Page 2 - MACHINE DATA LOG/OVERVIEW; YOUR DEALER
MACHINE DATA LOG/OVERVIEW WAV 86038510 05/15/07 1 For the name and address of your dealer contact: Windsor Industries YOUR DEALER Name: __________________________________________________________________________________________________ Address: ________________________________________________________...
Page 3 - TABLE OF CONTENTS; OPERATIONS
TABLE OF CONTENTS WAV 86038510 05/15/07 2 Machine Data Log/Overview. ........................1 Table of Contents..........................................2 HOW TO USE THIS MANUAL How to use this Manual.................................1-1 SAFETY Important Safety Instructions ........................2...
Page 4 - HOW TO USE THIS MANUAL; REF –
HOW TO USE THIS MANUAL WAV 86038510 05/15/07 1-1 This manual contains the following sections: - HOW TO USE THIS MANUAL - SAFETY - OPERATIONS - MAINTENANCE - PARTS LIST The HOW TO USE THIS MANUAL section will tell you how to find important information for ordering correct repair parts. Parts may be o...
Page 5 - IMPORTANT SAFETY INSTRUCTIONS; When using an electrical appliance, basic precaution; READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE.; SAVE THESE INSTRUCTIONS
WAV 86038510 05/15/07 2-1 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precaution must always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE. To reduce the risk of fire, electric shock, or injury: Use only indoors. Do not use outdoors...
Page 6 - HAZARD INTENSITY LEVEL; WARNING; WARNING; WARNING; CAUTION
HAZARD INTENSITY LEVEL WAV 86038510 05/15/07 2-2 The following symbols are used throughout this guide as indicated in their descriptions: HAZARD INTENSITY LEVEL There are three levels of hazard intensity identified by signal words - WARNING and CAUTION and FOR SAFETY. The level of hazard intensity i...
Page 7 - GROUNDING INSTRUCTIONS; GROUNDING INSTRUCTIONS:
GROUNDING INSTRUCTIONS WAV 86038510 05/15/07 2-3 THIS PRODUCT IS FOR COMMERCIAL USE ONLY. ELECTRICAL: In the USA this machine operates on a standard 15 amp 115V, 60 hz, A.C. power circuit . The amp, hertz, and voltage are listed on the data label found on each machine. Using voltages above or below ...
Page 8 - CONTROLS
CONTROLS WAV 86038510 05/15/07 3-1 1 Main Handle. Adjusts for operator comfort and storage. 2 Brush on/off lever. Activates brush when depressed. 3 Accessory vacuum hose and wand. Allows operator to clean edges, recessed, ledges, upholstery, etc. 4 Detail tools Dusting brush, crevice and upholstery ...
Page 9 - FILTER/BAG COMPARTMENT; WAVE SET UP
OPERATIONS WAV 86038510 05/15/07 3-2 FILTER/BAG COMPARTMENT WAVE SET UP 1. Take machine out of storage position by lowering onto all four wheels. 2. Adjust handle to comfortable position at waist level by opening adjustment lever on left side of machine and moving handle. Lock back into position by ...
Page 10 - OPERATION; BRUSH POSIT ION; HOW IT OPERATES
OPERATION WAV 86038510 05/15/07 3-3 BRUSH POSIT ION HOW IT OPERATES This machine is a portable, easy to use wide area vacuum designed for use indoors, in a commercial or light industrial environment. When operating as a carpet vacuum, soil is lifted from the carpet surface by a rotating brush and ca...
Page 11 - MAINTENANCE; W A R N I N G
MAINTENANCE WAV 86038510 05/15/07 4-1 NOTE: T HE FOLLOWING SERVICE ITEMS SHOULD BE PERFORMED BY AN AUTHORIZED SERVICE FACILITY OR AUTHORIZED SERVICE PERSONNEL . A LL PARTS REFERRED TO IN THESE INSTRUCTIONS CAN BE IDENTIFIED BY USING THE PARTS LISTS AND ILLUSTRATIONS ON THE FOLLOWING PAGES . REMOVE M...
Page 13 - WIRING DIAGRAM
WIRING DIAGRAM WAV 86038510 05/15/07 4-3 880246 880250 POWER CORD BLK GRN BLK WHT 88349 EXHAUST SCREEN 76149 GROUND POST 87016 57104 880247 57104 BLK 880247 SWITCH MAIN 88220 WHT MOTOR VAC WHT BLK BLK 76070 SWITCH BOX SCREW 880253 GRN BRUSH 3 AMP 880248 BLK C.B. BLK VAC 13 AMP C.B. RED BLK HANDLE 88...
Page 14 - MAINTENANCE DAILY
MAINTENANCE WAV 86038510 05/15/07 4-4 SERVICE SCHEDULE MAINTENANCE DAILY WEEKLY MONTHLY QUARTERLY Check bag and replace if necessary * Check filters and replace if necessary * Check hoses for wear, blockages, or damage * Inspect base for clogs * Check swivel neck for clogs; remove clogs with fingers...
Page 15 - THIS PAGE LEFT BLANK INTENTIONALLY
WAV 86038510 05/15/07 4-5 THIS PAGE LEFT BLANK INTENTIONALLY
Page 16 - BRUSH AND DRIVE GROUP
BRUSH AND DRIVE GROUP WAV 86038510 04/08/08 5-1 BRUSH DRIVE MOTOR ASSEMBLY Vacuum Door Assembly 16 15 25 26 27 5 3 12 6 9 7 4 11 12 28 18 43 44 42 41 38 40 39 37 38 19 21 20 2122 10 3022 36 2 35 34 VACUUM DOOR ASSEMBLY 18 33 33 18 8 22 21 45 17 13 32 31 14 24 A,B BRUSH SET BRUSH DRIVE MOTOR ASSEMBLY...
