Xantech MX88VI - Manual
Xantech MX88VI – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – CONNECTIONS; Figure 2: A common network system for the MX88vi/MX88ai
- Page 3 – a. Note that you will need to know its IP Address to do this.
- Page 4 – SETTING UP A STATIC IP ADDRESS; Changing the IP Address of a MRIP; MRIP Installer
- Page 5 – Figure 4: MRIP Installer Utility – IP Setup; interference from Safari.
-
1
-
INSTALLATION INSTRUCTIONS
MX88vi, MX88ai Multi-room IP Interface
INTRODUCTION
The MX88vi and MX88ai have the capability to connect to an internet-ready device such as the
popular Apple iPad and/or a personal computer. A web-based user interface provides control to the
MX88vi and MX88ai. It is recommended to use a web-browser (such as Apple Safari and Mozilla
Firefox) with a screen resolution of 800 x 600 or greater. This document will explain a common
installation application.
Figure 1: Sample screen shot of the web-based user interface inside the MX88vi/MX88ai
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
- 2 - CONNECTIONS The MX88vi and MX88ai must be connected to a network. A wireless Ethernet router is preferred so that a wireless tablet, such as the Apple iPad can be used. While a personal computer is not a necessity for the installation, it is good idea to connect it to the Ethernet router for t...
- 3 - NETWORK CONFIGURATION OVERVIEW Note: Most residential networks are managed by a network router (usually the box next to the cable or DSL modem). You will need to have access to the network router settings in order to successfully add the MRIP to the network. In order to fully enjoy the MRIP, y...
- 4 - SETTING UP A STATIC IP ADDRESS In order to use your MRIP (either external, or the internal version built into the MX88), you first need to configure it for your network. You will need to assign the MRIP a static IP Address. The MRIP ships with its TCP/IP addressing set to obtain an IP address ...
