Page 2 - I n t r o d u c t i o n
2 I n t r o d u c t i o n Gen’l (Rev. 2/19/2008) TO THE DEALER: Assembly and proper installation of this product is the responsibility of the Woods ® dealer. Read manual instructions and safety rules. Make sure all items on the Dealer’s Pre-Delivery and Delivery Check Lists in the Operator’s Manuala...
Page 3 - TABLE OF CONTENTS; Si no lee Ingles, pida ayuda a
I n t r o d u c t i o n 3 29927 (Rev. 3/14/2008) TABLE OF CONTENTS INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 GENERAL INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY RULES . . . . . . . ....
Page 4 - S a fe t y; TRAINING; SAFETY RULES
4 S a fe t y 59C-2 Safety Rules (Rev. 6/22/2007) TRAINING Safety instructions are important! Read all a tta c h m e n t a n d p o w e r u n i t m a n u a l s ; f o l l o w a l lsafety rules and safety decal information. (Replace-ment manuals and safety decals are available fromyour dealer. To loca...
Page 5 - TRANSPORTATION
S a fe t y 5 59C-2 Safety Rules (Rev. 6/22/2007) Do not stop, start, or change directions sud- denly on slopes. Use extreme care and reduce ground speed on slopes and rough terrain. Watch for hidden hazards on the terrain during operation. Stop power unit and equipment immediately u p o n s ...
Page 6 - S a f e t y; ROTATING BLADES AND; SAFETY & INSTRUCTIONAL DECALS; Replace Immediately If Damaged!
6 S a f e t y 29927 (Rev. 3/14/2008) 3 - SERIAL NUMBER PLATE MODEL NO. SERIAL NO. Woods Equipment Company Oregon, Illinois, U.S.A. 1 - PN 19007 ROTATING BLADES AND THROWN OBJECTS Do not put hands or feet under or into mower when engine is running. Before mowing, clear area of objects that may be thr...
Page 7 - WARNING; TO AVOID SERIOUS; SHIELD MISSING
S a f e t y 7 29927 (Rev. 3/14/2008) SAFETY & INSTRUCTIONAL DECALS ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! Replace Immediately If Damaged! 4 - PN 18877 WARNING TO AVOID SERIOUS INJURY OR DEATH: Read Operator's Manual (available from dealer) and follow all safety precautions. Keep all s...
Page 8 - O p e r a t i o n; OPERATION; MOWING GRASS; Streaking; Lubrication
8 O p e r a t i o n 29927 (Rev. 3/14/2008) OPERATION ■ Do not allow children or unqualified persons to operate equipment. ■ Keep bystanders away from equipment while it is in operation. ■ Stop mower and tractor immediately upon striking an obstruction. Turn off engine, removekey, inspect and repair ...
Page 10 - How to Align a Twisted Belt
1 0 O p e r a t i o n 29927 (Rev. 3/14/2008) How to Align a Twisted Belt Right : Inside edge of belt are approximately lined up with the sheave. Figure 2 . Wrong : Outer edge of belt appears to be in line. Figure 3 . CLEANING After Each Use ● Remove large debris such as clumps of dirt, grass,crop re...
Page 11 - A s s e m b l y; ASSEMBLY; Center Belt Shield Bracket & Pivot Pipe
A s s e m b l y 11 29927 (Rev. 3/14/2008) ASSEMBLY Side Shield (See page 16) Attach side shields (39 & 48) to mower with 3/8 x 1"bolts and lock nuts. A side discharge chute (48) may beinstalled on right end of mower in place of side shield(30). Center Belt Shield Bracket & Pivot Pipe (Se...
Page 12 - Shielding
1 2 A s s e m b l y 29927 (Rev. 3/14/2008) Figure 5 . Then thread it back across the front of the centersheave in the top groove. Figure 6 . Proper Twist: The belt then follows with a 3/4 twist back under the left V-idler, up over the drive sheaveand back down under the right idler pulley. This will...
Page 13 - A ss e mb l y
A ss e mb l y 1 3 29927 (Rev. 3/14/2008) Figure 7 . 59-C-2 Idler Bracket
Page 15 - DEALER CHECK LISTS; PRE-DELIVERY CHECK LIST; DELIVERY CHECK
A ss e mb l y 1 5 29927 (Rev. 3/14/2008) LEAF MULCHER (OPTIONAL) Turn mower upside down on saw horses. If mower hasa bolt-on front shield, adjust shield all the way down inlong slots. Remove side shields. Leave side skids on. Ifoptional front roller has been installed, it must beremoved. On mowers w...
Page 16 - P a r ts
1 6 P a r ts 29927 (Rev. 6/22/2007) 59C-2 Main Assembly
Page 21 - Lift Chain Hook-Up Table; Special Notes
P a r ts 2 1 29927 (Rev. 6/22/2007) Lift Chain Hook-Up Table Special Notes (Refer to numbers in parentheses in above table) 1. Hook one 13-link chain between holes “C” & “D”. 2. Fasten one 10-link and one 7-link chain together. 3. Hook lower end of spring in crotch chain. 4. Hook spring into cha...
Page 22 - Manual Height Adjustment
2 2 P a r ts 29927 (Rev. 6/22/2007) Manual Height Adjustment
Page 24 - Spindle Assembly
2 4 P a r ts 29927 (Rev. 6/22/2007) Spindle Assembly REF PART QTY DESCRIPTION 1 4116 1 Spindle 2 5089 2 Seal 3 4114 1 Sleeve 4 4115 1 Pin 5 4107 2 Bearing cone 6 4117 1 Housing with cups 7 4106 2 Bearing cup 8 1972 1 Grease fitting 9 4105 1 Spindle shaft 10 4110 1 Shoulder washer 11 12170KT 1 16-13/...
Page 25 - A p p e n d i x; BOLT TORQUE CHART
A p p e n d i x 2 5 Bolt Torque & Size Charts (Rev. 3/28/2007) BOLT TORQUE CHART Always tighten hardware to these values unless a different torque value or tightening procedure is listed for a specific application. Fasteners must always be replaced with the same grade as specified in the manual ...
Page 26 - BOLT SIZE CHART; SAE Bolt Thread Sizes; MM
2 6 A p p e n d i x Bolt Torque & Size Charts (Rev. 3/28/2007) BOLT SIZE CHART NOTE: Chart shows bolt thread sizes and corresponding head (wrench) sizes for standard SAE and metric bolts. ABBREVIATIONS AG .............................................................. Agriculture ASABE .............
Page 27 - WARRANTY
F-3079 (Rev. 6/1/2007) WARRANTY (All Models Except Mow’n Machine TM Zero-Turn Mowers and Woods Boundary TM Utility Vehicles) Please Enter Information Below and Save for Future Reference. Date Purchased: ____________________________ From (Dealer): ___________________________________________ Model Num...
Page 28 - (Replacement Parts For All Models Except Mow’n Machine
F-8494 (Rev. 6/23/2005) Woods Equipment Company 2606 South Illinois Route 2 Post Office Box 1000Oregon, Illinois 61061 800-319-6637 tel800-399-6637 faxwww.WoodsEquipment.com ©2007 Woods Equipment Company. All rights reserved. WOODS, the Woods logo, and "Tested. Proven. Unbeatable." are trade...
