Apple 073-0560 - Manual
Apple 073-0560 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Figure 1; has not been shut down. Close the side access panel and shut down the
- Page 3 – Removing the Installed Card; Figure 2; Installing the Replacement Card
- Page 4 – Closing the Computer; missing parts can damage your computer or cause injury.
073-0560 Rev. C
Power Mac G4 / Macintosh Server G4
SCSI Card
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Note:
Written and video instructions covering customer-installable parts are available at
http://www.info.apple.com/installparts/.
Warning: During this procedure, keep small parts away from children.
Tools Required
The only tool required for this procedure is a Phillips screwdriver.
Opening the Computer
Warning: Always turn off your computer before opening it to avoid damaging its
internal components.
1.
Place your computer on a clean, flat surface.
2.
If you think your computer is in sleep, press the power button on the front of the
computer to wake it.
3.
Shut down your computer by opening the Special menu and choosing Shut Down.
Then wait five minutes for the computer’s internal components to cool down.
4.
If you attached a security cable through the computer’s lockable cover latch, remove
the cable.
5.
Unplug all other cables from the computer except the power cord.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Power Mac G4 SCSI Card - 2 6. Touch the metal PCI access covers on the back of the computer. (Figure 1) Important: To avoid electrostatic discharge, always ground yourself by touching the port access covers before you touch any parts or install any components inside the computer. To avoid static ele...
Power Mac G4 SCSI Card - 3 Removing the Installed Card 1. Disconnect the SCSI ribbon cable from the SCSI card. (Figure 2A) 2 Using a Phillips screwdriver, remove the card’s mounting screw. (Figure 2B) 3. Gently pull up the card and remove it from the PCI slot. Figure 2 Power Mac G4 Power Mac G4 (Mir...
Power Mac G4 SCSI Card - 4 Closing the Computer 1. Raise the side access panel, lift the latch, and press the panel against the case until it snaps securely into place. 2. Reconnect all cables and restart your computer. Warning: Never turn on your computer unless all of its internal and external par...
