Apple Processor Cage Fans - Manual
Apple Processor Cage Fans – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Hard Drive
- Page 3 – Graphics Card; Remove bracket from
- Page 5 – Remove card from; Checklist for handling card:; connectors are barely visible, card is connected.
- Page 6 – Processor Tray; Locate processor tray.
- Page 7 – Place tray DIMM side; PCIe Fan
- Page 8 – Processor Cage
- Page 10 – Processor Cage Fans
- Page 12 – Position front fan in
- Page 15 – Closing the; Replace access panel.
073-1254 Rev. A
1
© 2009 Apple Inc. All rights reserved.
Mac Pro
First Steps
Shut down computer.
1
2
Wait 10 minutes.
W
arning:
Parts inside
computer can be very
hot. Allow computer
to cool down before
continuing.
Unplug all external
3
cables except power
cord.
Touch metal PCI cover
4
on back of computer.
Unplug power cord.
5
Opening the
Computer
Hold side access
1
panel and lift latch on
back of computer.
Warning:
Edges of
access panel and
enclosure can be
sharp. Be careful
when handling.
Remove access panel
2
and place it on flat
surface covered by
soft, clean cloth.
Processor Cage Fans, Front and Rear
Replacement Instructions
Note:
Follow these instructions carefully. Failure to do so could damage your equipment and
void its warranty.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
073-1254 Rev. A 2 © 2009 Apple Inc. All rights reserved. Required Tools Phillips #2 screwdriver • RIght-angle, 2.5 mm • hex driverFlatblade screwdriver • Long-handled Phillips • #1 screwdriver Removing the Installed Fans Fans are installed in processor cage. To access fans, you must first remove: Ha...
073-1254 Rev. A 3 © 2009 Apple Inc. All rights reserved. Graphics Card 3 Locate graphics card in slot 1. 4 Using Phillips #1 screwdriver, loosen 2 captive screws securing card’s bracket to enclosure. Remove bracket from 5 enclosure.
073-1254 Rev. A 5 © 2009 Apple Inc. All rights reserved. 8 Holding card by top corners, pull it up out of slot. Remove card from 9 computer. Checklist for handling card: When removing or installing card, handle it only by the edges. Do not touch its connectors • or any components. Don’t rock card fr...
