Xantech 490-95 - Manual
Xantech 490-95 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION; . The presence of Direct Sunlight and; MOUNTING
- Page 3 – Page 3; shown in; Equipment Rack; AV; Xantech IR Receiv ers.
- Page 4 – Satellite Receiver; Receiver; X X; Power; Output on the CB12. To W ire in this fashion:
INSTALLATION INSTRUCTIONS
MODEL 490-95
MICRO LINK™ “PLASMA FRIENDLY” INFRARED RECEIVER
TABLE OF CONTENTS
INTRODUCTION ............................................................................................................................................................. 1
Features ...................................................................................................................................................................... 1
Specifications .............................................................................................................................................................. 1
INSTALLATION ............................................................................................................................................................... 2
Placement ................................................................................................................................................................... 2
Mounting...................................................................................................................................................................... 2
Application Wiring ........................................................................................................................................................ 3
Adv anced Wiring Configuration .................................................................................................................................... 3
3.5mm Mini Plug Pinout ............................................................................................................................................... 4
INTRODUCTION
The
490-95
is designed to reject interference from
Plasma
Displays from entering the IR signal line. These Small IR
Receiv ers are intended to be mounted in panels, doors, cabinets, etc. for control of A/V equipment behind closed doors or
any IR Repeater System that is in close proximity of a
Plasma
or
LCD
Displays. Modeled after the original 490-90, the
490-95 offers the same features as its predecessor but in a smaller mounting frame.
FEATURES
•
Small size; mounts in ¾” diameter hole. 2¾ inches deep (70mm)
•
Quick-Connect 3.5mm Stereo Mini Plug on 7ft. (213.36cm) cable for direct plug-in to
Xantech
Connecting Blocks
•
W orks in normal 3-wire mode (12VDC, IR, GND)
•
Green Talkback LED for System Verification
•
Improv ed Fluorescent Light rejection (under most conditions) and rejection from LCD Displays
•
Can be used in Direct Sunlight
•
RF Grid included for EMI interference reduction
•
Includes CB12 Connecting Block for easy connection and extension of 7' ribbon cable
•
7 units may be powered by one 781RG power supply
Note:
The 490-95 will not operate in 2-wire
Phantom Power
mode
SPECIFICATIONS
•
Infrared modulation frequency bandwidth: 30 - 100 kHz
•
Reception range: up to 55 feet (17M), depending on local conditions
•
Reception angle: 55 degrees off axis for 50% range reduction
•
Cable requirements: 3-conductor. Use 24 gauge up to 200' (61M), 22 gauge up to 600' (182.5M), 20 gauge up to
1000' (305M), 18 gauge up to 2000' (610KM) -- unshielded OK)
•
Maximum transmission length: One mile using 18 gauge wire (1.6KM)
•
Maximum current output: 100 mA
•
Dimensions: 0.75" diameter x 2.75" deep (19mm x 70mm)
•
Power requirements: 12 v olts DC @ 20 mA
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Page 2 Model 490-95 © 2004 Xantech Corporation INSTALLATION These units, equipped with a 7-foot cable and 3.5 mm stereo mini plug, are intended to be plugged directly into the "IR RCVR" or "AUX" jack on Xantech Connecting Blocks, such as the CB12(included), CB60, 789-44, 791-44, etc....
Model 490-95 Page 3 © 2004 Xantech Corporation APPLICATION WIRING A typical system , with a 490-95, 781RG Power Supply and 283M Emitter plugged into a 789-44 Connecting Block, is shown in Figure 3 : 1. Plug in the 2.1mm Coaxial power plug of the 781RG Power Supply (not included) into the jack labele...
Page 4 Model 490-95 © 2004 Xantech Corporation 291-10 IR Receiver +12 VDC IR OUT GND 780-10 J-BOX RECEIVER ® Satellite Receiver AV Receiver VCR MAIN ROOM 1, EQUIPMENT CABINET, ETC. 282M Mouse Emitter 282M Emitter 283M Blink IR Emitter GND IR OUT +12V 780-10 J-Box IR Receiver 3-Wire Cable IR OUT GND ...
