Page 2 - • SUMMIT; introduction; Even if you are an experienced R/C enthusiast,; REGISTERING YOUR MODEL
2 • SUMMIT 3 BEFORE YOU PROCEED 3 SAFETY PRECAUTIONS 6 TOOLS, SUPPLIES, AND REQUIRED EQUIPMENT 7 ANATOMY OF THE SUMMIT 8 QUICK START: GETTING UP TO SPEED 9 TRAXXAS TQ i RADIO SYSTEM 17 ADJUSTING THE ELECTRONIC SPEED CONTROL 19 DRIVING YOUR MODEL 22 TUNING ADJUSTMENTS 28 MAINTAINING YOUR MODEL 29 TQ ...
Page 3 - SUMMIT • 3; before you proceed; Your hobby; Refers you to a page with a related topic.; SUPPORT; SAFETY PRECAUTIONS; Important Points to Remember
SUMMIT • 3 before you proceed Traxxas1100 Klein RoadPlano, Texas 75074Phone: 972-265-8000Toll-free 1-888-TRAXXAS InternetTraxxas.comE-mail: [email protected] Entire contents ©2013 Traxxas. Traxxas, Ready-To-Race, TQ, Titan, Summit, and EVX-2 are trademarks or registered trademarks of Traxxas. Othe...
Page 4 - • SUMMIT; Skill Level = Myriad Semi Bold; bluehighway font; C h o o s e t h e M o d e l T h a t i s R i g h t F o r Yo u .; This product is capable of extreme speed; This product is capable of extreme speed; LiPo Batteries; LiPo batteries are; Traxxas does not recommend that anyone under the; Be; TERMS OF USE; - The buyer assumes all risk associated with using this; Your retailer absolutely cannot accept product for return or
4 • SUMMIT This model is not intended for use by children under 14 years of age without the supervision of a responsible and knowledgeable adult. All instructions and precautions outlined in this manual should be strictly followed to ensure safe operation of your model. Previous experience with radi...
Page 5 - SUMMIT • 5; Important Warnings for users of Lithium Polymer (LiPo) batteries:
SUMMIT • 5 Important Warnings for users of Lithium Polymer (LiPo) batteries: Lithium Polymer (LiPo) batteries are significantly more volatile than other rechargeable batteries. ONLY use a Lithium Polymer (LiPo) balance charger with a balance adapter (such as the Traxxas EZ-Peak Plus Charger #2933 or...
Page 6 - • SUMMIT; Recommended Equipment; Use the Right; Supplied Tools and Equipment
6 • SUMMIT Recommended Equipment These items are not required for the operation of your model, but are a good idea to include in any R/C toolbox:• Safety glasses• Thin, hobby-quality cyanoacrylate instant tire glue (CA glue, Part #6468) • Hobby knife• Side cutters and/or needle nose pliers • Phillip...
Page 7 - SUMMIT • 7; anatomy of the summit
SUMMIT • 7 Rear T-Lock Servo Transmission Shifting Servo Front T-Lock Servo Slipper Clutch LED Light Pipe Battery Compartment Door Battery Compartment Vent Receiver Box Antenna Mount Front Suspension Arm Front Bumper Shock Rear Half Shaft Toe Link Electronic Speed Control Battery Door Release Tab Pi...
Page 8 - • SUMMIT; quick start: getting up to speed; Apply other decals if desired.
8 • SUMMIT quick start: getting up to speed The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom corners of Quick Start pages. 1. Read the safety precautions on page 3 8. Detail your model • See page 9 For your own safety, u...
Page 9 - TRAXXAS TQ; INTRODUCTION; Note
SUMMIT • 9 8 Applying the Decals The main decals for your model have been applied at the factory. Additional decals are printed on self-adhesive clear mylar and are die-cut for easy removal. Use a hobby knife to lift the corner of a decal and lift it from the backing. To apply the decals, place one ...
Page 10 - Your model is equipped with the newest TQi 2.4GHz; TRANSMITTER AND RECEIVER; EVX-2 ELECTRONIC SPEED CONTROL; MODEL WIRING DIAGRAM
10 • SUMMIT TRAXXAS TQ i RADIO SYSTEM Your model is equipped with the newest TQi 2.4GHz transmitter with Traxxas Link ™ Model Memory. The transmitter has two channels for controlling your throttle and steering. The receiver inside the model has 5 output channels. Your model is equipped with one serv...
