Xantech VSX-45TX - Manual
Xantech VSX-45TX – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Application Advisory
AA-04(Interfacing with Pioneer VSX-45TX)
Page 1 of 2
Symptom:
Unable to control a Pioneer VSX-45TX Receiver via the
Multi Room &
Source
REMOTE IN jack on the rear of the receiver.
Solution:
This requires any one of Xantech’s IR Receivers (291, 480,490, or 780
Series), 781RG Power Supply with a standard connecting block (CB12,
789-44 etc.) and a 3.5mm Stereo Mini Plug to Stereo Mini Plug cable.
This is a DIRECT Connect application with a standard emitter out but
requires a Stereo Mini Plug instead of a Mono Mini Plug.
NOTE: Do not use a mono mini plug when connecting to the MR&S
Remote IN Jack on the rear of the receiver.
The Pioneer VSX-45TX
MR&S Remote IN jack outputs a 5VDC voltage on the RING of the Stereo
Mini Jack. Using a Mono Mini Plug will short this voltage to ground and
possibly damage the unit.
1. To operate the receiver from a remote room, connect the system as
follows (see Figure 1 for reference):
OUT
V
IR
RCVR
PWR
G S
X
283M
Emitter
CD Changer
Cassette DecK
291-10 or -80
IR Receiver
REMOTE ROOM
789-44
Connecting Block
283M
Emitter
IR Remote
12VDC
+12 VDC
GND
STATUS
IR IN
EMITTERS
789-44
CONNECTING BLOCK
®
IR
RCVR
3.5mm Stereo Mini to Stereo Mini Cable
To Multi Room & Source
REMOTE IN Jack on rear
To 120 V AC
(unswitched)
781RG
Power Supply
Pioneer VSX-45TX
MAIN EQUIPMENT ROOM
24AWG to 18AWG
3 Conductor Wire
X
Figure 1: Sample IR Repeater setup configuration
2. Using a 3.5mm Stereo Mini Plug cable (Xantech PN#06017600),
connect one end into a spare emitter port on the 789-44 Connecting
Block (or other) and the opposite end into the Green jack on the rear
of the Receiver marked
Multi Room & Source REMOTE IN
.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
