Tripp Lite 1400 XL - Manual
Tripp Lite 1400 XL – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Mounting Instructions
Wallmount
Bracket
for the SmartPro
®
1400XL NET,
BP-36V27 and SNMP Solo
ESPAÑOL: p. 2 FRANÇAIS: p. 2
1111 W. 35th Street
Chicago, IL 60609 USA
Customer Support: (773) 869-1234
www.tripplite.com
Mounting the Bracket
on a Wall
H o l d t h e B r a c k e t l e v e l
against the intended mount-
ing surface and mark the
locations of the mounting
holes (A). Drill 1/8” guide
h o l e s i n t h e s e l o c a t i o n s .
Place the included wash-
e r s a r o u n d t h e i n c l u d e d
s c r e w s , t h e n d r i v e t h e
screws through the mount-
ing holes and into the guide
h o l e s .
C A U T I O N : T h e h a r d w a r e
(screws and washers) in-
cluded with the Bracket is
only intended for use with
plywood surfaces. To mount
your Bracket on a different
surface, you must determine
a safe mounting procedure
and obtain proper hardware.
Copyright © 2000 Tripp Lite. All rights reserved. SmartPro
®
is a registered trademark of Tripp Lite.
Mounting a SNMP Solo
Affix one of the self-adhe-
sive velcro pads included
in the bottom of the bracket’s
S N M P s l o t ( E ) . A f f i x t h e
other pad to the long side of
the SMMP-Solo opposite its
indicator lights. Press the
velcro-covered side of the
SNMP-Solo into the bracket’s
SNMP slot.
Mounting a SmartPro
or Battery Pack
CAUTION: Before mounting
a SmartPro UPS, make sure
the UPS is OFF and un-
plugged. Before mounting a
B P - 3 6 V 2 7 b a t t e r y p a c k ,
make sure that the battery
pack is disconnected from
your SmartPro system. The
UPS or battery pack is ex-
tremely heavy. Take care to
avoid injury while lifting.
Place the UPS or battery
pack in the mounting tray.
The feet of a UPS should
press against the rear ridge
(B) and fit around the center
ridge (C) while the front of
the UPS presses against the
front ridge (D). The base of
a battery pack should fit
between the rear (B) and
center (C) ridges, with its
cords facing the wall.
Next, Pass the safety strap
around the UPS or battery
p a c k a n d t h r o u g h t h e
mounting tray as shown.
The safety strap should pass
through the tray’s outer strap
holes for a UPS or through
the tray’s inner strap holes
for a battery pack. Fully
tighten the safety strap and
fasten the velcro end.
A
B C
D
E
Wallmount Bracket for SmartPro 1400XL NET.p65
3/2/00, 3:43 PM
1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