Page 11 - Use the Right Batteries; INSTALLING TRANSMITTER BATTERIES; The EZ-Peak charger is NOT compatible with; CHARGING THE BATTERY PACK; Do not leave battery and charger; If the charger detects any of the battery’s cells are already fully
SUMMIT • 11 2, 3 If the status LED doesn’t light green, check the polarity of the batteries. Check rechargeable batteries for a full charge. If you see any other flashing signal from the LED, refer to the chart on page 30 to identify the code. Use the Right Batteries Your transmitter uses AA batteri...
Page 12 - INSTALLING BATTERY PACKS; Using Different Battery Configurations; Adjusting Battery Position
12 • SUMMIT 4 When rechargeable batteries begin to lose their charge, they will fade much faster than alkaline dry cells. Stop immediately at the first sign of weak batteries. Never turn the transmitter off when the battery pack is plugged in. The model could run out of control. 6-cell Battery Orien...
Page 13 - Spring Clip Removal; THE TRAXXAS HIGH-CURRENT CONNECTOR
SUMMIT • 13 TRAXXAS TQ i RADIO SYSTEM The battery compartments can be reconfigured to accept many sizes of LiPo batteries. If you are using batteries that are very thick, the spring clip may need to be removed from the battery compartment. Spring Clip Removal 1. Pull down on the inside of the clip. ...
Page 14 - RADIO SYSTEM BASIC ADJUSTMENTS; Throttle Neutral Adjustment; Turn to EVX-2 Setup Programming on; Steering Trim; RADIO SYSTEM CONTROLS
14 • SUMMIT • Always turn your TQi transmitter on first and off last. This procedure will help to prevent your model from receiving stray signals from another transmitter, or other source, and running out of control. Your model has electronic fail-safes to prevent this type of malfunction, but the f...
Page 15 - USING THE RADIO SYSTEM; WARNING
SUMMIT • 15 TRAXXAS TQ i RADIO SYSTEM 6, 7 Using Reverse: While driving, push the throttle trigger forward to apply brakes. Once stopped, return the throttle trigger to neutral. Push the throttle trigger forward again to engage proportional reverse. Automatic Fail-Safe The TQi transmitter and receiv...
Page 16 - Decreased Steering Sensitivity (Negative Exponential); SETTING UP THE ANTENNA; Do not; Correct
16 • SUMMIT TQi Binding Instructions For proper operation, the transmitter and receiver must beelectronically ‘bound.’ This has been done for you at the factory. Should you ever need to re-bind the system or bind to another transmitter or receiver, follow these instructions. Note : the receiver must...
Page 17 - ADJUSTING THE ELECTRONIC SPEED CONTROL; Never use LiPo batteries; When the LED blinks RED ONCE, pull the throttle; MOSFET
SUMMIT • 17 ADJUSTING THE ELECTRONIC SPEED CONTROL The EVX-2 electronic speed control is factory set and should not require any adjustments. These instructions are provided for your reference. Battery Settings (Low-Voltage Detection Setting) The Low-Voltage Detection circuitry constantly monitors th...
Page 18 - Thermal Shutdown Protection; Never use LiPo batteries while Low-Voltage Detection
18 • SUMMIT ADJUSTING THE ELECTRONIC SPEED CONTROL 4. Return the throttle trigger to neutral. The LED will shine red.5. Move the throttle trigger forward again to engage reverse (Profile #1). The LED will turn off. Once full reverse power is reached, the LED will shine red. 6. To stop, return the th...
Page 19 - DRIVING YOUR MODEL; Operating the High-Low Transmission
SUMMIT • 19 9 DRIVING YOUR MODEL Now it’s time to have some fun! This section contains instructions on driving and making adjustments to your model. Before you go on, here are some important precautions to keep in mind. • Allow the model to cool for a few minutes between runs. This is particularly i...
Page 20 - mAh Ratings and Power Output; RUNNING IN WET CONDITIONS; Precautions
20 • SUMMIT • Maintain your model. Do not allow dirt or damaged parts to cause binding in the drivetrain. Keep the motor clean. mAh Ratings and Power Output The mAh rating of the battery can affect your top-speed performance. The higher capacity battery packs experience less voltage drop under heavy...
Page 21 - RECEIVER BOX: MAINTAINING A WATERTIGHT SEAL
SUMMIT • 21 4. Blow off the truck with compressed air (optional, but recommended). Wear safety glasses when using compressed air. 5. Remove the wheels from the truck. 6. Spray all the bearings, drivetrain, and fasteners with WD-40® or similar water-displacing light oil. 7. Let the truck stand or you...
Page 22 - SUSPENSION TUNING; Springs; TUNING ADJUSTMENTS; The shocks are; Rocker Arm
22 • SUMMIT Summit does not require any specialized knowledge or understanding of its unique suspension and drivetrain to perform typical, everyday setup and tuning adjustments. Adjustment procedures for alignment, spring rate, damping, steering, and ride height are covered here. SUSPENSION TUNING S...
