Xantech ISM4 - Manual
Xantech ISM4 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – MACRO PROGRAMMING TABLE; Brand
- Page 4 – once to indicate that the ISM4 has entered delay mode.
- Page 5 – Deleting IR Commands and Macros; LED will blink once indicating that the IR command was deleted.
- Page 6 – NOTES
TYPICAL SYSTEM CONNECTIONS
ISM4 INTELLIGENT SYSTEM MANAGER
PROGRAMMING QUICK START GUIDE
Front
Rear
This ISM4 Programming Quick Start Guide provides the basic instruction to programming an ISM4. To use the Quick Start Guide, fill
out the Macro Programming Table and follow the Programming Instructions. For complete instructions on installation, connections and
additional programming capabilities, refer to the ISM4 Installation & Programming Manual.
The System shown on the back cover illustrates a typical Home Theater System. In the configuration as shown, when the TV is turned
ON, the ISM4 will sense the TV ON state, look at Sources 2-4 (A/V Receiver, Cable Box and DVD Player) and if any of them are OFF,
automatically output the Source ON Macros for those devices to turn them ON. If at any time, while the TV is ON, any of Sources 2-4
turns OFF, the ISM4 will automatically turn it back ON. When the TV is turned OFF, the ISM4 will sense the TV OFF state, look at
Sources 2-4, and if any of them are ON, automatically output the Source OFF Macros for those devices to turn them OFF.
There are endless applications for this type of power management. Two other system examples are shown in the ISM4 Installation &
Programming Manual for reference. See Section: System Applications.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
MACRO PROGRAMMING TABLE Source 1 Source 2 Source 3 Source 4 IR Command ON OFF ON OFF ON OFF ON OFF Brand Device Command
Adding Delays 9. To add a DELAY after the IR Command (following Step 5), press the DELAY button. The PROGRAM LED will flash once to indicate that the ISM4 has entered delay mode. 10. Press the NEXT button once for each second of delay to be added to the IR Macro Command. Press the PREV button once f...
Deleting IR Commands and Macros 17. Delete a Single IR command (must be in EDIT mode): Press and release the DELETE button. The PROGRAM LED will blink once indicating that the IR command was deleted. 18. Delete a Macro: Press and hold (approximately 2 seconds) the DELETE button until the SOURCE (act...
