York D1EE 048 - Manual
York D1EE 048 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – FIGURES; No. Description Page; TABLE OF CONTENTS
- Page 3 – MUST; Unitary Products Group; INSTALLATION; Voltage Variation; - UNIT APPLICATION DATA
- Page 4 – - RECOMMENDED DRAIN PIPING
- Page 6 – - TYPICAL FIELD WIRING; CONTROL WIRING; POWER WIRING; C O O L I N G / H E A T I N G ( E L E C T R O N I C T H E R M O S T A T )
- Page 7 – REAR VIEW; DETAIL “A”
- Page 8 – ELECTRIC HEATERS; - ENTHALPY SET POINT ADJUSTMENT; TABLE 3
- Page 9 – TABLE 4
- Page 10 – TABLE 5
- Page 11 – TABLE 6
- Page 12 – NOTE: Prior to each cooling season, the crankcase heater; COOLING SEQUENCE OF OPERATION; WITH POWER TO UNIT AND THERMOSTAT IN THE; OPERATION; - HEAT ANTICIPATOR SETTING
- Page 13 – MOTOR PULLEY ADJUSTMENT; CAUTION; - PRESSURE DROP ACROSS A DRY
- Page 14 – SECURE OWNER'S APPROVAL; perature settings within the limitations of the system.; MAINTENANCE; NORMAL MAINTENANCE; CAUTION: Prior to any of the following maintenance proce-
GENERAL
YORK Model DEE units are single package air conditioners
designed for outdoor installation on a rooftop or a slab. Electric
heaters are available as field-installed accessories.
The units are completely assembled on rigid, permanently
attached base rails. All piping, refrigerant charge, and electrical
wiring is factory-installed and tested. The units require only
electric power and duct connections at the point of installation.
The electric heaters have nickel-chrome elements and utilize
single point power connection.
INSPECTION
As soon as a unit is received, it should be inspected for possible
damage during transit. If damage is evident, the extent of the
damage should be noted on the carrier's freight bill. A separate
request for inspection by the carrier's agent should be made in
writing. Refer to Form 50.15-NM for additional information.
REFERENCE
Additional information on the design, installation, operation and
service of this equipment is available in the following reference
forms:
•
55.70-N1
-General Installation
•
55.70-N2
-Pre-start & Post-start Check List
•
530.18-N1.2V -Economizer Accessory
•
530.18-N1.13V -Man. Outdoor Air Damper Accy 0-35%
•
530.18-N1.14V -Man. Outdoor Air Damper Accy 0-100%
•
530.18-N1.12V -Motorized Outdoor Air Damper Accy.
•
530.18-N1.8V -Coil Guard
•
530.18-N7.1V -Electric Heater Accessory
•
530.18-N7.2V -Fuse Block Accessory
•
690.15-N25V
-Low Ambient to 0
°
F
Renewal Parts:
•
Refer to Parts Manual for complete listing of replacement
parts on this equipment.
All forms referenced in this instruction may be ordered from:
Standard Register
Toll Free Tel: 877-318-9675/Fax. 877-379-7920
APPROVALS
Design certified by U.L. and C.G.A. as follows:
1. For use as a cooling only unit or cooling unit with electric heat.
2. For outdoor installation only.
3. For installation on combustible material.
®
SUNLINE 2000
™
ELECTRIC / ELECTRIC
SINGLE PACKAGE AIR CONDITIONERS
INSTALLATION INSTRUCTION
Supersedes: 035-12046-002-A-0302
035-12046-003-A-0204
Installer should pay particular attention to the words:
NOTE, CAUTION
and
WARNING
. Notes are intended to clarify or
make the installation easier. Cautions are given to prevent equipment damage. Warnings are given to alert installer that per-
sonal injury and/or equipment damage may result if installation procedure is not handled properly.
MODELS D1EE 048 & 060
and D2EE 036 (11 SEER)
CAUTION
T H E E N C LO SE D IN S TA LLA TIO N IN S TR U C TIO N S A N D A N Y A P PLIC A B LE
LO C AL, ST AT E, A N D N AT IO N A L C O D E S IN C LU D IN G , B U T N O T LIM IT ED
TO , BU ILD IN G , ELE C TR IC A L, AN D M E C H AN IC A L C O D E S .
T H IS P R O D U C T M U S T B E IN S T A L L E D IN S T R IC T C O M P LIA N C E W IT H
WARNING
O P E R A T IO N O F T H E P R O D U C T C O U L D C A U S E P E R S O N A L IN J U R Y
O R P R O P E R T Y D A M A G E .
IN C O R R E C T IN S TA LLAT IO N M AY C R E A TE A C O N D IT IO N W H E R E TH E
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
035-12046-003-A-0204 2 Unitary Products Group General................................................................................1Inspection ............................................................................1Reference .......................................................................
LIMITATIONS These units must be installed in accordance with the current edition of the following national and local safety codes:In USA: 1. National Electrical Code ANSI/NFPA No. 70. 2. Local electric utility requirements. In Canada: 1. Canadian Electrical Code C22.1. 2. Canadian Installation Codes...
kept clean or replaced with same size and type. Dirty filters will reduce the capacity of the unit and will result in frosted coils or safety shutdown. Minimum filter area and required sizes are shown in Table 2. CONDENSATE DRAIN Plumbing must conform to local codes. Use a sealing compound on male p...
