Vermont Casting 2823 - Manual

Table of Contents:

• Page 2 – Vermont Castings Jefferson Direct Vent/Natural Vent Gas Heater; Table Of Contents; Assembly Procedures
• Page 3 – from the manufacturer.; Installation & Operating Instructions
• Page 4 – Jefferson Direct Vent/ Natural Vent Stove Dimensions; Attention
• Page 5 – Installation Requirements; Locating the Stove; In choosing a location for the stove, consider:; Clearance Requirements; Minimum Clearances to Combustible Materials; Direct Vent System Only; • Always maintain required
• Page 6 – Fig. 5 Minimum wall thimble centerline.
• Page 7 – Jefferson Direct Vent/Natural Vent; Input; Natural; Gas Inlet and Manifold Pressures; Fig. 7 Horizontal vent termination window.
• Page 8 – Vertical Termination - Direct Vent ONLY; No more than two 90 ̊ elbows may be used.; Fig. 8 Vertical vent termination window.; Vent Termination Clearances; Some considerations are:
• Page 9 – Vent Termination Clearances - Direct Vent ONLY; Location of Vent Termination
• Page 10 – Canadian Installations; General Venting Information - Termination Location
• Page 11 – Venting Requirements - Natural Vent Only; Venting Runs; = Acceptable venting configuration; Outside Corner; Termination Clearances; Recessed Location
• Page 12 – Venting Requirements and Options -; Approved Vent System Components; Minimum Horizontal Vent Kit; CFM Vent Components
• Page 13 – WARNING; Tools Required; Fig. 13 Snapstat assembly and installation.
• Page 14 – General Information; Install the Restrictor Plate. Consult the ‘Vent Run; Venting System Assembly - Direct Vent; Dry fit the Inner pipe assembly to the stove and; Fig. 20 Correct position of fan skirt installation.
• Page 15 – Side Wall Terminations: Dry fit the inner elbow; Fig. 18 Attach inner assembly to flue collar.; Install the Vent Adapter Pipe; Install the Restrictor Plate. Consult the ‘Vent Run; Run a bead of sealant around the bottom end of
• Page 16 – Side Wall Termination Assembly; Locate the vent opening on the wall. Refer to Figure; Combustible Wall; Measure the wall thickness and cut the wall sleeve; Fig. 23 Assemble the wall sleeve and firestop.; For DuraVent pipe only: Install vent pipe by aligning; Slide the wall plate over horizontal run before; Fig. 24 Determine the vertical pipe length.; Install first the inner then the outer straight pipe
• Page 17 – Fig. 26 Install the horizontal pipe and wall plate parts.; For both CFM and DuraVent Systems: Install the; Vent Termination Below Grade
• Page 18 – Vent Assembly; Fig. 30 Install firestops and attic insulation shield.
• Page 19 – Venting System Assembly - Natural Vent; Add additional vent lengths to achieve the proper
• Page 20 – Install the Log Set; Remove the logs from their packaging, and inspect; Fig. 35 Install lava rock and upper logs.
• Page 21 – Connect the Gas Supply Line; Model; Direct Vent; Air Shutter Adjustment Instructions; Remove stove front. Lift stove front up and then
• Page 23 – Fig. 41 Be sure to maintain 90; angle at left burner leg.; Complete the Assembly; Run wires down back of stove, under bottom of rear; Fig. 42 Attach switch assembly to rear shroud.; Install the Stove Front
• Page 24 – Thermostat; Thermostat Connection; Use only a thermostat rated for 500 millivolts.
• Page 25 – Operation; Your First Fire; Flame & Temperature Adjustment; LO; Flame Characteristics
• Page 26 – FOR YOUR SAFETY READ BEFORE LIGHTING; To Turn Off Gas To Heater; Lighting And Operating Instructions; Lighting Instructions; Euro SIT
• Page 27 – Troubleshooting / Honeywell #8420 Gas Control System; SYMPTOM
• Page 28 – Conversion Precautions; Fuel Conversion Instructions; Fig. 51 Attach the gas line to the left side of the valve.; Conversion Procedure; Pilot Type 1
• Page 29 – NOTE: It is very critical to keep the left burner leg, which; Fig. 58 Remove and replace injector orifices.; Table 2. Injector Orifice Size Matrix; Conversion to Natural Gas
• Page 30 – Maintenance
• Page 31 – Gasket Replacement; Determine the correct length of gasket by laying it; Check the Gas Flame Regularly; Fig. 60 Release the latches to release the glass frame.
• Page 32 – C WIRE OR ITS EQUIVALENT.; Wiring Diagrams; Schematic Diagram; Draft Hood
• Page 33 – Jefferson Direct Vent/Natural Vent Gas Heater; Description; Furnace Cement
• Page 35 – Optional Accessories; Fan Kits; Refer to Page 13 for installation instructions.; Remote Controls; ON/OFF and Temperature; Decorative Rings
• Page 36 – IF WARRANTY SERVICE IS NEEDED...; LIMITED LIFETIME WARRANTY