Tripp Lite CCC4 - Manual
Tripp Lite CCC4 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Introduction; Connection To Telephone Line (PLUS models only)
- Page 3 – Connecting Your Equipment; Switched Outlets; Command Console Compact; continued
- Page 4 – Features; Circuit Breaker; Diagnostic Indicator Lights
- Page 5 – Front Panels
- Page 6 – Battery Selection
- Page 7 – Specifications
- Page 8 – Warranty
TouchMaster
™
(MT-6)
TouchMaster PLUS
™
(MT 6PLUS)
Command Console
®
(CCI 6)
Command Console PLUS
®
(CCI6PLUS)
Command Console
®
Compact (CCC4)
Power Center (PC 5)
Under-Monitor Surge Suppressors
Owner’s Manual
1111 W. 35th Street Chicago, IL 60609 USA
Customer Support: (773) 869-1234 • www.tripplite.com
Copyright © 2002 Tripp Lite. PowerVerter
®
is a registered trademark of Tripp Lite. All rights reserved.
Your Tripp Lite Under-Monitor Surge Suppressor protects your sensitive electronic equip-
ment from spikes, surges and line noise on the AC power line. It features convenient, fin-
gertip control of AC power for your computer and various peripherals, as well as advanced
diagnostic indicators that display power-protection status. PLUS models include a set of RJ-
style phone jacks for protection against spikes, surges and line noise on a single telephone
line. TouchMaster and Command Console models (except Command Console Compact)
include premium ISOBAR
®
surge suppression.
POSITIONING YOUR UNDER-MONITOR
SURGE SUPPRESSOR
The Under-Monitor Surge Suppressor is designed to be placed between your computer and
monitor. Place the unit on top of your computer and then place your monitor on top of
the Under-Monitor Surge Suppressor's housing. Each Under Monitor Surge Suppressor is
sturdy enough to support the weight of a computer monitor.
Canadian National
Standards
Certified by UL
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Introduction CONNECTING YOUR UNDER-MONITORSURGE SUPPRESSOR Connection to AC Power Line (all models) The Under-Monitor Surge Suppressor power cord should only be connected to a standard3-wire grounded 120-Volt AC, 60-Hz outlet. Connection To Telephone Line (PLUS models only) Under-Monitor PLUS mode...
3 Connecting Your Equipment (See Front and Rear Panel illustrations on page 5 for connection to your specific model.) After you have properly connected your Under-Monitor Surge Suppressor to the AC lineand telephone line (if applicable), you can connect the AC power cords of your equip-ment to the s...
4 Features Circuit Breaker (all models) If the current draw of the equipment connected to the surge suppressor exceeds 15 ampsfor longer than a few seconds, the circuit breaker will open (trip) to prevent any possibledamage. When the circuit breaker trips, the plunger will be extended. Remove the ov...
