Tiger NH TS100-135A - Manual

Page 3 - SAFETY PRECAUTIONS

PAGE - 3 This symbol means: CAUTION ! Your safety is at rick ! – Any R.O.P.S. (roll over protective structure) should not be drilled, welded on, or altered in any manner. Any alteration may reduce your protection. – Do not bypass the tractor neutral safety swith. Jumping or bypassing can cause tract...

Page 4 - OPERATIONAL SAFETY PRECAUTIONS

PAGE - 4 OPERATIONAL SAFETY PRECAUTIONS This symbol means: CAUTION ! Your safety is at rick ! – Reduce speed when turning, taking curves, rough ground, or hillsides to reduce chance of rollover. – Always keep tractor in gear when traveling downhill to prevent runaway. – When driving on a road, day o...

Page 5 - OPERATION

PAGE - 5 OPERATION Be sure the ball valves on the mower hydraulic tank are OPEN before starting the tractor. Serious damage to the hydraulic system can occur if the valves are not OPEN. For brush operation: open the high pressure valve located near the pressure port of the pump and close the high pr...

Page 7 - TIGER SWEEPER

PAGE - 7 1. Do not store sweeper polypropylene brushes in direct sunlight! Direct sunlight will cause the bristles to deteriorate, causing the bristles to become brittle. If the broom is to be stored for any length of time, store it in the shade, inside, or cover the brush with a tarp to protect it ...

Page 8 - MOUNTING INSTRUCTIONS

PAGE - 8 MOUNTING INSTRUCTIONS Please rea and understand the instructions and schematics completely before beginning assembly. Parts and drawings may vary slightly due to the variety of tractor makes and models. The mounting kit you receive should be correct for your application. If questions arisep...

Page 10 - LEVELING INSTRUCTIONS

PAGE - 10 LEVELING INSTRUCTIONS The sweeper must be leveled t maintain even brush wear and to produce efficient sweeping action. If the broom is not leveled at first and periodically after that, then it willput stress on certain parts causing excessive wear. The broom is easily leveled if thesesteps...

Page 11 - LEVELING INSTRUCTIONS CONTINUED

PAGE - 11 Make a note of the measurements. Swing the brush head assembly to the left and take the same measurements. If the measurements are not equal, refer to previousleveling steps and illustrations for adjustments. LEVELING INSTRUCTIONS CONTINUED 5. After leveling, tighten the brush head mountin...

Page 12 - SUPPORT YOKE ADJUSTMENT

PAGE - 12 SUPPORT YOKE ADJUSTMENT NOTE: This section applies only to units with serial number 75146 and above. Unitswith serial number below 75146 do not have adjustable support yokes. Before operatingthe sweeper the brush head frame support yokes should be checked and if necessaryadjusted as follow...

Page 13 - BRUSH REPLACEMENT

PAGE - 13 BRUSH REPLACEMENT 1. Disconnect the two hydraulic hoses at both motors. IMPORTANT: Tape over the ends of the hydraulic hoses and the hydraulic motor ports to prevent contamination of the hydraulic system. 2. Remove the four bolts holding the hood in place. Lift the hood off the brush and s...

Page 14 - MOTOR AND HUB REPLACEMENT

PAGE - 14 MOTOR AND HUB REPLACEMENT 1. Disconnect the two hydraulic hoses at both motors. IMPORTANT: Tape over the ends of the hydraulic hoses and the hydraulic motor ports to prevent contamination of the hydraulic system. 2. Remove the four bolts holding the hood in place. Lift the hood off the bru...

Page 16 - TRACTOR MOUNT - MAIN FRAME