WEN 61783 - User Manual

AIR SUPPLY SAFETY 1. USE ONLY CLEAN, DRY, AND REGULATED AIR. Condensation from an air compressor can rust and damage the internal workings of the tool. Regularly drain water and contaminants out from the compressor. An in-line filter is recommended to remove most of these contaminants and prolong th...

TOOL OPERATION & MAINTENANCE SAFETY 1. DO NOT FORCE THE TOOL to do a job for which it was not designed. 2. INSPECT TOOL BEFORE USE. Do not operate if any portion of the tool, trigger, or safety bracket is dam-aged, inoperable, disconnected, or altered. Leaking air, damaged parts, or missing part...

KNOW YOUR NAILER Directional ExhaustDeflector Trigger 1/4˝ NPT Air Inlet Magazine Shingle Guide Safety Bracket Depth Setting Wheel Carefully unpack the tool and all accessories from the packaging. Check your tool against the graph below. If any part is damaged or missing, please contact our customer...

Your nailer is designed to operate on dry compressed air at the regulated pressure between 70 and 120 PSI (4.8 and 8.3 bar). Do not operate when the air pressure is outside of the recommended range. The recom-mended air supply setup should include the following: • A pressure regulator - to regulate ...

Air Hose Quick Connector Air Supply Regulator Lubricator Filter PREPARATION & ADJUSTMENTS WARNING: To reduce the risk of misfiring, connect the air supply BEFORE loading fasteners. Make sure the nailer magazine is empty when connecting to the air supply to prevent misfire. Never aim the tip of t...

1. Open the magazine. Pull down the door latch (Fig. 3) and swing door open to the left. Then swing the magazine cover open to the right. 2. Use only the recommended fasteners according to the specifications. STEP 4: LOADING THE FASTENERS (FIG. 3 TO 5) SHINGLE GUIDE (FIG. 6) The shingle guide can be...

DIRECTIONAL EXHAUST DEFLECTOR (FIG. 8) Air will be released from the air outlet during operation. Ro-tate the directional exhaust deflector (Fig. 9) on the top of the nailer to direct the released air to your preferred direc-tion, away from yourself and others. PREPARATION & ADJUSTMENTS Fig. 7 F...

OPERATION Pull the trigger and press down the safety bracket to drive a fastener. Release the safety bracket while hold-ing down on the trigger, reposition the nailer and engage the safety bracket again to drive the next nail. NOTE: Double firing may occur if the safety bracket is engaged between sh...

13 OPERATION CLEARING A JAMMED NAIL WARNING: Disconnect air line from tool and remove all fasteners from magazine before making adjustments or personal injury may result. Keep the tool pointed away from yourself and others. WARNING: If nails continue to jam, stop using the nailer. Contact our custom...

MAINTENANCE LUBRICATION Routine lubrication of the tool is required for best performance. An automatic in-line oiler is recommended. If tool is used without an in-line oiler, place 4 to 5 drops of pneumatic tool oil into the air inlet of the tool at the beginning of each workday or after about 1 hou...

15 TROUBLESHOOTING GUIDE WARNING: Stop using the tool immediately if any of the following problems occur. Repairs and replacements should only be performed by an authorized technician. For any questions, please contact our customer service at (800) 232-1195, M-F 8-5 CST or email us at [email protect...

11 EXPLODED VIEW AND PARTS LIST EXPLODED VIEW & PARTS LIST 16

WEN Products is committed to building tools that are dependable for years. Our warranties are consistent with this commitment and our dedication to quality. LIMITED WARRANTY OF WEN CONSUMER POWER TOOLS PRODUCTS FOR HOME USE GREAT LAKES TECHNOLOGIES, LLC (“Seller”) warrants to the original purchaser ...