Page 2 - Visit our website for:; Register your product for better service:; CUSTOMER CARE AND SERVICE; General information and tips
CONTENTS 1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2. SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 3. TECHNICAL INFORMATION ....
Page 4 - SAFETY INSTRUCTIONS; Installation
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly quali-fied persons in order to avoid a hazard. • The operating water pressure (minimum and maxi- mum) must be between 0,5 bar (0,05 MPa) and 8 bar(0,8 MPa) • The ventilation openings in the base ...
Page 6 - TECHNICAL INFORMATION
• Disconnect the appliance from the mains supply. • Cut off the mains cable and discard it. • Remove the door catch to prevent children and pets to get closed in theappliance. 3. TECHNICAL INFORMATION Dimensions Width / Height / Depth 600 / 820 / 630 mm Total depth 640 mm Electrical connection: Volt...
Page 7 - PRODUCT DESCRIPTION; Child safety device; Spanner
4. PRODUCT DESCRIPTION 7 8 9 10 1 2 3 4 5 6 1 Detergent dispenser 2 Control panel 3 Door handle 4 Rating plate 5 Drain pump 6 Feet for the appliance level 7 Water drain hose 8 Mains cable 9 Water inlet hose 10 Feet for the appliance level 4.1 Child safety device • When you activate this device, you ...
Page 8 - CONTROL PANEL; Display; Duration of the set programme
5. CONTROL PANEL 1 2 3 4 5 6 7 9 8 10 A BC 1 Programme selector dial 2 SPIN button• Rinse hold position 3 STAIN button 4 TIME SAVE button 5 EXTRA RINSE button 6 DRYING TIME button 7 Display 8 START/PAUSE button 9 DELAY START button 10 Indicator pilot lights:• A – Washing phase• B – Drying phase• C –...
Page 10 - WASHING PROGRAMMES
• after pressing button 8 : it will be im- possible to change any other pro-gramme or option. To enable or disable this option press si-multaneously for about 6 seconds but- tons 4 and 5 until the symbol comes on or disappears from the display. 6. WASHING PROGRAMMES ProgrammeMaximum and Minimum Temp...
Page 12 - For cancelling the running programme or to switch the machine off .
ProgrammeMaximum and Minimum TemperatureType of LaundryMaximum Load Cycle De-scription Options Cotton Economy 60°Max. load 7 kg White and fast coloured cotton . Slightly or normally soiled cotton items.The appliance decreases the temperatureand extends the washing time to obtain agood washing effici...
Page 13 - Drying programmes; Suitable for ironing
6.1 Drying programmes Timed programmes Degree of Drying Type of Fabric Drying Load Spin Speed Sugges- ted drying time Minutes EXTRA DRY Ideal for towelling mate-rials Cotton and linen (bathrobes, bathtowels, etc) 4 kg 1200 180 -200 3 kg 1200 120 -130 1.5 kg 1200 85 - 95 CUPBOARD DRY 1) Suitable for ...
Page 14 - CONSUMPTION VALUES; Programme; White Cottons 95°; ration of the; Synthetics 40°; FIRST USE; Loading the laundry; Open the appliance door.
7. CONSUMPTION VALUES Programme Energy con-sumption(KWh) Water con-sumption(litres) Programmeduration(minutes) White Cottons 95° 2.2 72 For the du- ration of the pro- grammes, please refer to the dis- play on the control pan- el. Cottons 60° 1.35 67 Cotton Energy Saving Pro-gramme 60° 1) 1.05 49 Cot...
Page 15 - Filling the detergent and additives; This is the maximum level for the quantity of liquid additives.; Setting the programme; OFF of the machine
Make sure that no laundry stays betweenthe seal and the door. There is a risk ofwater leakage or damage to the laundry. 9.2 Filling the detergent and additives MAX The detergent compartment for the prewash phase, the soakprogramme and for the stain function.Add the detergent for prewash, soak and st...
Page 16 - DAILY; Setting the EXTRA RINSE
If you turn the programme dial toanother programme when theappliance is working, the yellowpilot light of button 8 blinks 3 times. The display shows themessage Err to indicate a wrong selection. The machine will notperform the new set programme. 9.4 Setting the SPIN speed (button 2) When you set the...
Page 18 - Stand by; Drying only
The water must be emptied out beforeopening the door. During this time thedrum continues to turn at regular inter-vals until water drain.Follow the below instructions to emptyout the water:• Turn the programme selector dial to • Set the DRAIN or SPIN programme• Reduce the spin speed, if needed• Pres...
Page 19 - HELPFUL HINTS AND TIPS; The laundry load
the drum and select an additional dryingcycle of 20-30 minutes. 9.16 NON-STOP programme: Washing and Timed drying The recommended load size is 3 kg forcotton and 2 kg for synthetic. It is also possible to dry up to 4kg of cotton items (see the «Dry-ing Programme » table). CAUTION!Do not use a dosing...
Page 20 - soft; Drying hints
• Button up pillowcases, close zippers, hooks and poppers. Tie up belts. • Empty the pockets and unfold the items. • Turn inside out multilayered fabrics, wool and items with painted illustra-tions. • Remove hard stains.• Wash with a special detergent heavy soil stains. • Be careful with the curtain...
Page 21 - average; Additional drying; CARE AND CLEANING; Descaling
• For the maximum laundry load of the drying programmes, refer to the dry-ing programmes table. Do no not set a drying programme forthis laundry: – Very delicate items.– Synthetic curtains.– Woollen and silk items.– Pieces of clothing with metal inserts.– Nylon stockings.– Quilts.– Bed covers.– Duve...
Page 22 - • Clean the drum with special product; Detergent dispenser; To clean the dispenser:; Pull the dispenser out.; Clean all the parts with water.
