Tripp Lite BP240V7RT3U - Manual

Mount the shelved sections (A) of your UPSRMRII kit on the back side of your rack.Mount them in the lowest available space of your rack with with the screws, nuts andwashers provided (B). Note that the support ledges should face inward. Attach mounting ears (C) to the front mounting holes of your eq...

6 Features Familiarize yourself with the location and function of the front and rear panel features before installing and operating your UPS. UPS Front Panel Controls The UPS Front Panel Controls can be rotated in its mounting to match your tower or rackmount installation. To rotate the controls, in...

7 Features continued UPS Rear Panel EPO ACC. RS-232 DRY CONTACT AC INPUT AC OUTPUT BREAKER AC INPUT BREAKER EXTERNAL BATTERY INPUT 240VDC CAUTION: DO NOT DISCONNECT UNDER LOAD G L1 L2 L2 L1 G G L1 L2 L2 L1 G AC OUTPUT C US UL Input: 200/208/220/230/240V~, 50/60Hz29.1/27.9/26.4/25.3/24.2A Output: 200...

8 Features continued UPS Rear Panel 1. Output Terminal Block: Use these terminals to connect your UPS to your equipment or to the transformer’s UPS Connector. Unscrew and remove the cover plate above the block for access. 2. Input Terminal Block: Use these terminals to connect your UPS to your utili...

9 Hardwire your utility power source to your UPS’s input. Remove the top of the box covering the UPS’s power terminals. Pass one end of apower cable through the UPS’s cover box’s right knockout, then connect it to theUPS’s input terminals. Connect the other end to your utility power source. Hardwire...

10 NORMAL BY PASS Hardwire your isolation transformer’s UPS connector toyour UPS’s input and output. Remove the tops of the boxes covering the UPS’s and transformer’s input and outputterminals. Pass the free end of the isolation transformer’s UPS connector throughthe UPS’s cover box’s knockout, then...

11 Connection continued Connect external battery pack(s) to your UPS Your UPS has no internal batteries and must be connected to at least one externalbattery pack to operate. Complete installation and mounting instructions for yourbattery pack(s) appear in the battery pack(s)’s owner’s manual. Make ...

12 Turn input to the UPS ON If the UPS is connected to a transformer, turn the transformer’s UPS and LoadBreakers ON. Turn the UPS’s Input Circuit Breaker ON. Press the UPS’s ON button until you hear a beep to begin inverter operation. If your AC input is not providing power normally, you may “cold ...

13 DIAGNOSTIC MODE AC/DC OK DIAGNOSTIC MODE TESTING INVERTER ON BATTERY MODE LOAD = XXX% X.XXKW Operation When you turn the UPS ON, it will enter Diagnostic Mode and perform a brief self-test lasting about 15 seconds. The results of the self-testare shown on the LCD screen in the sequence below. DIA...

14 Operation continued During normal operation, the first line of your LCD Display shows which operating mode your UPS is in: Online, Economy, On Battery,or Bypass. Online mode: The UPS provides AC power while utility power is available and switches to On Battery mode instantly (zero transfer time) ...

16 Service/Warranty and Insurance Your SmartOnline UPS is covered by the 2-year limited warranty period described below. A variety of service contracts is also availablefrom Tripp Lite, including start-up service contracts and 3- to 5-year SafeSure on-site service contracts. For more information, ca...

17 Specifications Specifications are for UPS, Isolation Transformer, and one battery pack. Model SU6000RT3U SU10KRT3U Input UPS Input Voltage 156V~276V Single Phase 156V~276V Single Phase Transformer Input Voltage 200/208/220/230/240V 200/208/220/230/240V Input Frequency 50/60 Hz ± 3 Hz 50/60 Hz ± 3...