Vermont Casting 43LDVT - Manual

Table of Contents:

• Page 2 – LDVT Series Direct Vent Gas Fireplace; Table of Contents
• Page 3 – LDVT Series Direct Vent GaS Fireplace; CAUTION: Due to high glass surface temperature chil-; Installation & Operating Instructions; Proposition 65 Warning:; Certified To; Vented Gas Fireplace Heaters; OFF
• Page 4 – Fireplace Dimensions; Fireplace specifications and framing dimensions.; Framing Dimensions
• Page 5 – Locating Your Fireplace; Appliance; Concentric sections of DV Vent; Mantels; Combustible mantel minimum installation.; Mantel Chart; Combustible mantel leg minimum installation.
• Page 6 – Cold climate installation recommendation:; Hearth; DO NOT; Final Finishing; Flange Location for Desired Drywall Depth; Gas Specifications
• Page 7 – Gas Line Installation; Typical gas supply installation.; alternate; Alternate switch location.; High Elevations; Remote switch wiring diagram.; Remote switch
• Page 8 – Electronic Gas Control Valve
• Page 9 – • Horizontal venting which incorporates the twist lock; General Venting; There must not be any obstruction; POWER CORD; SIT822 Valve with Synetek electronic control wiring diagram.
• Page 10 – General Venting Information - Termination Location; Canadian Installations
• Page 11 – Termination clearances.; General Information on Assembling Vent Pipes; Canadian Installations:; Flex Vent Pipes; flex vent; Apply high temperature sealant to 4” and 7” pipes.; Termination Clearances; of Caps
• Page 12 – Vertical Sidewall Applications; From the point of this intersection, draw a vertical; DV Graphic; ertical dimension from the fl; Twist Lock Pipes
• Page 13 – Support straps for horizontal runs.; According to the chart the maximum; Maximum horizontal vent run.; Maximum number of elbow degrees.
• Page 14 – When using flex vent, the opening will have to; Noncombustible Walls:; Vertical Sidewall Installation; Vent Opening; Vent Opening for Combustible Wall; Opening for Noncombustible Wall; Locate vent opening on wall.; Adjustable zero clearance sleeve.; Measure wall thickness and cut zero clearance sleeve; Zero clearance sleeve is only required for; tical height (X) required from the base of the flue collars
• Page 15 – Apply high temperature sealant to collars or termina-; Vertical Sidewall Installation; spacer springs; Install spacer springs.
• Page 16 – Ensure sidewall venting clearances are observed.; pipe coming through the wall.; Below Grade Installations; Top Vent; Below grade installation.; Install the 4” flex then 7” flex to the termination.; Bend flex vent at 90° so horizontal portion is 6
• Page 17 – Typical offset application.; This Gas Fireplace has been approved for:; Snorkel; Snorkel installation, recessed foundation.
• Page 18 – ceiling above and mark position.; Typical ceiling/roof support; Typical Roof Support; Roof and ceiling supports.; Install appropriate pipe sections until the venting is
• Page 19 – Vertical Restrictor Plate; MUST BE FITTED TO THE APPLIANCE; Replace the rear log support to the same location; Assembling the restrictor plate.
• Page 20 – Vent Components; Vent components; Venting Components; Elbow; Vent components
• Page 21 – Care must be taken to avoid breakage of the glass.; Operating Instructions; Glass Information; Louvre removal; Remove top louvre assembly.; remove glass frame; Window frame assembly removal.; Tilt the glass frame out slightly at the bottom, lift the
• Page 22 – Installation of Logs, Lava Rock & Ember Material; Log Installation; Place ember material on top of burner. Scatter the; Log Identification Chart; Location
• Page 23 – Correct log placement for 36LDVT.; Place ember material on top of; Correct log placement for 39LDVT.
• Page 24 – Scatter lava rock material round the firebox base.; Correct log placement for 43LDVT.; Flame Characteristics; Flame adjustment knob for Honeywell valve.; Flame adjustment knob for SIT valve.
• Page 25 – 3LDV log flames; Correct burner flame appearance for the LDVT fireplaces.
• Page 26 – FOR YOUR SAFETY READ BEFORE LIGHTING; Follow the gas supplier’s instructions.; To Turn Off Gas To Heater; Lighting and Operating Instructions; Lighting Instructions; Euro SIT
• Page 27 – For Fireplaces equipped with SIT822 Gas Valve (EN or EP)
• Page 28 – Troubleshooting Honeywell Millivolt Valve
• Page 29 – Troubleshooting the Gas Control System; Normal Operation
• Page 30 – CONVERTING THE APPLIANCE FROM LP TO; For Model 36LDVT ONLY:; Nova SIT 820 gas valve.; Natural Gas; Propane Gas; Move log locator pins to new locations on rear log; SIT top Convertible Pilot
• Page 31 – Maintenance; Burner and Burner Compartment; Cleaning the Standing; If repair is necessary, it should; Honeywell gas valve.; Honeywell valve
• Page 32 – LDVT parts
• Page 34 – Fuel Conversion Kits; Support Front Log
• Page 35 – FK24 Fan Assembly; Optional Accessories; Fan Kits; fan install; FK24 fan placement.
• Page 36 – Wiring Instructions; WIRING DIAGRAM; Ceramic Refractory Panels; Installation; Slide the side refractory panels into place to hold; Ceramic panels; Ceramic panel installation.; rear ceramic panel; Rear refractory panel installation.; Model; RCI; Remote Controls
• Page 37 – Optional Trim Kits; Regular Trim Kit; Screen Door Kit; Filigree Louvre Kit; Appliance Model
• Page 39 – LIMITED LIFETIME WARRANTY; PRODUCT COVERED BY THIS WARRANTY; IF WARRANTY SERVICE IS NEEDED...; ) Contact your supplier. Make sure you have your warranty,
• Page 40 – Efficiency Ratings; CFM Corporation