11.3 Door seal Regularly examine the seal and removeall objects from the inner part. 11.4 Drum Regularly examine the drum to preventlimescale and rust particles.Only use special products to remove rustparticles from the drum.To do this: • Clean the drum with special product for stainless steel. • St...
Page 23 - Drain pump; • the appliance makes an unusual noise
11.6 Drain pump The pump should be inspected regularlyand particularly if:• the appliance does not empty and/or spin; • the appliance makes an unusual noise during draining due to objects such assafety pins, coins etc. blocking thepump; • a problem with water draining is de- tected (see chapter “Tro...
Page 24 - • The indicator of button; To clean the water inlet filters:
7. Check carefully whether the pumpimpeller rotates (it rotates jerkily). Ifit doesn’t rotate, please contactyour Service Centre. 8. Put the cap back on the emergencyemptying hose and place the latterback in its seat. 9. Replace the filter into the pump byinserting it correctly into the specialguide...
Page 25 - Emergency emptying out; place a bowl on the floor; Frost precautions; screw the water inlet hose back on; TROUBLESHOOTING
4. Remove the inlet hose behind theappliance. 5. Clean the filter in the valve with astiff brush or a towel. 45° 20° 6. Install again the inlet hose. Makesure that the couplings are tight toprevent leakages. 7. Open the water tap. 11.8 Emergency emptying out If the water is not discharged, proceedas...
Page 26 - yellow; pilot light of button; Problem; has not been pressed.
During machine operation it is possiblethat the yellow pilot light of button 8 blinks, one of the following alarm codesappears on the display and at the sametime some acoustic signals sound every20 seconds to indicate that the machineis not working:• : problem with the water supply • : problem with ...
Page 27 - screw the filter fully in.
Problem Possible cause/Solution The machine does notempty and/or does notspin: The drain hose is squashed or kinked. • Check the drain hose connection.The drain filter is clogged. • Clean the drain filter.You have set an option or a programme that endswith the water still in the tub or a that elimin...
Page 28 - gree for the laundry.
Problem Possible cause/Solution The machine vibratesor is noisy: The transit bolts and packing have not been re-moved.• Check the correct installation of the appliance.The support feet have not been adjusted• Check the correct levelling of the appliance.The laundry is not evenly distributed in the d...
Page 29 - • Thoroughly clean the empty drum, the gasket and; INSTALLATION; Unpacking; Remove the cardboard top.
Problem Possible cause/Solution The laundry is full ofdifferent colored fluff: The fabrics washed in the previous cycle releasedfluff of a different colour.• The drying phase helps to eliminate some fluff.• Clean the clothes with a fluff remover. In case of an excessive amount of fluff in thedrum re...
Page 30 - Remove the internal film.
4. Remove the internal film. 5. Open the door. Remove the poly-styrene piece from the door sealand all the items from the drum. 6. Put one of the polystyrene packag-ing elements on the floor behindthe appliance. Carefully put downthe appliance with the rear side onit. Make sure not to damage the ho-...
Page 31 - Pull out the plastic spacers.
9. Remove the power supply cable andthe drain hose from the hose hold-ers. 10. Remove the three bolts. Use the keysupplied with the appliance. 11. Pull out the plastic spacers. 12. Put the plastic caps in the holes.You can find these caps in the usermanual bag. WARNING! Remove all the packaging andt...
Page 32 - Positioning and levelling; • Carefully level by screwing the adjust-; The inlet hose; • Connect the hose to the appliance.
13.2 Positioning and levelling • Install the machine on a flat hard floor.• Make sure that air circulation around the machine is not impeded by car-pets, rugs etc. • Carefully level by screwing the adjust- able feet in or out. • After having levelled the appliance, tighten the lock nuts. • The appli...
Page 33 - • Connect the water inlet hose to the; Water drainage; With the plastic hose guide.
• Connect the water inlet hose to the cold water tap with 3/4 thread. CAUTION! Make sure that there are no leaksfrom the couplings. Do not use an extension hose ifthe inlet hose is too short. Con-tact the service centre for the re-placement of the inlet hose. Water-stop device A The inlet hose has a...
Page 34 - • If the end of the drain hose is this (see; Without the plastic hose guide.
• On the edge of a sink.• Make sure that the plastic guide can- not move when the appliance drains.Attach the guide to the water tap orthe wall. • To a stand pipe with vent-hole. Refer to the illustration. Directly into adrain pipe at a height of not less than60 cm (23.6”) and not more than 100cm (3...
Page 35 - In the interest of the environment; • Connect the appliance to the FOUL; Building in; • This appliance has been designed to
• Directly to a built-in drain pipe in the room wall and tighten it with a clip. You can extend the drain hose tomaximum 400 cm. Contact theservice centre for the other drainhose and the extension. 13.5 In the interest of the environment • Connect the appliance to the FOUL system for the drain water...
Page 36 - Preparation and assembly of the door; • The machine is originally pre-arranged; Door; depends on the height; Hinges; and
Preparation and assembly of the door • The machine is originally pre-arranged for the assembly of a door openingfrom right to left (Fig. 2 ). Fig. 2 Ø 35 mm 14 mm 16-22 mm 22±1,5 mm 416 mm X 595-598 mm • Door The dimensions of the door should be:– width 595-598 mm– thickness 16-22 mm– the height X d...
Page 37 - Mounting the door; ENVIRONMENT CONCERNS
B A • Mounting the door Fix the hinges to the appliance bymeans of the M5x15 screws . The hing-es can be adjusted to compensate forpossible uneven thickness of the door.To align the door perfectly it is neces-sary to loosen the screw , adjust thedoor and tighten the screw A again (Fig. 5 ). Do not r...
