York H*DA012 - Manual
York H*DA012 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Physical and Electrical Data
- Page 4 – COOLING CAPACITY; & 3 PHASE HDA WITH N1AH AIR HANDLER & G2FD COILS
- Page 5 – TYPICAL FIELD WIRING
- Page 6 – TYPICAL INSTALLATION; FOR NON-FURNACE APPLICATIONS; MODULAR BLOWER
- Page 7 – NOTES
036-21105-004 Rev. A (0902)
FOR DISTRIBUTION USE ONLY - NOT TO BE USED AT POINT OF RETAIL SALE
®
TECHNICAL GUIDE
STELLAR 2000
SPLIT-SYSTEM AIR CONDITIONERS
10 SEER 50 HZ
MODELS: H*DA012 THRU H*DA076
(1 & 3 PHASE)
(1 THRU 7.5 NOMINAL TONS)
Due to continuous product improvement, specifica-
tions are subject to change without notice.
Visit us on the web at www.york.com for the most
up-to-date technical information.
DESCRIPTION
The HDA Series condensing unit is the outdoor part of a ver-
satile system of air conditioning. It is designed to be custom-
matched with one of UPG's complete line of evaporator sec-
tions, each designed to serve a specific function. Matching
Air Handlers are available for upflow, downflow or horizontal
application to provide a complete system. Electric heaters are
available if required.
FEATURES
•
QUALITY CONDENSER COILS -
The coil is constructed
of enhanced copper tube and aluminum fins.
•
COIL PROTECTION -
Coils are protected from damage by
a polymer mesh applied between the coil face, and a PVC
coated steel coil guard.
•
PROTECTED COMPRESSOR -
The compressor is inter-
nally protected against high pressure and temperature.
This is accomplished by the simultaneous operation of
high pressure relief valve and a temperature sensor which
protect the compressor if undesirable operating conditions
occur.
•
DURABLE FINISH -
Cabinet is made of pre-painted steel.
The pre-treated flat galvanized steel provides a better
paint to steel bond, which resists corrosion and rust creep.
Special primer formulas and glossy earth tone finish insure
less fading when exposed to sunlight.
•
LOWER INSTALLED COST -
Installation time and costs
are reduced by easy power and control wiring connec-
tions. Discharge line heat exchanger knockouts are pro-
vided, if required. Both quick connect and sweat connect
models are available. Both service valves are firmly affixed
to the unit. The sweat unit contains enough refrigerant for
matching indoor coils and 15 feet of interconnecting pip-
ing. The small base dimension means less space is
required on the ground or roof.
•
TOP DISCHARGE -
The warm air from the top mounted
fan is blown up away from the structure and any landscap-
ing. This allows compact location on multi-unit applica-
tions.
•
LOW OPERATING SOUND LEVEL -
The upward air flow
carries the normal operating noise up away from the living
area. The rigid top panel effectively isolates any motor
sound. Isolator mounted compressor and the rippled fins
of the condenser coil muffle the normal fan motor and
compressor operating sounds.
•
LOW MAINTENANCE -
Long life permanently lubricated
motor- bearings need no annual servicing.
•
EASY SERVICE ACCESS -
Fully exposed refrigerant con-
nections and a single panel covering the electrical controls
make servicing easy.
•
SECURED SERVICE VALVES -
Secured re-usable ser-
vice valves are provided on both the liquid and vapor
sweat connections for ease of evacuating and charging.
•
FACTORY TESTED -
to verify system operation and con-
trol functioning before shipment.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
036-21105-004 Rev. A (0902) 2 Unitary Products Group Physical and Electrical Data MODEL H*DA 18 24 30 36 48 60 076 Unit Supply Voltage 230 – 1 – 50 380/415-3-50 Normal Voltage Range * *. Rated in accordance with ARI Standard 110, utilization range “A”. 216 to 252 342-456 Minimum Circuit Ampacity 12....
036-21105-004 Rev. A (0902) 4 Unitary Products Group MBH based on 80°F entering air temperature, 50% RH, and rated air flow.KW includes compressor, outdoor fan and indoor blower motor watts. Add-on coils include 365 watts/1000 CFM for blower motor. SEER (Seasonal Energy Efficiency Ratio) is the tota...
036-21105-004 Rev. A (0902) Unitary Products Group 5 TYPICAL FIELD WIRING TYPICAL FIELD WIRING - 1 PHASE TYPICAL FIELD WIRING - 3 PHASE CONTROL WIRING LOW VOLTAGE JUNCTION BOX POWER WIRING GROUND LUG ALL OUTDOOR WIRING MUST BE WEATHERPROOF. USE COPPER CONDUCTORS ONLY. POWER WIRING 230-1-50 CONTACTOR...
