U-Line SS1095 - Manual - manualsarea.com

Page 2 - M A R I N E S E R I E S; IMPORTANT; Warranty Registration; Figure 1; Introduction

2 SS1095 M A R I N E S E R I E S Congratulations on your purchase of a U-Line refrigeration product. A pioneer in the field for more than 40 years, U-Line Corporation is the world’s number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-Line dedicates ...

Page 3 - Table of Contents

SS1095 3 M A R I N E S E R I E S Introduction .................................................................................................. Inside Front Cover Warranty Registration .......................................................................... Inside Front CoverPlease Record Your Mo...

Page 4 - Safety Alert Definitions; Safety Precautions

4 SS1095 M A R I N E S E R I E S IMPORTANT IMPORTANT PLEASE READ all instructions completely before attempting to install, operate, or service your unit.• Proper installation procedures must be followed if this unit is being initially installed, or is moved to a new location after being in service. ...

Page 5 - Figure 2; Initial Startup; Figure 3; Ice Harvest Control; Figure 4; Ice Maker; Product Features; Model; OFF

SS1095 5 M A R I N E S E R I E S Origins Ice MakerModel SS1095 All Origins Ice Makers provide high daily ice production and storage capabilities, and conserve on water, using only 2-3/4 gallons (10.4 L) to produce approximately 22 lbs (10 kg) of ice. • Model SS1095 produces up to 23 lbs (10.4 kg) of...

Page 6 - Figure 5; Normal Operating Sounds; Figure 6

6 SS1095 M A R I N E S E R I E S Figure 5 Ice production may be interrupted by raising the bin arm into an upright and locked position (Figure 5) . The unit will maintain temperature for ice storage. IMPORTANT IMPORTANT If you are not intending to use the ice maker and turn the supply valve off, it ...

Page 7 - WARNING; • If the ambient temperature is expected to drop; Product Disposal; DANGER

SS1095 7 M A R I N E S E R I E S WARNING Electrical Shock Hazard. Disconnect power before servicing. Before operating, replace all panels. Failure to do so may result in death or electrical shock. 1. Remove all consumable contents from the unit. 2. Disconnect power to the unit. 3. Shut off water sup...

Page 8 - • Do not use any solvent-based or abrasive; Defrosting; Figure 7; CAUTION; Condenser Cleaning; Interval - Every Three Months; Figure 8; Cleaning and Maintenance

8 SS1095 M A R I N E S E R I E S Proper cleaning and maintenance of your U-Line product will ensure efficiency, top performance and long life. The maintenance intervals listed are based on normal conditions. You may want to shorten the intervals if you have pets or other special considerations. Inte...

Page 9 - Figure 9; Ice Maker Maintenance; Inlet Screen; Hose Connector

SS1095 9 M A R I N E S E R I E S 1. Disconnect electrical power to the unit. 2. With a standard blade screwdriver or 1/4" nut driver, remove the grille screw (Figure 8) . 3. Remove the grille. WARNING DO NOT touch the condenser fins. The condenser fins are SHARP and can be easily damaged. IMPORT...

Page 10 - Ice Cube Thickness Adjustment; Interval - As Required; Leveling

10 SS1095 M A R I N E S E R I E S SS1095FD model: Align the tabs on the bottom of the grille with the slots in the flange and swing grille up into position. Align the grille and cabinet screw holes (Figure 8) . 10. Insert the grille screw (Figure 8) and tighten. Do not over-tighten. 11. Reconnect po...

Page 11 - Door Reversal; Hinge screws

SS1095 11 M A R I N E S E R I E S Door Alignment Check and Adjustment IMPORTANT IMPORTANT Properly aligned, the door’s gasket should be firmly in contact with the cabinet all the way around the door (no gaps). Carefully examine the door’s gasket to assure that it is firmly in contact with the cabine...

Page 12 - Plastic

12 SS1095 M A R I N E S E R I E S 6. Install hinge on opposite side, bottom of cabinet (Figure 18) . Align hinge outer edge with cabinet before tightening screws. Figure 18 Figure 19 7. Relocate plastic spacer/bushing (Figure 19) on top and bottom of door to opposite side. Clean out bushing hole in ...

Page 13 - Before Calling for Service; Service

SS1095 13 M A R I N E S E R I E S 13. Remove all three screws on the opposite side of the hinge and carefully lift off the door latch assembly (Figure 23) . Figure 23 14. Place the door latch assembly on opposite side of unit. Be sure to tighten all three screws securely (Figure 24). 15. Place door ...

Page 14 - Troubleshooting - What to check when problems occur:; Troubleshooting Guide

14 SS1095 M A R I N E S E R I E S DANGER ELECTROCUTION HAZARD! Never attempt to repair or perform maintenance on the unit unitl the main electrical power has been disconnected. Troubleshooting - What to check when problems occur: 8 Troubleshooting Guide PROBLEM POSSIBLE CAUSE REMEDY The unit frosts ...

Page 15 - U-LINE CORPORATION LIMITED WARRANTY

SS1095 15 M A R I N E S E R I E S U-LINE CORPORATION LIMITED WARRANTY U-Line Corporation warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, ...

Page 16 - For General Inquiries:

For General Inquiries: P.O. Box 245040Milwaukee, Wisconsin 53224-9540 U.S.A.Phone (800) 779-2547 FAX (414) 354-5696www.U-Line.com For Service and Parts Assistance: Phone (800) 779-2547 (414) 354-0300 FAX (414) 354-5696Email: [email protected]: [email protected]...

U-Line SS1095 - Manual

Table of Contents:

Summary

Other U-Line Models