Vermont Casting RUVS40 - Manual
Vermont Casting RUVS40 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Vermont Castings Radiance; Table of Contents
- Page 3 – NG; Radiance Unvented Gas Heater RUVS40; Specifications; Dimensions
- Page 4 – to safe and proper operation of this heater.; DANGER; Safety Information; Warnings
- Page 5 – General Information; Vent Free Features; Quick Installation
- Page 6 – Installation Requirements; WARNING; You must determine that these; Provide For Adequate Ventilation; Space is defined as the room in which you will
- Page 7 – * Do not include Direct Vent appliances as these
- Page 8 – Alcove Clearances; Hearth Requirements; Clearance Requirements; Freestanding Stove
- Page 9 – Assembly; Tools required; Unpacking the Radiance; With the help of an assistant, carefully remove the; Remove the Front, Screen and Logs; Remove the Front Plate. Grasp one side and the
- Page 10 – Kit Contents used with the RUVS40:; AA
- Page 12 – Connect the Gas Line; CAUTION; Thermostat Connection; do not over apply. NEVER! test with an open
- Page 13 – Install the Logs; Push the burner assembly fully to the rear. There
- Page 14 – Engage the sockets in the underside of the top log; Complete the Installation; Replace the screen frame or glass frame assem-
- Page 15 – Operation; Your First Fire; Pilot and Burner Inspection
- Page 16 – LIGHTING INSTRUCTIONS; Push in gas control knob slightly and turn clockwise
- Page 17 – Warning; Condition
- Page 18 – Troubleshooting; Possible Cause; Shut off gas supply; Odor During Operation
- Page 19 – Maintenance; Firebox Cleaning and Inspection; Cleaning Procedure; Glass Replacement
- Page 20 – Catalytic Combustor
- Page 21 – Radiance Vent Free Gas Heater RUVS40
- Page 23 – How To Obtain Service; Warranty
- Page 24 – The Vermont Castings,
1
Vermont Castings Radiance
Tested and listed to
ANSI Z21.11.2b-1998, Unvented Heaters
WARNING:
Improper installa-
tion, adjustment, alteration,
service or maintenance can cause
injury or property damage. Refer
to this manual for correct installa-
tion and operational procedures.
For assistance or additional infor-
mation consult a qualified
installer, service agency, or the
gas supplier.
Installation and service must be
performed by a qualified in-
staller, service agency or the gas
supplier.
Do not store or use gasoline or
other flammable vapors and
liquids in the vicinity of this or
any other appliance.
This is an unvented gas-fired heater. It
uses air (Oxygen) from the room
which it is installed. Provisions for
adequate combustion and ventilation
air must be provided.
Radiance
Vent Free Gas Heater
Model RUVS40
3000-0456c/1000
INSTALLER / CONSUMER
SAFETY INFORMATION
WARNING: If the information in
this manual is not followed ex-
actly, a fire or explosion may
result causing property damage,
personal injury or loss of life.
Please read this manual before
installing and using appliance.
FOR YOUR SAFETY
Installation and service must be per-
formed by a qualified installer, service
agency or the gas suppler.
WHAT TO DO IF YOU SMELL GAS
•
Shut off the gas supply.
•
Do not try to light any appliance.
•
Do not touch any electrical switch;
do not use any phone in your
building.
•
Immediately call your gas supplier
from a neighbor's phone. Follow
the gas supplier's instructions.
•
If you cannot reach your gas
supplier, call the fire department.
Homeowner’s Installation
and Operating Manual
INSTALLER: DO NOT DISCARD THIS MANUAL -
LEAVE FOR HOMEOWNER
RADIAN
CE
0456
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Vermont Castings Radiance ATTENTION CONSUMER: In order to ensure safe and effectiveinstallation, this unit must be installed only bya qualified agency, individual, firm, corporation,or company that is experienced in theinstallation, repair and servicing of this type ofappliance and is familiar wit...
3 Vermont Castings Radiance Fuel Type: NG LP Manifold Pressure; Min. / Max.: 1.7"/3.5" 5.4"/11.0" Min. Inlet Supply Pressure foradjustment:: 5.0" W.C. 11.0" W.C. Max. Inlet Supply Pressure foradjustment: 8.0" W.C. 12.0" W.C. Min. Output, BTU/hr: 26,000 26,000 Max. Out...
4 Vermont Castings Radiance 1. Install only in accordance with National Fuel Gas Code, ANSI Z223.1 - latest edition. (Exception:Do not derate this appliance for altitude. Thisappliance has been tested and listed for use inaltitudes up to 10,000 feet. Maintain the manifoldpressure at 3.5 inches W.C. ...
