Xantech ML25 - Manual
Xantech ML25 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
INSTALLATION INSTRUCTIONS
MODEL
ML25
Micro Link™ Peep-Hole Style
Standard IR Receiver
1
DESCRIPTION
The Micro Link IR Receiver is a small peep-hole style infrared repeater
assembly. The Micro Link IR Receiver is equipped with a 7-foot cable and
a 3.5mm stereo mini plug, which is plugged directly into the “IR RCVR”
jack on the connecting block, such as the models 789-44, CB60, and 791-
44. The Micro Link IR Receiver is primarily intended for use in installations
where the connecting block is within reach of its 7-foot cable – as when
installing the Micro Link IR Receiver in a cabinet where the controlled
equipment is behind closed doors.
FEATURES
•
Small size; mounts in 1/2” diameter hole. 2 inches deep (50mm).
•
Quick-Connect 3.5mm Stereo Mini Plug on 7ft. cable for direct plug-in
to Xantech Connecting Blocks.
•
Works in normal 3-wire mode (12VDC, IR, GND).
•
Green Talkback LED for System Verification.
SPECIFICATIONS
•
Infrared modulation frequency bandwidth: 25 – 60 kHz.
•
IR reception range: Up to 80 feet, depending on remote control output
strength and ambient conditions.
•
Reception angle: 55 degrees off axis for 50% range reduction.
•
Cable requirements: 3-conductor. Use 24 gauge up to 200’, 22 gauge
up to 600’ 20 gauge up to 2000’, 18 gauge up to 5000’ – unshielded
OK.
•
Max. transmission length: 1 mile using 18 gauge wire.
•
Maximum current output: 100mA
•
Drives IR emitters through Xantech Connecting Blocks, Controllers,
etc.
•
Dimensions: 1/2” diameter x 2” deep (13mm x 50mm).
•
Power requirements: +12VDC, 20mA.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
