Adam Equipment MDW-250 L - Manual

Page 3 - CONTENTS; MEASURING

© Adam Equipment Company 2005 CONTENTS 1.0 INTRODUCTION .............................................................................................2 2.0 KEYS AND DISPLAY DESCRIPTION .............................................................2 3.0 TROUBLESHOOTING THE MDW-250L .......................

Page 4 - INTRODUCTION; KEYS; To lock the reading even if the person to be weighed is moving.; DISPLAY; ZERO; Full

© Adam Equipment Company 2005 2 1.0 INTRODUCTION The MDW 250L scale is a Digital Physician Scale. It is an accurate electronic device with advanced design and stable performance. It is designed to measure both the weight and the height of a person. 2.0 KEYS AND DISPLAY DESCRIPTION KEYS FUNCTIONS [Ta...

Page 5 - PROBLEMS; FULL; HOLD

© Adam Equipment Company 2005 3 3.0 TROUBLESHOOTING THE MDW-250L PROBLEMS SUGGESTIONS Nothing happens when [On/off] is pressed Press the switch situated on side of the indicator to ON , for battery operation Display turns ON but then goes off Charge the battery Display shows “ FULL ” and does not ch...

Page 6 - TECHNICAL SPECIFICATIONS

© Adam Equipment Company 2005 4 4.0 TECHNICAL SPECIFICATIONS Maximum capacity 250 kg Minimum capacity 2 k g Scale division 100 g Height range 70cm-190cm Division of measurement 0.5cm Accuracy class Display LCD Size of platform 372X272cm Overall dimension 535X275X940mm Deadweight 13Kg Environment for...

Page 7 - SCALE

© Adam Equipment Company 2005 5 • Position the height measuring rod and secure it by fixing its threaded end. • Connect the adapter power supply to the main power supply and put the switch at the rear of the scale to ON. 6.0 FUNCTION 6.1 WEIGHING • Place the Physician Scale on an even floor and pres...

Page 8 - Overload display; MEASURING HEIGHT; USER CALIBRATION; ON

© Adam Equipment Company 2005 6 • Overload display : When “ FULL ” appears on the display, it shows that the load on the platform is over the maximum capacity. Under these circumstances, it is necessary to reduce the load otherwise the sensor or the platform will be damaged. • Hold Function: To lock...

Page 9 - ULOAD; OFF

© Adam Equipment Company 2005 7 4. The indicator will show the selection capacity: “ P1000 ” “ P2000 ”….” P5000 ”, Select “ P2500 ” for 250kg, then press the [On/Off] key once. 5. Indicator will automatically show the decimal points : “ POT 0 ” “ PT0.0 ” “ T0.00 ” “ T0.000 ”, “ POT 0 ”. Select the “...

Page 11 - ADJUSTMENT AND REPAIRS

© Adam Equipment Company 2005 9 9.0 ADJUSTMENT AND REPAIRS 9.1 ADJUSTMENT The users can not make any adjustments other than Calibration. 9.2 REPAIRS 9.2.1 ELECTRONICS REPAIR The most common electrical problems are- 1> Broken cables between the base and indicator, 2> Broken cables or poor conne...

Page 12 - Voltage between pins 2 and 3 should be approximately 0 to 1mv. This

© Adam Equipment Company 2005 10 Any broken knife edges, bent “S” links or severe misalignment can cause poor weighing results. Inspect for damage and try to re-align parts if necessary. If any of the mechanical parts are damaged or missing, it is usually not possible to do a cost-effective repair. ...

Page 16 - ADAM EQUIPMENT

© Adam Equipment Company 2004 ADAM EQUIPMENT is an ISO 9001:2000 certified global organisation with more than 30 years experience in the production and sale of electronic weighing equipments. Products are sold through a world wide distributor network -supported from our company locations in the UK, ...

Adam Equipment MDW-250 L - Manual

Table of Contents:

Summary

Other Adam Equipment Models