APC BR1500MS2 - User Manual
APC BR1500MS2 Surge Protector – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – The UPS is shipped with the battery disconnected.
- Page 3 – PowerChute is only compatible with a Windows operating system. If; Installation; Click the download link and select Software product. Select the; Connect the Equipment; Battery Backup and Surge Protected outlets
- Page 5 – Operation; Power Saving Display; Generator Sensitivity
- Page 6 – Front Panel Buttons and Display Interface; Front panel; button; button
- Page 7 – Detected Alarms and System Errors; Audible Indicators
- Page 9 – Function Button Quick Reference
- Page 10 – Troubleshooting; Problem
- Page 11 – is; Warranty
- Page 12 – Select models are ENERGY STAR; EMC Compliance; which the receiver is connected.
Important Safety Instructions
Inspect the package contents upon receipt. Notify the carrier and
dealer if there is any damage.
SAVE THESE INSTRUCTIONS - This section contains important
instructions that should be followed during installation and maintenance of
the UPS and batteries.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• This UPS is intended for indoor use only.
• Do not operate this UPS in direct sunlight, in contact with fluids, or
where there is excessive dust or humidity.
• Be sure the air vents on the UPS are not blocked. Allow adequate
space for proper ventilation.
• Connect the UPS power cable directly to a wall outlet.
Failure to follow these instructions will result in death or serious
injury.
CAUTION
RISK OF HYDROGEN SULPHIDE GAS AND EXCESSIVE SMOKE
• Replace the battery at least every 5 years or at the end of its service
life, whichever is earlier.
• Replace the battery immediately when the UPS indicates battery
replacement is necessary.
• Replace batteries with the same number and type of batteries as
originally installed in the equipment.
• Replace the battery immediately when the UPS indicates a battery
over-temperature condition, or when there is evidence of electrolyte
leakage. Power off the UPS, unplug it from the AC input, and
disconnect the batteries. Do not operate the UPS until the batteries
have been replaced.
Failure to follow these instructions could result in minor or
moderate injury and equipment damage.
User Manual Back-UPS
™
Pro
BR1500MS2
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Back-UPS Pro BR1500MS2 2 Inventory Connect the Battery The UPS is shipped with the battery disconnected. Coaxial Cable USB communication cable Lay the UPS with the battery door facing up. The arrows point to the locking tabs of the battery compartment. Press the tabs downwards and pull the batte...
Back-UPS Pro BR1500MS2 3 Install PowerChute ™ Personal Edition Software Use PowerChute Personal Edition software to configure the UPS settings. During a power outage, PowerChute will save any open files on your computer and shut it down. When power is restored, it will restart the computer. Note: Po...
Back-UPS Pro BR1500MS2 5 Operation Power Saving Display The display interface can be configured to be continuously illuminated, or to save energy, it can be configured to darken after a period of inactivity. 1. Full Time Mode: Press and hold DISPLAY for two seconds. The display will illuminate and t...
