ATD ATD-8402 - Manual
ATD ATD-8402 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – ASSEMBLY; USE PTFE tape for all threaded air connections; connections are tight and properly seated.
- Page 3 – only fill the tank 3/4 full and reload as needed to finish the work.
- Page 5 – disconnect the air compressor power.
- Page 6 – TROUBLE SHOOTING; PROBLEM REMEDY
- Page 7 – Ceramic
ATD-8402
90LB PRESSURE BLASTER
INSTRUCTION MANUAL
SAVE THESE INSTRUCTIONS
SAFETY INSTRUCTIONS FOR SANDBLASTER
1. Before opening the tank release the air pressure on the sand tank. To do this, turn off
the air supply valve(#14) to release pressure in the line. Be sure that the tank pressure
gauge (#05) reads zero then open the tank.
2. Maintain correct air pressure. Pressure should not exceed 125PSI. If it does, the safety
valve (#06) is supposed to release the excess pressure. If it doesn’t release excess
pressure, stop all work immediately and use the air compressor to reduce the excess
pressure.
Do not
investigate the sandblaster’s pressure problem until the pressure
gauge (#05) reads zero.
3. When using pneumatic equipment, basic safety precautions should always be followed
to reduce the risk of personal injury and hazards due to over pressurization.
4. Do not operate the unit when tired or under the influence of alcohol or drugs.
5. When servicing only use parts and accessories intended for use with this unit.
6. Do not allow sand blaster to be pressurized while unattended or not in use.
WARNING
: The warnings and cautions discussed in this instruction manual cannot cover
all possible conditions and situations that may occur. It must be understood by the operator
that common sense and caution are factors that cannot be built into this product but must
be supplied by the operator.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
ASSEMBLY USE PTFE tape for all threaded air connections 1. Assemble the intake manifold (#08). Attach the pressure gauge (#05) to the top of the intake manifold (#08), and turn the gauge so that it can be seen across the top of the tank. Next, attach the sand meter valve (#18) to the bottom of the m...
ABRASIVE SELECTION The kind of sand you choose will greatly influence the amount of time needed to clean a given surface area. Sandblasting materials include silicon carbide, alumina, silica sand, bank sand and beach sand. However, bank sand and beach sand even if washed, will still contain shell, c...
IMPORTANT SAFETY INSTRUCTIONS WARNING: When using tools such as your air compressor, whether powered by electric motor or gasoline engine, basic safety precautions should always be followed to reduce the risk of fire, electric shock and personal injury. READ ALL INSTRUCTIONS BEFORE USING 1. Keep the...
