Adam Equipment ae-301 - Manual

© Adam Equipment Company November 2011 5 2.2 POWER SUPPLY • Power can be supplied using an internal re-chargeable battery provided within the indicator case, or from mains power. • If the battery is low on charge the symbol on the LCD will show just one bar meaning the battery needs to be re- charge...

© Adam Equipment Company November 2011 8 3.7 ALARM 3.7.1 Over-load alarming • When the sample weight on the scale is over the maximum capacity the beep will sound and the display will show “Err“. • Remove the weight immediately to avoid any damage to the scale. 3.7.2 Low-load alarming • If the top p...

© Adam Equipment Company November 2011 9 Parameters Description 1. BLT Enable / disable the backlight 2. CHK Enable / disable the check-weighing facility 3. FIL Enable / disable the ADC filter rate 4. SDT Sets the RS-232 output function. Options are 1, 2, 3 and 4. 5. PAT Sets the following parity op...

© Adam Equipment Company November 2011 11 5.0 RS-232 INTERFACE The BFW series of indicators come with a standard RS-232 interface. U The standard Interface parameters are: U Connection details are: U Normal Output U : (For SDT 1, 2 and 3) SN ± xx.xxx LL UU S stands for stable, N for no error G/W for...

© Adam Equipment Company November 2011 12 6.0 TECHNICAL PARAMETERS To enter this section, press and hold the [Mode] and the [Tare] key while you turn on the indicator. The display will show the revision number and then the first parameter Zero Tracking as “ ZEO ” 6.1 ZERO TRACKING • When ZEO is disp...

© Adam Equipment Company November 2011 13 6.3 CALIBRATION The next section is the Calibration section. A weight value and. “ WEl ” will be displayed. • When WEI is displayed, press the [Unit] key to scroll through the options for selecting the calibration mass. • To select the desired mass press the...

© Adam Equipment Company November 2011 14 7.0 TROUBLE-SHOOTING GUIDE PROBLEMS POSSIBLE CAUSES Display is blank On/Off switch on rear panel is off Indicator not turned on Battery not charged No countdown of display on power up Battery not charged Power supply not plugged in or incorrect type Power su...

© Adam Equipment Company November 2011 15 8.0 SERVICE INFORMATION This manual covers the details of operation. If you have a problem with the indicator that is not directly addressed by this manual then contact your supplier for assistance. In order to provide further assistance, the supplier will n...

© Adam Equipment Company November 2011 16 WARRANTY INFORMATION Adam Equipment offers Limited Warranty (Parts and Labour) for the components failed due to defects in materials or workmanship. Warranty starts from the date of delivery. During the warranty period, should any repairs be necessary, the p...

© Adam Equipment Company November 2011 Manufacturer’s Declaration of Conformity This product has been manufactured in accordance with the harmonised European standards, following the provisions of the below stated directives: Electro Magnetic Compatibility Directive 2004/108/EC Low Voltage Directive...