Amtrol DC2 - Manual
Amtrol DC2 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – ELECTRICAL CONNECTION; ELECTROCUTION HAZARD. FIRST DISCONNECT ALL; INSTALLATION INSTRUCTIONS; Unit Must be Installed by a Qualified Professional; pump, depending upon the installation
- Page 3 – NOTE: Steps 5 and 6 are required for outdoor installations only.; LINE; Guardian CPTM; BASIC WIRING
- Page 4 – START UP; “88” will appear, then code; DEVICE ADJUSTMENT (Entering Programming Mode); “LO” appears, release. This will determine the pressure at; OPERATION
- Page 5 – TROUBLESHOOTING
- Page 6 – GENERAL SAFETY INFORMATION; READ CAREFULLY THE PRODUCT INSTALLATION, OPERATING
- Page 8 – AMTROL INC. 2-YEAR LIMITED PRODUCT WARRANTY
1
West Warwick, Rhode Island 02893
INSTALLATION, OPERATION
& MAINTENANCE
INSTRUCTIONS
Your DC2 DIGITAL CONTROL has been carefully assembled and factory tested. To enjoy
the full service this unit can provide, you should read and follow all of the instructions in this
manual. When all installation steps have been completed, make sure you also follow the
enclosed post-installation and startup checklists before using your AMTROL
®
product. You
should also read carefully the sections describing proper product maintenance and follow
the required procedures as you use your DC2 DIGITAL CONTROL. Keep this manual with the
product. This manual may become out-of-date by later amendments. Check our web site,
www.amtrol.com or ask your AMTROL
®
supplier for any updates relating to your product.
THIS IS THE SAFETY ALERT SYMBOL. IT IS USED TO ALERT YOU TO
POTENTIAL PERSONAL INJURY AND OTHER HAZARDS. OBEY ALL
SAFETY MESSAGES THAT FOLLOW THIS SYMBOL TO REDUCE THE
RISK OF POSSIBLE INJURY AS WELL AS PROPERTY DAMAGE.
INSTALLER: LEAVE THIS MANUAL WITH THE OWNER
Part # 9046-0001 (09/10)
Guardian CP
™
Digital Pump Control
Model DC2
Patent Pending
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 ELECTRICAL CONNECTION ELECTROCUTION HAZARD. FIRST DISCONNECT ALL ELECTRICAL POWER BEFORE SERVICING. ELECTROCUTION HAZARD. THE DC2 MUST BE ELECTRICALLY GROUNDED. NOTE: The DC2 will operate on 115 VAC & 230 VAC systems. Its ambient air temperature rating is 122°F / 50°C. 1. Disconnect power and ...
3 4. Loosen the screw on the cover of the controller and remove the plastic cover, exposing the wiring pigtails. (When reassembling cover, do not over-tighten screw.) 5. The wire conduit hub is to be connected to the conduit before the hub is connected to the enclosure. The maximum hub diameter cann...
4 START UP BEFORE CONTINUING, CHECK FOR OPEN DRAIN VALVES OR OTHER SOURCES OF FLOODING BEFORE STARTING UNIT. 1. Prime pump if necessary and adjust tank precharge to manufacturer’s recommendation for intended pressure range. The factory DC2 setting is 40 psi cut-in and 60 psi cut-out. 2. Turn on powe...
