Windsor PTC20 - Manual - manualsarea.com

Page 2 - Operator Safety Instructions; or

Operator Safety Instructions Read the instruction manual before operating this machine. Operate this machine only from the rear of machine. Use caution when operating the machine on a ramp or incline. Do not turn or leave this machine unattended on a ramp or incline. Machine can cause an explosion w...

Page 3 - “ON”

‘ I SQUEEGEE SOLUTION MAIN BATTERY SOLUTION VACUUM BRUSH SCRUB LEVER CONTROL SWITCH “ON” “ON” LIGHTED “ON” LIGHTED LIFT LEVER LEVER LIGHT LIGHT SWITCH SWITCH OPERATOR CONTROL HANDLE 1. Raises and lowers squeegee assembly. 2. Controls flow of cleaning solution t o floor. 3. Controls electric power t ...

Page 4 - SO; NOTE; HFT; WORK; NOTE

MACHINE PREPARATION BATTERIES 1. Install batteries and connect battery cables as shown. WARNING: Provide proper ventilation, leave door open when charging batteries. 2. Charge the batteries before using the machine. (See Battery Charging ced re) PAD ASSEMBLY 1. Raise scrub deck assembly by raising c...

Page 5 - BATTERY MAINTENANCE; TERMINAL CLEANER; SERVICING THE; PUMP; ASSEMBLY; SQUEEGEE ASSEMBLY

3. Connect the “DC” charger plug t o the connector on the machine. NOTE A safety override s w i t c h i s a c t i v a t e d when the “ D C charge plug is connected. This prevents all panel circuits on the m a c h i n e f r o m a c c i d e n t a l l y b e i n g switched on during charging cycle. 4. C...

Page 6 - SCRUB; MOTOR; Position; Brush Motor; Windsor Industries warrants that the; b y; this warranty i s free from; SOLUTION STRAINER; loss

SCRUB MOTOR 1. Remove (4) screws h o l d i n g m o t o r shroud. Squeegee tracking can be controlled t e n s i o n of squeegee springs. : Position recovery hose as shown before making adjustments. 2. Remove batteries and squeegee as- sembly. Lay machine on side. 3. Remove center screw holding drive ...

Page 7 - FRAME

TANKS, VAC FRAME 27 39 TANKS, VAC FRAME KEY PART NO. DESCRIPTION 1 70020 Scr, 1/4-20 x HHMS 2 61181 Panel, Rear 3 87090 Washer, 1 / 4 Flat 4 70010 Scr, 1/4-20 x 1.5 HHCS 5 34188 Frame, Main 7 18027 Caster 8 70266 Scr, 1 HHCS 9 70327 Scr, 1/4-20 x 3/8 THMS 10 27266 Cap, Wheel Hub 11 09010 Bearing, Ca...

Page 8 - SCRUB DECK

Page 9 - BATTERY COMPARTMENT; DECK; B A T T E R Y C O M P A R T M E N T

PARTNO. DESCRIPTION 73425 Strap Asm, Bumper 73465 Strap Asm, Bumper 2 87090 Washer, 1 / 4 ID x Flat 3 48012 Knob, Adjustment 4A 14676 Bumper, Brush Shroud 14571 Bumper, Brush Shroud I 5A 02162 Pad Driver, 16" Ylw Pad Lock 02156 Pad Driver 16" Weighted 02098 Pad Driver, 18" Blk Pad Lock 0...

Page 10 - ELECTRICAL CONTROLS

Page 11 - MECHANICAL CONTROLS

MECHANICAL CONTROLS 34 - 3 I 13 41 I . 30 24 2 2 32 I MECHANICAL CONTROLS PARTNO. DESCRIPTION PART NO. DESCRIPTION DESCRIPTION 1 29151 Door. Battery Compartment 15 27460 Cable, Squeegee 30 67224 Rod, Handle Adjust 2 66068 Pin, x Roll 16 70298 Shoulder Bolt, 5/16 OD x L 31 51142 Handle Clamp 3 67226 ...

Page 12 - F r a m e; Snap; Wheel; Star; SQUEEGEE

SQUEEGEE SQUEEOEE LIFT MECHANISM F r a m e I - F r a m e 4 KEY P A R T NO. OESCRIPTION 1 67103 Ring, 5/16 Snap 2 87029 Washer, 5/16 Flat 3 89058 Wheel, Squeegee Roller 4 66108 Squeegee Wheel 5 57112 Nut, 5/16-18 Flange 6 14482 Brkt, Squeegee Wheel 7 70011 Scr, 1/4-20 x 5 / 8 HHMS 8 87025 Washer, Sta...

Page 13 - A U X I L I A R Y PUMP MODEL; PLUMBING; S T A N D A R D MODEL

A U X I L I A R Y PUMP MODEL 3 2 0 28 PLUMBING 27 S T A N D A R D MODEL Note: Plumbing i I trated with machine laying on right side. 6 I 13

Page 14 - TROUBLE-SHOOTING GUIDE; PROBLEM; Vacuum motor

TROUBLE-SHOOTING GUIDE PROBLEM PROBABLE CAUSE CORRECTIVE ACTION No power. Battery cables corroded at battery terminals. Faulty main switch. Faulty safety override switch. 1. Clean battery cable clamps and battery terminals. 2. Check voltage at points A and B. Voltage should be 22/26 VDC. 1. Check vo...

Page 15 - Pump; Pump Repair; Plug; Housing; Cover

POWER SOLUTION SOLUTION LIGHT BATTERY LEVEL SWITCH SWITCH LIGHT SWITCH WIRING DIAGRAM VACUUM MOTOR PUMP SWITCH CHARGER CONNECTION I PUMP MOTOR (OPTIONAL) PUMP Pump Assembly 65019 I Pump Repair K i t 47020 Pump Motor 53188 I I I Plug 66017 Housing 41010 Cover Base - 62053 15

Windsor PTC20 - Manual

Table of Contents:

Summary

Other Windsor Models