Page 2 - I n t r o d u c t i o n; DANGER
2 I n t r o d u c t i o n SFMK (Rev. 6/6/2005) TO THE DEALER: Assembly and proper installation of this product is the responsibility of the Woods ® dealer. Read manual instructions and safety rules. Make sure all items on the Dealer’s Pre-Delivery and Delivery Check Lists in the Operator’s Manualare...
Page 3 - S a f e t y; SAFETY RULES; Si no lee Ingles, pida ayuda a
S a f e t y 3 4-Point SFMK (Rev. 7/8/2005) SAFETY RULES ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! This Sub-Frame Mounting Kit is only for the backhoes and tractors specified in the Sub-FrameM o u n t I n s ta l l a t i o n s e c t i o n o f t h i s m a n u a l . A n yother use or modificat...
Page 5 - I n s ta l l a t i o n; BACKHOE SUB-FRAME INSTALLATION; Tractor Preparation; WARNING
I n s ta l l a t i o n 5 MAN0131 (Rev. 12/23/2005) BACKHOE SUB-FRAME INSTALLATION Tractor Preparation ■ Only use 1002899 Sub-Frame Mounting Kit for mounting Woods BH6500 Backhoes on CubCadet ® 7000, 7192, 7194, 7195, 7200, 7205 tractors and Mahindra 2015 tractors equipped with Woods1006, Cub Cadet 4...
Page 6 - Install Rear Mounting Bracket; Install Front Mount
6 I n s ta l l a t i o n MAN0131 (Rev. 12/23/2005) Install Rear Mounting Bracket Refer to Figure 2. 1. Position rear mounting bracket (2) on tractor axlehousings (D). 2. Install cap screws (9) and hardened flat washers(8) in top two holes of mounting bracket (2) asshown. 3. Install cap screws (A) an...
Page 7 - Attach Sub-Frame to Backhoe
I n s ta l l a t i o n 7 MAN0131 (Rev. 12/23/2005) Sub-Frame Fit-Up Refer to Figure 4. 1. Center sub-frame under tractor. 2. Insert cross tube of sub-frame into channel of rearmount bracket (2). 3. Secure in place with clevis pins (6) and klik pin(7). 4. Pivot front end of sub-frame up into front mo...
Page 8 - HYDRAULIC INSTALLATION; Install Pump Kit
8 I n s ta l l a t i o n MAN0131 (Rev. 12/23/2005) HYDRAULIC INSTALLATION Keep hands and body away from pressurized lines. Use paper or cardboard, not hands or otherbody parts to check for leaks. Wear safety goggles.Hydraulic fluid under pressure can easily penetrateskin and will cause serious inj...
Page 9 - Install Hoses to Backhoe Valve
I n s ta l l a t i o n 9 MAN0131 (Rev. 12/23/2005) 1002898 HOSE KIT INSTALLATION Completion of this hose kit requires connection to the tractor hydraulic manifold andloader control valve. Shut off engine and lock parking brake before installing hose kit. Check all parts inhose kit against packing li...
Page 10 - Install Hydraulic Fittings; Backhoe Hose Connection
1 0 I n s ta l l a t i o n MAN0131 (Rev. 12/23/2005) WOODS 1006 LOADER Install Hydraulic Fittings Use thread sealant on pipe threads. Be careful not touse excess sealant that could enter hydraulic system. NOTE: Some fittings in hose kit will not be used for this installation. 1. Remove male quick co...
Page 11 - MAHINDRA ML104 LOADER
I n s ta l l a t i o n 11 MAN0131 (Rev. 12/23/2005) MAHINDRA ML104 LOADER Install Hydraulic Fittings Use thread sealant on pipe threads. Be careful not touse excess sealant that could enter hydraulic system. NOTE: Some fittings in hose kit will not be used for this installation. 1. Disconnect loader...
