York DH 240 - Manual

York DH 240

York DH 240 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
Page: / 44

Table of Contents:

  • Page 2 – TABLE OF CONTENTS; LIST OF FIGURES
  • Page 3 – PRODUCT NOMENCLATURE; 5-25 Ton Sunline UltraTM Model Number Nomenclature
  • Page 4 – FEATURES; Simplicity
  • Page 5 – All models are CSA approved.; Gas Heat Operation; - All gas heat units are built with; Electric Heat Operation; - York’s SunlineTM series units offer factory; Comfort; FACTORY-INSTALLED OPTIONS; FIGURE 1 - UNIT CUTAWAY; UNIT SHOWN
  • Page 8 – FIELD-INSTALLED ACCESSORIES
  • Page 9 – TABLE 1: INDOOR SOUND POWER RATING; TABLE 3: GAS HEAT RATINGS
  • Page 18 – Example 1; tion is given so 70°F is assumed.; TABLE 8: ALTITUDE CORRECTION FACTORS
  • Page 19 – ALTITUDE/TEMPERATURE CONVERSION FACTOR
  • Page 20 – 80 MBH - BOTTOM DUCT CONNECTIONS
  • Page 21 – 10 MBH - BOTTOM DUCT CONNECTIONS
  • Page 22 – 40 MBH - BOTTOM DUCT CONNECTIONS
  • Page 26 – 00 MBH - BOTTOM DUCT CONNECTIONS
  • Page 27 – TABLE 16: BLOWER MOTOR AND DRIVE DATA; TABLE 18: POWER EXHAUST PERFORMANCE
  • Page 32 – TABLE 25: DH VOLTAGE LIMITATIONS; POWER SUPPLY; TABLE 26: ELECTRIC HEAT CORRECTION; NOMINAL VOLTAGE; TYPICAL DH FIELD WIRING DIAGRAM; CONTROL WIRING
  • Page 33 – TABLE 27: PHYSICAL DATA
  • Page 34 – TABLE 30: UTILITIES ENTRY DATA; HOLE
  • Page 35 – REAR VIEW DIMENSIONS; For bottom duct applications:; Connect ductwork to the flanges on those panels.
  • Page 36 – Locate unit so that the vent air outlet hood is at least:; TABLE 31: MINIMUM CLEARANCES; REAR VIEW
  • Page 37 – UNIT CENTER OF GRAVITY
  • Page 38 – UNIT 4 POINT LOAD; FIGURE 10 - UNIT 6 POINT LOAD
  • Page 39 – FIGURE 11 - UNIT ROOF CURB DIMENSIONS
  • Page 40 – FIGURE 14 - TYPICAL ROOFTOP INSTALLATION; SIMPLICITY; CONTROL WIRING DIAGRAM
  • Page 41 – GUIDE SPECIFICATIONS; GENERAL; UNIT CABINET
  • Page 42 – REFRIGERANT COMPONENTS; All models shall have two independent circuits.; UNIT CONTROLS; Primary and auxiliary high-temperature limit switches.; UNIT OPERATING CHARACTERISTICS
Loading the manual

262260-YTG-E-1008

FOR DISTRIBUTION USE ONLY - NOT TO BE USED AT POINT OF RETAIL SALE

SINGLE PACKAGE GAS/ELECTRIC UNITS

AND SINGLE PACKAGE

AIR CONDITIONERS

DH 180, 210, 240 & 300

15, 17.5, 20 & 25 NOMINAL TONS

10.8 EER (15 TONS), 10.2 EER (17.5 TONS), 9.7 EER (20
TONS) AND 9.6 EER (25 TONS)

®

TECHNICAL GUIDE

DESCRIPTION

YORK Sunline Ultra™ units are convertible single package
high efficiency rooftops. All models have independent dual
refrigerant circuits for efficient part load operation. Although
the units are primarily designed for curb mounting on a roof,
they can also be slab-mounted at ground level or set on steel
beams above a finished roof.

All units include:

•

Powder Paint finish that meets ASTM-B-117 1000 hour
salt spray standards

•

Two-stage cooling provided by dual independent refriger-
ation circuits with expansion valves, filter-driers, high and
low pressure/loss of charge switches and freezestats

•

Hermetically sealed scroll compressors with crankcase
heaters

•

Two-stage heating provided by dual independent heat
exchangers with aluminized steel tubes, redundant gas
valves, spark ignition with induced draft logic

•

Permanently lubricated motors

•

Bottom or side air discharge configuration capability
(field convertible)

•

Belt drive blower motor with high static drive options

•

Constant supply air volume (CV) with optional variable
air volume (VAV)

•

Manufactured under the quality standards of ISO9001

•

Twenty-four volt control circuit with compressor lock-out

•

Zero-25% fixed air damper with hood

•

Copper tube/aluminum fin coils

•

Hinged filter access and tool free latched doors optional

•

Hinged tool free blower, blower motor, filters and electri-
cal panel access optional

•

Rigging holes in base rails for lifting

•

Single point power connection

•

Complete factory package - tested, charged and wired

•

CSA agency approvals on all units

WARRANTY

•

Factory Limited Parts Warranty

•

One-year parts warranty

•

A Five-year parts warranty on the compressor and

electric heat elements.

•

Ten-year parts warranty on the gas-fired heat

exchangers.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - TABLE OF CONTENTS; LIST OF FIGURES

262260-YTG-E-1008 2 Johnson Controls Unitary Products TABLE OF CONTENTS DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 PRODUCT NOMENCLATURE . . . . . . . . . . . . . . . . . 3 FEATURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 FACTORY-INSTALLED OPTION...

Page 3 - PRODUCT NOMENCLATURE; 5-25 Ton Sunline UltraTM Model Number Nomenclature

262260-YTG-E-1008 Johnson Controls Unitary Products 3 PRODUCT NOMENCLATURE D H 180 N24 A 2 A AA 1 0 1 2 4 A D = A/C, Single Pkg., R-22 Product Category Airflow 1 = First Generation Product Generation 2 = Second Generation C00 = Cooling Only. No field installed electric heat Heat Type and Nominal Hea...

Page 4 - FEATURES; Simplicity

262260-YTG-E-1008 4 Johnson Controls Unitary Products FEATURES All models are available with a wide variety of factory-mounted options such as stainless steel heat exchangers, phase monitor, dirty filter switch, and coil guard to make them suitable for almost every application. All units are self-co...

Other York Models

All York Other