed. Installation 1. Clean the control arm and coat the I.D. with a suitable lub...
Ite m# Orde ring Part# De scription 1 PRT8696-1 SCREW 2 PRT8696-2 BLOW MOLDED CASE 3 PRT8696-3 INSTALL ADAPTER 4 PRT8696-4 INSTALL CUP ADAPTER 5 PRT8696-5 RECEIVING CUP 6 PRT8696-6 1-3/4" x 2" RING 7 PRT8696-7 2-3/4" X 2-1/2" RING 8 PRT8696-8 2-1/4" X 3" RING 9 PRT8696-9 C-FR...
