Winegard RD-9046 - Manual

WINEGARD

®

46 cm Portable Satellite System

Models RD-9046 / RD-9146

UNPACKING/ASSEMBLY

After unpacking the system, verify that you have a level,
compass (attached to base), and 25 feet of coax. If you
do not, call Winegard Company at 1-800-288-8094
between the hours of 8:00 a.m. and 4:00 p.m. central
time, Monday through Friday.

SAVE THE CARTON. This carton is designed to be
reused to store your system in when not in use.

Signal from satellite

24° look angle

Antenna Reflector at 90°

ANTENNA/MOUNT

MADE IN U.S.A.

U.S. Patents 5,532,710

& 5,646,638

OPERATION

STEP 1.

Connect coax from LNBF to receiver. If

additional cable length is required, use a high grade RG-
6/U type foam cable suitable for satellite signal and an
FS-8100 cable splice.

STEP 2.

Plug in the receiver and TV.

STEP 3.

Turn TV and receiver ON.

STEP 4.

Tune TV to ch. 3 or 4 (to the same channel as

the output on the receiver.)

STEP 5.

Determine azimuth (direction) and elevation

required for your position. Refer to receiver manual.

STEP 6.

Loosen clamp knobs. Elevate reflector to the

correct elevation. Align degree of elevation required
with

front of the slide bracket.

Each mark indicates 5

degrees of elevation with the first mark being 0

0

(mark

closest to compass/level). See Figures 1 and 2. Tighten
clamp knobs.

STEP 7.

Level base using bubble level recessed into

the base.

STEP 8.

Using compass recessed into base, rotate the

base

slowly

(3

o

increments) to the desired azimuth

(direction) for the high power satellites. The signal is
digital, you must wait a few seconds after each move to
allow the receiver to process the signal.

NOTE: Disregard the compass markings, the red
compass needle

always points North

. Rotate the

base so that the other end of the needle points at the
correct heading (direction) on the antenna base. DO
NOT USE THE DEGREE MARKINGS ON THE
COMPASS.

NOTE: If you have the unit sitting on a tailgate or on
other metal items, it is recommended that you remove
the compass from the base and stand away (15' min.)
to find the correct azimuth. Compass is attached to
base with velcro.

STEP 9.

Adjust azimuth (direction) and elevation (up/

down) for strongest signal.

NOTE: If you do not get a picture, check the following:

1. Make sure antenna has clear view of the high

power satellites, no buildings, trees, etc.
blocking the view.

2. Make sure coax connections are good.
3. Check coax for breaks, crimps, cuts etc.
4. If base is not level, you will have to adjust the

elevation to compensate.

5. Check that TV is tuned to correct channel.

CAUTION: DO NOT DROP SYSTEM. IF ANTENNA IS
DAMAGED, IT WILL REDUCE THE GAIN (HOW MUCH
SIGNAL THE ANTENNA SENDS TO THE RECEIVER)
OF THE ANTENNA. THIS CAN RESULT IN A
DEGRADED PICTURE.