Zanussi ZFT 50/2R - User Manual

5 The appliance can be installed to recirculate or extract contaminated air. The cooker hood is more effective when used in the extraction mode. Recirculation In the recirculation mode contaminated air is passed through the charcoal filter to be purified and recirculated into the kitchen through a r...

6 MAINTENANCE AND CLEANING Before carrying out any maintenance or clea- ning isolate the cooker hood from the mains supply. The cooker hood must be kept clean, a build up of grease or fat can be a fire hazard. External Cleaning Wipe the cooker hood frequently with warm soapy water using a mild deter...

7 Synthetic Paper Grease Filter The filter has saturation indicators, which are small squa - res made from a series of dots. When the white paper inside the squares becomes saturated with grease the coloured dots start to run and spread across the paper, indicating that the filter has reached satura...

8 SOMETHING NOT WORKING SERVICE AND SPARE PARTS If, having followed these instructions carefully, your cooker hood fails to work properly please carry out the following checks. Symptom The cooker hood will not start The cooker hood is not working effectively The cooker hood has switched off during o...

9 GUARANTEE CONDITIONS We Zanussi, undertake that if within 12 months of the date of the purchase this Zanussi built-in appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, the company will, at our option repair or replace the same FREE OF ANY CH...

10 INSTALLATION INSTRUCTIONS Note: CE Marking certifies that this appliance complies with the requirements laid down in EEC directive 89:336. (Electromagnetic compatibility) and subsequent modifications and Low Voltage directive 72/23/E. It is dangerous to alter the specifications or attempt to modi...

11 INSTALLING THE COOKER HOOD Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air. Incorrect installation may affect the safety of...

12 The clereance height between the inferior part of the cooker hood and the hob must be 650 mm ( some models can be fitted at a lower height from the hob, please refer to the installa- tion paragraph). Unpacking The fittings supplied to install this cooker hood can be found with the instruction boo...

13 Venting The hood is more effective when used in the extraction setting (ducted to the outside). Venting kits maybe purchased through your retailer or DIY store, and must be ducted to an outside vent of 100mm (4”) minimum. The ducting used must be manufactured from fire retardant material which sh...

14 The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will...

15 In the event of your appliance requiring service, or if you wishto purchase spare parts please contact your local ServiceForce Centre by telephoning: 08705 929929 Your telephone call will be automatically routed to the ServiceForce centre covering your post code area. For the address of your loca...