Zip CT1003 - User Manual

Typical Cut out procedure for B Ventilation Cutout deatils Air inlet vent 1. Mark out and cut the air inlet and door outlet holes as shown 2. Ensure the air inlet vent and air outlet vent are positioned at opposite ends of the same cupboard space. 3. Fit the inlet vent, as shown and secure with 5 sc...

Section 3 CO2 Cylinder WARNING: This cylinder mus be installed in an open plan area or in an enclosed room, with a volume no less than 20m3. If more than 1 gas cylinder containing CO2 is present within the same location, the recommended ventilated area should be in proportion to the number of gas cy...

Installation & Operating Instructions - 89914 - Zip ChillTap Sparkling - Jan 2016 v1.04 Page 12 of 20 # Installation Instructions continued 4.1 - Chiller Installation Place the chiller unit into the cupboard with the proposed outlet tap position as close as possible, to minimise the length of tu...

CO2 pressure set zone: 2.7- 3.0 bar After replacing a bottle or after making a gas connection: Stage1: 1. Turn the gas OFF 2. Using soapy water applied with a sponge, or with a brush, cover all of the gas joints with a liberal amount of suds. 3. Alternatively, use a leak detecting spray. Stage 2: 1....

Page 14 of 40 802005 - Sparkling HT-BCS; CS; AIO; Residential- Installation Instructions - June 2015 - v2.01 Section 5 Commissioning Chilled filtered water (blue) Sparkling filtered water (white) Note: After dispensing sparkling water, a small amount will remain in the carafe filler. If the next dri...

Section 6 Maintenance Installation & Operating Instructions - 89914 - Zip ChillTap Sparkling - Jan 2016 v1.04 Page 15 of 20 Water Filter Replacement NOTE: For safe operation, the filter cartridge should be replaced every 6-12 months, or earlier if you notice a persistent reduction in water press...

Page 16 of 40 802005 - Sparkling HT-BCS; CS; AIO; Residential- Installation Instructions - June 2015 - v2.01 Air Filter Change: The Zip HydroTap air filter is conveniently located on the outside of the condenser. The filter screen is a sliding fit in the plastic housing on the left hand side of the ...

Installation & Operating Instructions - 89914 - Zip ChillTap Sparkling - Jan 2016 v1.04 Page 17 of 20 # Trouble Shooting Symptom Possible Cause Responsibility Solution No still water No sparkling water Poor levels of carbonation in drinks Mains water not connected or turned on Water pressure reg...

Installation & Operating Instructions - 89914 - Zip ChillTap Sparkling - Jan 2016 v1.04 Page 18 of 20 Trouble Shooting continued Warm drinks No power Thermostat faulty or out of calibration. Insufficient cooling air flow through the fridge Fridge failure Rated chilled water capacity has be expen...

Installation & Operating Instructions - 89914 - Zip ChillTap Sparkling - Jan 2016 v1.04 Page 20 of 20 Head Office Zip Heaters (Aust) Pty. Ltd.ABN: 46 000 578 72767 Allingham StreetCondell Park NSW 2200 Postal: Locked Bag 80Bankstown 1885 Australia Website: www.zipwater.comFacsimile (02) 9796 385...