Page 12 - Remove Hydraulic Fittings
1 2 I n s ta l l a t i o n MAN0131 (Rev. 12/23/2005) CUB CADET 475 LOADER Remove Hydraulic Fittings Use thread sealant on pipe threads. Be careful not touse excess sealant that could enter hydraulic system. NOTE: Some fittings in hose kit will not be used for this installation. 1. Remove female quic...
Page 13 - Install PBY Tube Assembly
I n s ta l l a t i o n 1 3 MAN0131 (Rev. 12/23/2005) Install PBY Tube Assembly 1. Remove slug on right side of backhoe console. 2. Remove plug from PBY port on right side of back-hoe valve. 3. Install Power Beyond sleeve (10), straight con-nector (12), and tube assembly (11) on the side ofthe backho...
Page 14 - Backhoe and Loader Hose Connections
1 4 I n s ta l l a t i o n MAN0131 (Rev. 12/23/2005) Backhoe and Loader Hose Connections 1. Attach hose (A) from the loader valve OUT port tofemale quick coupler (2) in the front of tee (5). 2. Connect hose (B) from the loader valve PBY portto male quick coupler in the PBY port (N) on thehydraulic m...
Page 15 - Hydraulic System Check List
I n s ta l l a t i o n 1 5 MAN0131 (Rev. 12/23/2005) Mount Sub-Frame & Backhoe to Tractor This mounting kit is designed to provide sec ure mounting and a de qua te operator clea r-ance when properly installed. Check clearancedi me n s io ns s ho wn b el o w to be s ure y ou h a v einstalled se...
Page 16 - Remove Backhoe With Sub-Frame; Store Hydraulic Pump if Equipped
1 6 I n s ta l l a t i o n MAN0131 (Rev. 12/23/2005) Remove Backhoe With Sub-Frame The only time the backhoe may be operated from a position other than the operator seat i sduring backhoe attachment and removal. Opera-tor must: • Read Mounting Kit Manual instructions on a t ta c h i n g a n d r e ...
Page 17 - P a rts
P a rts 1 7 MAN0131 (Rev. 12/23/2005) 1002899 SUB-FRAME MOUNTING KIT 14 15 13 10 11 12 9 8 7 6 5 3 4 2 1 3 17 11 19 18 16 20 10 For MahindraML104 Loader Mount CD5017B Serial Number Plate Located inside sub-frame side rail, rear of cross tub e MODEL NO. SERIAL NO. MASS (KG) ID NO. OREGON, IL U.S.A. Y...
Page 19 - A p p e n d i x; BOLT TORQUE CHART
A p p e n d i x 1 9 Bolt Torque & Size Charts (Rev. 10/10/2005) BOLT TORQUE CHART Always tighten hardware to these values unless a different torque value or tightening procedure is listed for a specific application.Fasteners must always be replaced with the same grade as specified in the manual ...
Page 20 - BOLT SIZE CHART; SAE Bolt Thread Sizes; MM
2 0 A p p e n d i x Bolt Torque & Size Charts (Rev. 10/10/2005) BOLT SIZE CHART NOTE: Chart shows bolt thread sizes and corresponding head (wrench) sizes for standard SAE and metric bolts. ABBREVIATIONS AG ............................................................ Agriculture ATF ................
Page 21 - WARRANTY
F-3079 (Rev. 9/21/2005) Woods Equipment Company 2606 South Illinois Route 2 Post Office Box 1000Oregon, Illinois 61061 815-732-2141 tel815-732-7580 faxwww.WoodsEquipment.com WARRANTY (All Models Except Mow’n Machine TM Zero-Turn Mowers and Woods Boundary TM Utility Vehicles) Please Enter Information...
Page 22 - (Replacement Parts For All Models Except Mow’n Machine
F-8494 (Rev. 6/23/2005) Woods Equipment Company 2606 South Illinois Route 2 Post Office Box 1000Oregon, Illinois 61061 815-732-2141 tel815-732-7580 faxwww.WoodsEquipment.com ©2001 Woods Equipment Company. All rights reserved. WOODS, the Woods logo, and "Tested. Proven. Unbeatable." are trade...
