Summit Appliance BIM100ADA - User Manual

Page 2 - TABLE OF CONTENTS

2 TABLE OF CONTENTS Important Safety Instructions 3 Precautions 3 Grounding Instructions 4 Location of Parts 5 Installation Instructions 6-7 Before Using your Ice Maker 6 Installing the Ice Maker 6 Connecting the Water Line 6-7 Installing the Purification Filter 7 Operation 7-8 Ice Full Sensor 7 Ice...

Page 3 - IMPORTANT SAFETY INSTRUCTIONS; PRECAUTIONS; READ ALL SAFETY INFORMATION BEFORE USING.

3 IMPORTANT SAFETY INSTRUCTIONS Child entrapment and suffocation are not problems of the past. Unused or abandoned icemakers are still dangerous, even if they will just “sit in the garage a few days.” • Before you throw away your old icemaker, take off the doors. Leave any shelves or drawers in plac...

Page 4 - GROUNDING INSTRUCTIONS

4 GROUNDING INSTRUCTIONS WARNING: Improper use of the grounding plug can result in a risk of electric shock. • This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. • This appli...

Page 5 - LOCATION OF PARTS

Page 6 - INSTALLATION INSTRUCTIONS; Before Using the Ice Maker; Installing the Ice Maker

6 INSTALLATION INSTRUCTIONS Before Using the Ice Maker • Remove any exterior or interior packaging. • Attach the four leveling feet to the bottom of the appliance. NOTE: Before connecting the ice maker to a power source, let the appliance stand upright for approximately two hours. This will reduce t...

Page 7 - Installing the Purification Filter; OPERATION; Ice Full Sensor

7 • Connect a 3/8” diameter pipe to the tap water line. • The pressure of the tap water line should be maintained at a level between 20psi (1.4bar) and 80psi (5.5bar). The tap water line and drain pipeline should be planned and prepared at the place of installation. The electric power, tap water pip...

Page 8 - Changing the Purification Filter; CLEANING; Cleaning the Ice Basin; Cleaning the Condenser Filter

8 Changing the Purification Filter When the purification filter is no longer active, the ice maker will not produce ice. The filter cycle is typically 6 months, but might be shorter, depending on your environment and quality of your water. Replacement filters can be ordered online at summitappliance...

Page 9 - SANITIZING

9 Cleaning the Condenser 1. Unscrew the two screws at the bottom of the front panel. 2. Pull down on the front panel to separate it from the appliance. 3. Use a vacuum cleaner to remove dust from the condenser. 4. After cleaning, insert the front cover into the upper holes, and push up and into plac...

Page 10 - TROUBLESHOOTING

10 When the first sanitizing procedure is complete, remove the packing down from the ice basin by pulling downward. Remove the water inside the packing down, and insert it back into the ice vessel sheet. Conduct the sanitizing procedure two more times. Once the third sanitizing procedure is complete...

Page 11 - TECHNICAL SPECIFICATIONS

11 TECHNICAL SPECIFICATIONS Item Unit Specification BIM100, SCIM101, ALIM100 M a x i m u m I c e M a k i n g (Based on 10 ℃ ) Kg /day (Lbs./day) 50(110.2) Freezing Capability Ice is made after 30 minutes. Size (Installed Height) Depth mm(inch) 574(22.5) Width 520(20.4) Height 862(33.9) (FOOT include...

Page 12 - LIMITED WARRANTY

12 LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory -specified parts and repair...

Summit Appliance BIM100ADA - User Manual

Table of Contents:

Summary

Other Summit Appliance Ice Makers Models