Windsor 10052350 - Manuals

SCEX364 86037160 03/12/07 2-1 IMPORTANT SAFETY INSTRUCTIONS When using an battery powered appliance, basic precaution must always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE. To reduce the risk of fire, electric shock, or injury: Use only indoors. Do not use...

HAZARD INTENSITY LEVEL SCEX364 86037160 03/12/07 2-2 The following symbols are used throughout this guide as indicated in their descriptions: HAZARD INTENSITY LEVEL There are three levels of hazard intensity identified by signal words - WARNING and CAUTION and FOR SAFETY. The level of hazard intensi...

SAFETY LABEL LOCATION SCEX364 86037160 03/12/07 2-3 NOTE: These drawings indicate the location of safety labels on the machine. If at any time the labels become illegible, promptly replace them. CIRCUIT BREAKER DECAL 86243530 PRV NO. 500565 2% GRADE WARNING SEE MANUAL BATTERY CAUTION 86252520 PRV NO...

TECHNICAL SPECIFICATIONS SCEX364 86037160 03/12/07 3-1 ITEM DIMENSION/CAPACITY Nominal power 1440 Watts Rated Voltage 24VDC Rated Amperage 60 Amps Batteries 4 X 6 Volt 250-305-335AH @ 20 hr rate Scrub Brush Motors .33 hp (0.25 Kw) Vacuum Motor .75 hp (0.56 Kw) Propelling Motor .3 hp (0.22 Kw) Mass (...

TECHNICAL SPECIFICATIONS SCEX364 86037160 03/12/07 3-2 ITEM MEASURE Height 45 in. (114 cm) Length with 36 in. (90 cm) scrub head 72 in. (183 cm) Width without squeegee and scrub head 24 in. (61 cm) Width of squeegee for 36 in. (90 cm) scrub head 35 in. (89 cm) Width of scrub path for 36 in. (90 cm) ...

HOW THE MACHINE WORKS SCEX364 86037160 03/12/07 3-3 The Saber Cutter is a battery powered, self-propelled, hard floor scrubber intended for commercial use. The appliance applies a cleaning solution onto a hard floor, scrubs the floor with brushes, and then vacuums the soiled water back into the reco...

COMPONENTS SCEX364 86037160 03/12/07 3-4 1. Control Panel 2. Front Cover 3. Recovery Tank 4. Recovery Tank Drain Hose 5. Scrub Head Fixed 6. Solution Tank 7. Solution Tank Cover 8. Solution Tank Drain Hose 9. Solution Strainer 10. Rear Squeegee 11. Top Cover 12. Vacuum Motor 13. Recovery Tank Dome 1...

CONTROLS SCEX364 86037160 03/12/07 3-5 4 10 11 12 14 15 8 7 6 3 13 16 1 9 5 2 17

CONTROLS SCEX364 86037160 03/12/07 3-8 13. BATTERY CHARGE LEVEL INDICATOR Indicates the charge level of the batteries. The meter display is divided into 10 vertical bars. Bar illuminated on the far right indicate full charge. Bars flashing near the left side indicate the batteries should be recharge...

MACHINE OPERATION SCEX364 86037160 03/12/07 3-9 PRE-RUN MACHINE INSPECTION Do a pre-run inspection to find possible problems that could cause poor performance or lost time from breakdown. Follow the same procedure each time to avoid missing steps. NOTE: See maintenance section for pre-run machine in...

MACHINE OPERATION SCEX364 86037160 03/12/07 3-10 NORMAL SCRUBBING Plan the scrubbing pattern in advance. The longest track is around the perimeter of the area to be cleaned. For efficient operation, the runs should be the longest possible without turning, stopping, or raising and lowering scrub deck...

MACHINE OPERATION SCEX364 86037160 03/12/07 3-11 DOUBLE SCRUB For floors which are heavily soiled or have thick accumulations of floor finish may not clean sufficiently with one pass. In these cases it will be necessary to double scrub. To double scrub, make the first pass over the surface being cle...

