Xantech HDMI4X4 - Manual
Xantech HDMI4X4 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
28EXT
External Emitter Adapter
INSTALLATION INSTRUCTIONS
DESCRIPTION
The 28EXT External Emitter Adapter is placed between a Xantech IR system and a list of approved
electronic equipment that feature a rear panel IR input jack. These input jacks accept electrical IR
commands without the carrier frequency, and are therefore not compatible with full range IR Receivers that
output a carrier frequency along with the IR commands, such as all Xantech IR Receivers. The 28EXT
interfaces and adapts a Xantech IR receiver to these rear panel IR inputs.
INSTALLATION
•
Before making any connections:
•
Confirm that the source equipment to be controlled is one of the devices in table A below.
•
Table A below may indicate the need for a Wire-Swap Connector for some source units. If your device
to be controlled requires this connector, make sure that it is securely plugged into the 28EXT output
connector (the one with the black connector and the warning tag). Otherwise damage to your source
unit or the 28EXT may occur, and such damage will not be covered under warranty.
•
The 28EXT may not be compatible with non-Xantech IR Receivers and Connecting Blocks.
TABLE A:
APPLICATION #1 – XANTECH®
Models:
HDMI3x1, HDMI4x1, HDMI4x4, WIC1200
Connector marking: EXT IR or IR In
TIP
SIGNAL
RING
+5VDC Power
SLEEVE
GROUND
Wire-Swap Connector Not Required
APPLICATION #2 – GEFEN®
Model:
Any product that uses RMT-IR Extender (for
example: 3x1, 4x1, 4x4 HDMI switchers)
Connector marking: EXT IR
TIP
SIGNAL
RING
+5VDC Power
SLEEVE
GROUND
Wire-Swap Connector Not Required
APPLICATION #3 – OMNIMOUNT® PANEL MOUNTS
Model:
Motion52 Motorized Mount
Connector marking: R/C
TIP
SIGNAL
RING
+5VDC Power
SLEEVE
GROUND
Wire-Swap Connector Not Required
APPLICATION #4 – SIRIUS® SATELLITE TUNERS
Model:
SCH2P Sirius Connect Home Pro Tuner
Polk Audio®/Sirius SR-H1000 Home Tuner
Connector marking: IR INPUT
TIP
+5VDC Power
RING
SIGNAL
SLEEVE
GROUND
Wire-Swap Connector Required
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
