Tripp Lite SMART3000RMOD2U - Manual

5 1 1 2 3 2 4 A B C D A B B A D C E B B 1 Connect the two segments of each shelf using the included screws and wing nuts A . Leave the screws slightly loose so that the shelves can be adjusted in the next step. 2 Adjust each shelf to fit the rack, then mount them in the lowest available space of the...

7 1 2 3 B A 1 Plug the UPS into an outlet on a dedicated circuit. NOTE: After you plug the UPS into a live AC outlet, the UPS will automatically charge its batteries* and will supply power to its outlets unless the unit is turned OFF (see Step 3 below). 2 P lug your equipment into the UPS.* * Your U...

8 4-5 1a 1b 2a 2b 3 3a 4 1 USB and Serial Communication Connection Use the included USB cable 1a and/or RS-232 DB9 serial cable 1b to connect the communication port of a computer to the communication port of the UPS. Install the PowerAlert software appropriate for the computer’s operating system. Co...

9 Indicator Lights (Front Panel) “ON” Button To turn the UPS ON: • with the UPS plugged into a live AC wall outlet, press and hold the “ON” button for one second. Release the button after you hear a beep. If utility power is absent, you can “cold-start” the UPS (i.e.: turn it ON and supply power for...

10 Load Level/Battery Capacity Indicator Lights (Front Panel) Sample LED Displays ”Load / Battery” Bar Graph: The LED bars indicate the level of the output load and battery capacity. 100% Load / Battery Bar LED Load Bar graph: 81% -105% load (Yellow) Battery Bar Graph: 81% -100% battery capacity (Gr...

12 1 2 3 4 5 6 7 8 A B C D The SMART3000RMOD2U features a hot-swappable power module. There is no manual bypass switch on the unit. However, when the bracket holding the power module in place is removed (see Step #3 below), the UPS will automatically switch to “BYPASS” mode, allowing the power modul...

13 1 2 3 4 5 6 7 8 9 10 A B C D E Step 1: Remove front panel A . Step 2 : Disconnect battery connectors B . Step 3: Remove the screws C that secure the battery retention bracket in place. Step 4 : Remove battery retention bracket D . Step 5: Remove/recycle battery E . Step 6 : Replace the battery E ...

14 Before storing your UPS, turn it completely OFF. If you store your UPS for an extended period of time, recharge the UPS batteries for 4 to 6 hours once every three months. NOTE: After you connect the UPS to utility power, it will automatically begin charging its batteries. If you leave your UPS b...

15 Visit www.tripplite.com/warranty today to register the warranty for your new Tripp Lite product. You’ll be automatically entered into a drawing for a chance to win a FREE Tripp Lite product!* * No purchase necessary. Void where prohibited. Some restrictions apply. See website for details. FCC Rad...