MAINTENANCE SCEX364 86037160 03/12/07 4-1 SERVICE SCHEDULE MAINTENANCE DAILY WEEKLY MONTHLY 100 HRS 200 HRS Check batteries after charging; add water if necessary * Check pad wear to prevent buildup of chemicals * Check linkages and connectors for wear and damage * Check hoses for wear, blockages, o...

MAINTENANCE SCEX364 86037160 03/12/07 4-4 CHECKING BATTERY SPECIFIC GRAVITY Use a hydrometer to check the battery specific gravity. CHECKING GRAVITY A. Hydrometer B. Battery NOTE: Do not take readings immediately after adding distilled water, if the water and acid are not thoroughly mixed, the readi...

MAINTENANCE SCEX364 86037160 03/12/07 4-5 Batteries emit hydrogen gas. Explosion or fire can result. Keep sparks and open flame away. Keep covers open when charging. 4. Check the electrolyte level in each battery cell. Before charging, add just enough distilled water to cover the plates. After charg...

MAINTENANCE SCEX364 86037160 03/12/07 4-6 2. REAR SQUEEGEE The front blade allows solution to pass through channels in the blade into the squeegee assembly while maintaining vacuum to provide lift. The front blade has four wear surfaces and can be rotated for extended life. The front blade should no...

MAINTENANCE SCEX364 86037160 03/12/07 4-7 TO ADJUST SQUEEGEE PITCH 1. Choose a smooth, level surface. Turn “ON” the key switch. Lower the squeegee and drive forward at least 2 feet (60cm.). 2. With the squeegee down, stop the machine. Do not allow machine to roll back. FOR SAFETY: Before leaving or ...

MAINTENANCE SCEX364 86037160 03/12/07 4-8 3. SCRUB BRUSHES There are four different types of brushes available to cover applications from cleaning heavily soiled floors to polishing. A pad driver is also available to take advantage of the many cleaning pads on the market. Please refer to the followi...

MAINTENANCE SCEX364 86037160 03/12/07 4-9 ! WARNING 5. SOLUTION STRAINER The solution strainer is located in front of the left front wheel. The solution strainer protects the solenoid valve from debris. If there is little or no solution flow to the ground, check the strainer for debris. Drain the so...

MAINTENANCE SCEX364 86037160 03/12/07 4-10 ! WARNING 7. TRACTION MOTOR Do not use a pressure washer to clean around the motors. Use tap pressure only. TRACTION MOTOR CARBON BRUSH REPLACEMENT FOR SAFETY: Before leaving or servicing machine, stop on a level surface, turn off machine and remove key. 1....

MAINTENANCE SCEX364 86037160 03/12/07 4-11 10. VACUUM MOTOR (Refer to the Vacuum Group in the parts section of manual) Do not use a pressure washer to clean around the vacuum motors. Use tap pressure only. Care must be taken so that water is not directed into vacuum motor air intakes. CHANGING VACUU...

MAINTENANCE SCEX364 86037160 03/12/07 4-12 11. ACTUATOR SCRUB DECK UP-DOWN REMOVAL/REPLACEMENT FOR SAFETY: Before leaving or servicing machine, stop on a level surface, turn off machine and set parking brake (If option is installed). 1. Remove front cover. 2. Remove clevis pin and rue ring from lowe...

MAINTENANCE SCEX364 86037160 03/12/07 4-15 RECOMMENDED GREASING: 1-2 strokes of Mobiltemp ® 78 or compatible clay- based or calcium-based grease.

MACHINE TROUBLESHOOTING SCEX364 86037160 03/12/07 4-16 PROBLEM CAUSE SOLUTION Poor or no water pick-up on either squeegee Squeegee out of adjustment Adjust squeegee Debris caught on squeegee Remove debris Worn squeegee blades Rotate or replace squeegee blades Vacuum hose clogged Clear obstruction fr...