Page 23 - SHOCK TUNING; Shock Oil; Multi-tool Shock Functions
SUMMIT • 23 TUNING ADJUSTMENTS decreased by installing different rocker arm sets. The rockers are labeled Progressive 1 to Progressive 3. Progressive 1 rockers will provide a low progressive rate that maintains consistent damping force across the whole range of suspension travel. Progressive 2 rocke...
Page 24 - ALIGNMENT SETTINGS; Toe Adjustment; Decrease; Shock Piston Hole Sizes
24 • SUMMIT Shock disassembly The shocks must be removed from the vehicle and disassembled to change the pistons. Use the shock exploded views included with the model to aid in the assembly process.1. Remove the spring and lower spring retainer from the shock. 2. Remove the shock cap (A) and empty t...
Page 25 - Transmission Tuning; Adjusting the Slipper Clutch; WHEELS AND TIRES; Tighten; Positive camber
SUMMIT • 25 hex wrench engagement). The upper pivot ball is normally screwed all the way in. Negative camber is achieved by screwing the pivot ball of the lower control arm out. Note: When camber is changed, the toe angle of the wheel has to be reset. Static Camber Base Factory SettingsFront: 1-degr...
Page 26 - MOTORS AND GEARING; Gearing Compatibility Chart:; Spur Gear; High Gear
26 • SUMMIT model (listed in your parts list). Experimentation with different types of tires is recommended to see which ones work the best on the terrain where the model is run. When selecting tires, consider the overall diameter and the rubber compound (hard or soft). If the overall diameter of th...
Page 27 - DUAL SERVO STEERING SYSTEM; Adjusting The Steering System; T-LOCK SERVO INSTALLATION; Differential Locked; Steering Link Length Template
SUMMIT • 27 DUAL SERVO STEERING SYSTEM Summit uses dual-servo steering and a single heavy-duty servo saver for powerful, responsive steering. To prevent unnecessary receiver battery drain, it is important to make sure that the servos are “at rest” when the steering is at neutral. If one servo is out...
Page 28 - MAINTAINING YOUR MODEL; The following procedures should be taken
28 • SUMMIT MAINTAINING YOUR MODEL Your model requires timely maintenance in order to stay in top running condition. The following procedures should be taken very seriously. Inspect the vehicle for obvious damage or wear. Look for: 1. Cracked, bent, or damaged parts2. Check the wheels and steering f...
Page 29 - TRAXXAS LINK MODEL MEMORY; TQ; Restoring Factory Defaults
SUMMIT • 29 Your Traxxas transmitter has a programmable Multi-Function knob that can be set to control various advanced transmitter functions (set to Steering Sensitivity by default, see page 16). Accessing the programming menu is done by using the menu and set buttons on the transmitter and observi...
Page 30 - Failsafe; TRANSMITTER LED CODES; Model Lock; Press and hold MENU to return to driving mode.; : To unlock a memory, press SET twice at step 5. The LED will
30 • SUMMIT TQ i ADVANCED TUNING GUIDE Failsafe Your Traxxas radio system is equipped with a built-in failsafe function that returns the throttle to its last saved neutral position in the event of a signal loss. The LED on the transmitter and on the receiver will rapidly flash red. In order to re-ac...
Page 31 - MENU TREE; Press MENU twice. The red LED will blink three times repeatedly to; Enter Programming
SUMMIT • 31 TQ i ADVANCED TUNING GUIDE The Menu Tree below shows how to navigate through the TQi transmitter’s various settings and functions. Press and hold MENU to enter the Menu Tree, and use the following commands to navigate through the menu and select options. MENU: When you enter a menu, you ...
Page 32 - MENU TREE FORMULAS
Set Multi-Function knob for STEERING SENSITIVITY (Expo) Press/hold MENU green LED blinks Press SET red LED blinks x 8 Press SET to confirm green LED blinks (x8) Press/hold MENU returns to driving mode Set Multi-Function knob for THROTTLE SENSITIVITY (Expo) Press/hold MENU green LED blinks Press SET ...
Page 33 - PROGRAMMING YOUR TQ; or iPod touch; Traxxas Link; Tap and slide to adjust Steering Sensitivity,
SUMMIT • 33 TQ i ADVANCED TUNING GUIDE The TQi Docking Base is sold separately (Part #6510). The Traxxas Link application is available from the Apple App store for iPhone and iPod touch mobile devices. iPhone and iPod touch are not included with the TQi Docking Base. For more information about the T...