Page 17 - BRUSH AND DRIVE GROUP PARTS LIST
BRUSH AND DRIVE GROUP PARTS LIST WAV 86038510 10/23/08 5-2 REF PART NO. PRV NO. QTY DESCRIPTION SERIAL NO. FROM NOTES: 1 86031700 14384 1 BODY, WAV 2 86011010 89199 1 WELDMENT, HOSE CONNECT 3 86229050 14342 2 BEARING BLOCK 4 86008210 73998 2 SPACER, .75OD X .5ID X .5L 5 86000900 09019 2 BEARING, 1.1...
Page 18 - BRUSH HEIGHT AND WHEEL GROUP
BRUSH HEIGHT AND WHEEL GROUP WAV 86038510 07/24/07 5-3 MAIN FRAME ASSEMBLY 4 8 14 10 6 22 20 20 24 21 19 16 5 23 24 12 7 17 24 3 21 19 9 1 2 19 15 18 11 13
Page 19 - BRUSH HEIGHT AND WHEEL GROUP PARTS LIST
BRUSH HEIGHT AND WHEEL GROUP PARTS LIST WAV 86038510 07/24/07 5-4 REF PART NO. PRV NO. QTY DESCRIPTION SERIAL NO. FROM NOTES: 1 86005860 57273 1 NUT, 1/4-20 X 12MM HEX BARREL 2 86008200 73996 1 SPACER, .50OD X .37ID X .44L SS 3 86006660 70190 1 SCR, 1/4-20 X 1/2 BHCS DL 4 86008750 80673 1 KNOB, WITH...
Page 20 - VACUUM GROUP
VACUUM GROUP WAV 86038510 05/15/07 5-5 6 5 1413 4 9 10 7A, 7B (BRUSH SET) 17 8 11 15 16 12 1 2 3
Page 21 - VACUUM GROUP PARTS LIST
VACUUM GROUP PARTS LIST WAV 86038510 05/15/07 5-6 REF PART NO. PRV NO. QTY DESCRIPTION SERIAL NO. FROM NOTES: 1 86276040 70586 5 SCR, 1/4-20 X 3/4 BLK PPHTC 2 86064180 36185 1 GUARD, BELT 3 86010650 87018 4 WASHER, #10 X 9/16 OD 4 86068760 140196 2 BRKT, VAC MOTOR MOUNTING 5 86215090 140949 2 BAG, P...
Page 22 - HANDLE GROUP
HANDLE GROUP WAV 86038510 05/15/07 5-7 23 31 29 5 21 32 34 27 25 33 3 4 24 HANDLE ASSEMBLY - DETAIL - 19 22 27 9 14 28 20 11 35 36 18 10 26 17 30 13 12 8 15 16 6 7 28 27 1 HANDLE ASSEMBLY 2 37
Page 23 - HANDLE GROUP PARTS LIST
HANDLE GROUP PARTS LIST WAV 86038510 01/10/09 5-8 REF PART NO. PRV NO. QTY DESCRIPTION SERIAL NO. FROM NOTES: 1 86274640 70253 1 SCR, 10-32 X 1.25 PPHMS 2 86076510 38272 1 HANDLE, MAIN 3 86268300 88231 1 WIRE, 6" GRN/18 76008 X 76011 4 86091470 140309 1 BAR ASM, BRUSH SWITCH 5 86069190 140310 1 ...
Page 25 - LID/DECAL GROUP PARTS LIST
LID/DECAL GROUP PARTS LIST WAV 86038510 05/15/07 5-10 REF PART NO. PRV NO. QTY DESCRIPTION SERIAL NO. FROM NOTES: 1 86003780 35171 1 GASKET, ACCESSORY PORT 2 86234760 27674 1 COVER, ACCESSORY PORT 3 86006500 70024 2 SCR, #8 X 1/2 SHT METAL SS 4 86031930 51335 1 LID, WAV 5 86237590 35207 2 GASKET, FO...
Page 26 - ELECTRICAL PANEL AND COVER GROUP
ELECTRICAL PANEL AND COVER GROUP WAV 86038510 05/15/07 5-11 1 2 3 4 5 4 18 7 10 11 12 13 14 16 17 19 15 NUTS SUPPLIED WITH CIRCUIT BREAKER NUT SUPPLIED WITH SWITCH 6
Page 27 - ELECTRICAL PANEL & COVER GROUP PARTS LIST
ELECTRICAL PANEL & COVER GROUP PARTS LIST WAV 86038510 05/15/07 5-12 REF PART NO. PRV NO. QTY DESCRIPTION SERIAL NO. FROM NOTES: 1 86234300 23672 1 CORD ASM, 115V 2 86279220 87104 1 WASHER, 1/2 EXT. STAR 3 86261560 880250 1 WIRE ASM, MAIN SWITCH/BREAKER 4 86005670 57040 2 NUT, 1/2 NPT CONDUIT 5 ...
Page 28 - SUGGESTED SPARE PARTS
SUGGESTED SPARE PARTS WAV 86038510 05/15/07 5-13 PART NO. PRV NO. DESCRIPTION SERIAL NO. FROM NOTES: 86001090 11041 BELT, 220 J-6 POLY-V 86215090 140949 BAGS, PAPER (PKG. OF 10) 86003510 34012 FILTER, VAC MOTOR 86236040 34309 FILTER, EXHAUST 86001200 140164 BAG, CLOTH 86135260 140211 BRUSH SET, VAC ...
