Vermont Casting 7PDVS - Manual
Vermont Casting 7PDVS – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – DV Power Vent System; Table of Contents
- Page 3 – NOT; General Information and Instructions for
- Page 4 – DV Power Vent System Parts and Description:
- Page 5 – The DV Power Vent System box already has a 1” stand-off on all sides.; Clearance to Combustible Materials and Access Door; Confined Area Access Door Suggestions
- Page 6 – Models; Restrictor Orifice Sizes and Models
- Page 7 – Installing the DV Power Vent System
- Page 8 – -Install the Vent Pipes and the DV Power Vent System Box:; Inlet; Four different ways to install the Power Vent System Box.; Inlet; Inlet
- Page 9 – times 45 degrees elbows = 90 degrees
- Page 10 – Maximum 40FT of straight pipe.
- Page 11 – be pointed to the sides.; Figure A
- Page 12 – provided with the kit.
- Page 13 – Wiring Diagram
- Page 14 – LED Codes
- Page 15 – Maintenance
- Page 16 – Changing the Orifice Plate After the DV Power Vent Box is Installed
- Page 17 – Screws
- Page 18 – Troubleshooting the Power Vent System; START
- Page 20 – PDVS DV Power Vent System
- Page 21 – Plate Restriction Orifice Size 31/32”
- Page 24 – CFM Corporation
DV Power Vent System
Model
7PDVS
DO NOT STORE OR USE GASOLINE OR
OTHER FLAMMABLE VAPOURS AND
LIQUIDS IN THE VICINITY OF THIS OR
ANY OTHER APPLIANCE.
FOR YOUR SAFETY
WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use
any phone in your building.
•
Extinguish all flames.
•
Immediately call your gas supplier from
your neighbours phone. Follow the gas
suppliers instructions.
•
If you cannot reach your gas supplier call
the fire department.
WARNING!
IF THE INFORMATION IN THIS MANUAL IS
NOT FOLLOWED EXACTLY, A FIRE OR
EXPLOSION MAY RESULT CAUSING
PROPERTY DAMAGE,PERSONAL INJURY
OR LOSS OF LIFE.
Homeowner’s Installation and
Operating Manual
FOR YOUR SAFETY
•
Installation and service must be performed
by a qualified installer, service agency or
your gas supplier.
10003262 8/06 Rev. 3
DESIGN
C ERTIFIE D
C E R T I F I E D
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
DV Power Vent System 2 10003262 General Information .................................................................................................... 3 Power System Parts and Description ......................................................................... 4 Clearance to Combustibles ...........
3 DV Power Vent System 10003262 • This DV Power Vent System was designed to be used only on units with electronic ignition (EN or EP). • This DV Power Vent System was certified by CSA to be used only with CFM Corporation Direct Vent models, as listed in this manual. • This DV Power Vent System can be...
DV Power Vent System 4 10003262 1. DV POWER VENT box assembled with a 6FT power cord.2. Two deflectors to be added to the side wall vent termination.3. Assorted restrictor orifice plates to be used according to the instructions for specific models.4. Installation and Operating Instruction Manual. DV Po...
