Vermont Casting DVBR36 - Manual

Table of Contents:

• Page 2 – DVBR Series Direct Vent Gas Fireplace; Table of Contents
• Page 3 – Installation Instructions; PLEASE READ THE FOLLOWING CAREFULLY
• Page 4 – Fireplace Dimensions (Installed as Top Vent); Fireplace specifications and framing dimensions.; Framing Dimensions
• Page 5 – Fireplace Dimensions (Installed as Rear Vent)
• Page 6 – Clearance to Combustibles; Appliance; Mantels; Mantel Chart; Combustible mantel minimum installation.; Locating Gas Fireplace; Locating Your Fireplace
• Page 7 – Cold climate installation recommendation:; Certified to; Vented Gas Fireplace Heater
• Page 8 – Always provide a union; when using black; Remote Switch Installation; Thread wire through the electrical knockout located; Remote switch wiring diagram for R models.; Typical gas supply installation.
• Page 9 – Optional Top Vent Application; Rear View; Remove screws from outer collar adapter.; Secure flue cover to back of flue outlet. Be sure to; Remove flue cover and flue pipe.; Outer Collar Adapter; Replace flue cover and flue pipe.
• Page 10 – remove insulation; Remove and discard insulation.; • Only CFM Corporation venting components spe-; • Venting terminals shall not be recessed into a wall or; Location of Vent Termination; General Venting; DVBR42 heat shld; Remove screws securing heat shield cover plate. Dis-; Carefully remove the square piece of insulation
• Page 11 – Canadian Installations; General Venting Information - Termination Location
• Page 12 – General Information Assembling Vent Pipes; Flex Vent Pipes; Apply high temperature sealant to 4” and 7” pipes.; Termination clearances.; Termination Clearances; of Caps
• Page 13 – Twist Lock Pipe; Twist Lock Pipes; EXAMPLE; Rear Wall Vent Applications; Refer to Page 19 for venting; ertical Dimension from the Floor of the Unit
• Page 14 – Rear Wall Vent Installations -; When using flex vent, the opening will have to; Noncombustible Walls:; Hole opening should be 7; Locate vent opening on wall.; Vent Opening - Noncombustible Wall; Vent Opening - Combustible Wall; Adjustable zero clearance sleeve.; Top View Flat Installation
• Page 15 – Side View Vent Termination; Install the 7” vent pipe in the same manner as Step 2.; Follow Steps 1 and 2 on Page 14.; Grasp the vent pipe close to the collar and bend to; Vertical Sidewall Applications
• Page 16 – Maximum vent run with elbows.; Elbow 1; Total angular variation =; Maximum elbow usage.; Maximum horizontal runwith no rise.
• Page 17 – Vertical Sidewall Installation; Hole opening must be 7; Vent Opening Combustible Wall; combustible Wall
• Page 18 – Horizontal length requirement.; spacer springs; Install spacer springs.; Install the 4” flex then 7” flex to the termination.
• Page 19 – Below Grade Installation; Below grade installation.; Snorkel; Snorkel installation, recessed foundation.
• Page 20 – Typical Roof; Attic Insulation Shield; Install appropriate pipe sections until above the; Support straps for horizontal runs.; Cut opening equal to 9
• Page 21 – Minimum termination to roof clearance.
• Page 22 – Vent Components; Elbow; Vent components; vent components; Venting Components; Venting Components
• Page 23 – window frame by pulling back on the clamp handles.; Glass Information; Set left and right panels on hearth and bring towards; hearth Panels; Hearth panel location.; Operating Instructions; Remove valve cover; Care must be taken to avoid breakage of the glass.
• Page 24 – Logs; Log Chart; Place Right and Left Rear Logs on rear log support.; Place Left and Right Logs on pem studs on burner.; Lava Rock; NOT
• Page 25 – Place Left and Right Cover Logs and Center Log on grate.; Flame & Temperature Adjustment; flame adjustment knob for SIT valve.
• Page 26 – Top logs must be placed properly onto notches.; Correct flame appearance for DVBR36 model.
• Page 27 – FOR YOUR SAFETY READ BEFORE LIGHTING; WHAT TO DO IF YOU SMELL GAS; To Turn Off Gas To Heater; Lighting and Operating Instructions; Lighting Instructions; Euro SIT
• Page 28 – Troubleshooting – Honeywell VS8421
• Page 29 – SYMPTOM; Troubleshooting the Gas Control System; SIT NOVA 820 MILLIVOLT VALVE
• Page 30 – Fuel Conversion Instructions; Valve Conversion - Honeywell Valve; Remove manifold assembly.; Valve Conversion - SIT Valve; Remove burner orifice,; Remove mounting screws, pressure regulator tower
• Page 31 – Front View; Natural Gas; It is not necessary to remove the pilot tube; Pilot Conversion - PSE; Loosen pilot hood turning counterclockwise using a; Pilot Conversion - SIT; Conversion is complete.
• Page 32 – Burner and Burner Compartment; Cleaning the Standing; If repair is necessary, it should be per-; Correct pilot flame appearance.; Maintenance
• Page 33 – DVBR parts; Log Set Complete
• Page 35 – Optional Accessories; Remove the 9 screws securing burner to combustion; Fan placement; Remote Controls; Model Functions Controlled; ON/OFF and Temperature; IMTFK; Wall mounted thermostat control; Ceramic Refractory Panels; Ceramic Panel Supports
• Page 36 – Rear ceramic panel placement.; Side View; Decorative Glass Panels; Model; Espresso
• Page 39 – IF WARRANTY SERVICE IS NEEDED...; ) Contact your supplier. Make sure you have your warranty,; LIMITED LIFETIME WARRANTY; PRODUCT COVERED BY THIS WARRANTY
• Page 40 – CFM Corporation