Zanussi ZWI 71201 WA- Manual

Delay Start The programme can be delayed from 30 min - 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 20 hours by means of this button. Door locked pilot light The pilot light 9 illuminates when the programme starts and indicates if the door can be opened:• light on: the door cannot ...

Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Detergent Compartment 17–Mini 30’ Main wash - Rinses Maximum spin speed at 700 rpm Max. load 3 kg Quick washing programme for cotton and synthetic items which are lightly soile...

Helpful hints and tips Sorting out the laundry Follow the wash code symbols on each garment label and the manufacturer’s washing instructions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, wool- lens. Before loading the laundry Never wash whites and coloureds together. White...

• you are washing a small load• the laundry is lightly soiled• large amounts of foam form during washing. Degrees of water hardness Water hardness is classified in so-called “degrees” of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply com- p...

Important! • The selected delay can be changed only after selecting the washing programme again. • The door will be locked throughout the delay time. If you need to open the door, you must first set the wash- ing machine to PAUSE by pressing button 7 and wait a few minutes before opening the door. A...

Problem Possible cause/Solution The machine vibrates is noisy: The transit bolts and packing have not been removed.• Check the correct installation of the appliance. The support feet have not been adjusted• Check the correct levelling of the appliance. The laundry is not evenly distributed in the dr...

Water supply pressure Minimum Maximum 0,05 MPa 0,8 MPa Maximum Load Cotton 7 kg Spin Speed Maximum 1200 rpm (ZWI71201WA) 1400 rpm (ZWI71401WA) Consumption values Programme 1) Energy consumption (KWh) 2) Water consumption (litre) 2) White Cottons 90 °C 2.2 72 Cottons 60 °C 1.35 67 Cottons 40 °C 0.85 ...

The other end of the inlet hose which connects to the appliance can be turned as showed in the picture. Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. Set the hose correctly by loosening the ring nut. After positioning the inle...

If the outlet spigot has not been used before, remove any blanking plug that may be in place. Push the drain hose onto the spigot and secure with a clip, ensure a loop is formed in the drain hose (see above) to prevent waste from the sink enter- ing the appliance. If you intend to drain the hose fro...

D 46 8 Caution! Do not remove the screw 8! d) Counter-magnet (6) The appliance is prearranged for a magnetic closure of the door. To enable a correct operation of this device, it is neces- sary to screw the counter-magnet (6) (steel disk + rub- ber ring) into the inner side of the door. Its position...

Drill four fixing holes see Fig. G Position the base into the recess with its front edge as far forward as the adjoining plinth line will allow. The reason for placing the base in this position is to al- low a small strip of beading to be fitted in front of the appliance feet.Graphic H 600-605 490 5...