White Rodgers 1F90-60 - Manual
White Rodgers 1F90-60 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – SPECIFICATIONS; Operating Ambient Temperature Range:; NEW INSTALLATION; SELECT THERMOSTAT LOCATION; Locate thermostat about 5 ft. above the floor.; ROUTE WIRES TO LOCATION; INSTALLATION; Figure 1. Routing Thermostat Wires
- Page 3 – REPLACEMENT INSTALLATION; REMOVE OLD THERMOSTAT; Move subbase out of the way. Drill mounting holes.; MV; NOTE
- Page 4 – Figure 5. Typical Wiring Diagram for Millivolt Systems; ATTACH THERMOSTAT TO SUBBASE; CAUTION; Figure 7. Attaching thermostat to subbase
- Page 5 – SYSTEM CONFIGURATION; ENERGY MANAGEMENT RECOVERY; CHECK THERMOSTAT OPERATION; HEATING SYSTEM; Press; TROUBLESHOOTING; Figure 8. Back of Thermostat
- Page 6 – WARRANTY INFORMATION; WARRANTY INFORMATION FOR CONSUMERS
PART NO. 37-5109A
9151
Operator: Save these instructions for future use!
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY
BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE
PERSONAL INJURY AND/OR PROPERTY DAMAGE.
DESCRIPTION
This wall-mounted, low voltage thermostat maintains
room temperature by controlling the operation of heating
systems. The user may program up to four time/tempera-
ture settings per 24 hour period. The thermostat stores
independent heating programs for 5-day (weekday) and
2-day (weekend) periods. Three "AA" Energizer
®
batter-
ies will maintain the stored program for approximately
one year, if incoming power should fail. If power failure is
extensive and the program is lost, after power restoration,
the thermostat will automatically maintain a factory
preprogrammed heating temperature of 64
°
F.
WHITE-RODGERS DIVISION
EMERSON ELECTRIC CO.
9797 REAVIS ROAD
ST. LOUIS, MISSOURI 63123-5329
Printed in U.S.A.
PRECAUTIONS
If in doubt about whether your wiring is millivolt, line, or low
voltage, have it inspected by a qualified heating and air
conditioning contractor, electrician, or someone familiar
with basic electricity and wiring.
R
WHITE-RODGERS
Do not exceed the specification ratings.
All wiring must conform to local and national electrical
codes and ordinances.
This control is a precision instrument, and should be
handled carefully. Rough handling or distorting compo-
nents could cause the control to malfunction.
To prevent electrical shock and/or equipment
damage, disconnect electric power to system, at
main fuse or circuit breaker box, until installation
is complete.
Do not use on circuits exceeding specified volt-
age. Higher voltage will damage control and
could cause shock or fire hazard.
Do not short out terminals on gas valve or pri-
mary control to test. Short or incorrect wiring will
burn out thermostat and could cause personal
injury and/or property damage.
CAUTION
!
WARNING
!
1F90-60
5-Day/2-Day Electronic Digital Thermostat (for
Heating Only Systems)
INSTALLATION INSTRUCTIONS
CONTENTS
Description ......................................................... 1
Precautions ........................................................ 1
Specifications ..................................................... 2
Installation .......................................................... 2
New Installation
Select Thermostat Location
Route Wires to Location
Replacement Installation
Remove Old Thermostat
Attach Subbase to Wall
Attach Thermostat to Subbase
Operation ........................................................... 5
System Configuration
Energy Management Recovery (EMR)
Check Thermostat Operation
Heating System
Troubleshooting
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 SPECIFICATIONS ELECTRICAL DATAElectrical Rating: 17 to 30vAC 50/60 Hz.0.05 to 1.5 Amps1.5 Amps Maximum Total Load (All terminals combined) Anticipation: Heating 2 to 40 (Reference Values) THERMAL DATASetpoint Temperature Range: 40 ° F to 99 ° F (4 ° C to 37 ° C) Operating Ambient Temperature Range...
3 REPLACEMENT INSTALLATION REMOVE OLD THERMOSTAT 1. Shut off electricity at the main fuse box until installa-tion is complete. Verify power is off with a voltmeter. 2. Remove the front cover of the old thermostat. Withwires still attached, remove wall plate from the wall. 3. If the old thermostat ha...
4 RH MV THERMOSTAT SYSTEM W Figure 5. Typical Wiring Diagram for Millivolt Systems 6 Millivolt System 6 MV W RH Thermostat Terminal Connections From millivolt system W From millivolt system MV ATTACH THERMOSTAT TO SUBBASE POWER TO THERMOSTAT MUST BE OFF BE-FORE ATTACHING THERMOSTAT TO WALL.FAILURE T...
