Page 2 - WARNING; Introduction
For assistance, please seewww.Toro.com/supportfor instructional videos orcontact your AuthorizedService Dealer beforereturning this product. WARNING CALIFORNIA Proposition 65 Warning The power cord on this product contains lead, a chemical known to the State of California to cause birth defects or o...
Page 3 - With your mobile device, you can scan the QR code on
Whenever you need service, genuine the manufacturer parts, or additionalinformation, contact an Authorized Service Dealer or the manufacturerCustomer Service and have the model and serial numbers of your productready. Figure 1 identifies the location of the model and serial numbers on the product. W...
Page 6 - Safety; Read All Instructions
Safety IMPORTANT SAFETYINSTRUCTIONS WARNING When using electric gardening tools, always read and followbasic safety warnings and instructions to reduce the risk offire, electric shock, and personal injury, including the following: Read All Instructions I. Training 1. The operator of the tool is resp...
Page 8 - IV. Maintenance and Storage
9. Remove the battery pack from the tool whenever you leave itunattended. 10. Do not force the tool—Allow the tool to do the job better and safer atthe rate for which it was designed. 11. Do not overreach—Keep proper footing and balance at all times,especially on slopes. Walk, never run with the too...
Page 10 - Safety and Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to theoperator and are located near any area of potentialdanger. Replace any decal that is damaged or missing. decal139-5346 139-5346 decal139-5210 139-5210 1. Warning—read the Operator’s Manual ; stay away from moving...
Page 11 - Setup; Connecting the Attachment to the Power Head; No Parts Required; Procedure
Setup 1 Connecting the Attachment to the Power Head No Parts Required Procedure 1. Install the square shaft of the attachment into the square shaft ofthe power head (A of Figure 3 ). 2. Align the locking button on the lower shaft with the slotted hole onthe upper shaft and slide the 2 shafts togethe...
Page 13 - Installing the Guard; Parts needed for this procedure:
2 Installing the Guard Parts needed for this procedure: 1 Guard 4 Washer 4 Bolt Procedure 1. Align the trimmer guard beneath the guard mount as shown in Figure 4 . g333216 Figure 4 1. Guard mount 3. Washer 2. Trimmer guard 4. Bolt 2. Secure the guard to the trimmer using the 4 washers and 4 bolts as...
Page 14 - Product Overview; Specifications; Appropriate Temperature Ranges
Product Overview g372306 Figure 5 1. Guard 3. Bump button 2. String Specifications Model 88716, attaches to 51810T Charger Type Flex-Force 60V lithium-ion chargers Battery Type Flex-Force 60V lithum-ion batteries Appropriate Temperature Ranges Charge/store the battery pack at 5°C (41°F) to 40°C (104...
Page 15 - Attachments/Accessories; Operation; Starting the Attachment
Attachments/Accessories A selection of Toro approved attachments and accessories is available foruse with the machine to enhance and expand its capabilities. Contactyour Authorized Service Dealer or authorized Toro distributor or go towww.Toro.com for a list of all approved attachments and accessori...
Page 17 - Shutting Off the Trimmer; Removing the Attachment from the Power Head
Shutting Off the Trimmer To shut off the trimmer, release the trigger. Whenever you are not using the trimmer or are transporting the trimmer toor from the work area, remove the battery pack. Removing the Battery Pack from the PowerHead Press the battery latch on the machine to release the battery p...
Page 18 - Advancing the Line Using the Bump Feed; Advancing the Line Manually
Advancing the Line Using the Bump Feed 1. Run the trimmer at full throttle. 2. Tap the bump button on the ground to advance the line. The lineadvances each time the bump button is tapped. Do not hold thebump button on the ground. Note: The line trimming cut-off blade on the grass deflector cuts the ...
Page 19 - Adjusting the Cutting Swath
Adjusting the Cutting Swath The trimmer comes from the factory with a cutting swath of 36.6 cm (14inches) as shown in A of Figure 10 . Refer to the following instructions to adjust the swath to 40.6 cm (16 inches) as shown in D of Figure 10 . 1. Remove the swath blade from the bottom of the guard by...
Page 20 - Operating Tips
Operating Tips • Keep the trimmer tilted toward the area being cut; this is the bestcutting area. • The string trimmer cuts when you move it from right to left. Thisprevents the trimmer from throwing debris at you. • Use the tip of the string to do the cutting; do not force the string headinto uncut...
Page 21 - Maintenance; CAUTION
Maintenance After each use of the trimmer, complete the following: 1. Remove the battery from the power head. 2. Wipe the trimmer clean with a damp cloth. Do not hose the trimmerdown or submerge it in water. CAUTION The line cutoff blade on the deflector is sharp and can cutyou. Do not use your hand...
Page 22 - Replacing the String; Do not use any other gauge or type of string, and; Do not disassemble the trimmer head
Replacing the String Important: Use only 2 mm (0.080 inch) diameter monofilament string (the manufacturer Part No. 88611) or 2.4 mm (0.095 inch) diametertwisted monofilament string (the manufacturer Part No. 88202). 1. Remove the battery pack and clean any debris from the trimmerhead. 2. Remove any ...
Page 24 - Lubricating the Gearbox
Lubricating the Gearbox Service Interval: Every 25 hours or monthly, whichever comes first 1. Shut off the trimmer, remove the battery pack, and clean any debrisfrom the trimmer head. 2. Set the trimmer so the gearbox is upright. 3. Remove the plug from the side of the trimmer ( Figure 13 ). g524953...
Page 25 - Storage; Store the machine, battery pack, and charger only
Storage Important: Store the machine, battery pack, and charger only in temperatures that are within the appropriate range; refer to Specifications (page 14) . Important: If you are storing the machine for a year or longer, remove the battery pack from the machine and charge the batterypack until 1 ...
Page 26 - Troubleshooting
Troubleshooting Perform only the steps described in these instructions. All furtherinspection, maintenance, and repair work must be performed by anauthorized service center or a similarly qualified specialist if you cannotsolve the problem yourself. Always remove the battery from the tool when troub...
Page 28 - California Proposition 65 Warning Information; Cancer and Reproductive
California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in C...
