Sterling Water Heater - Manual

Sterling Water Heater – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1

2

3

4

Page: / 4 Go to

Next Page

PDF Text Table of Contents

Table of Contents:

• Page 2 – Micro Series Water Temperature Control Units; Complete Operation and Installation Instructions; Street · New Berlin, WI 53151 · USA; Spare Parts Location
• Page 3 – Spare Parts List; (See previous page for Spare Parts Location)
• Page 4 – Troubleshooting - Quick Guide; Problem

Loading the manual

Micro Series Water Temperature Control Units

Reference Manual (PN: 682.89373.00) for

Complete Operation and Installation Instructions

(Available online at www.sterlco.com)

Sterling, Inc.

Part No: 682.92594.10

2900 S. 160

th

Street · New Berlin, WI 53151 · USA

Bulletin No: HC2-320

Tel. 262.641.8610 • Fax 262.641.8653

Quickstart Installation Checklist

(Refer to main manual for complete installation instructions).

1. Connect 3-phase power based on nameplate data.
2. Install properly sized plumbing between temperature control unit

and primary processing equipment (supply and return).

3. Install properly sized plumbing between temperature control unit

and cooling water supply and return. Cooling water supply must be
at least 16 psi (110 kPa/1.1bar) for a 250˚F (121°C)

configuration

and 55 psi (379 kPa/3.8bar)

for a 300˚F (149°C) configuration.

4. Ensure proper pump rotation. (The pump should be moving

clockwise while looking at the motor end).

Unit Operation

(Refer to main manual and controller manual for complete operating instructions).

Start Up

1. Push

the

ON/OFF

rocker switch to the

ON ( | )

to energize the unit and begin the temperature control cycle.

The switch will be illuminated whenever the unit is on.

2. The unit will automatically vent for approximately one minute.
3. If needed, press and hold the vent button to purge any additional air from the process loop.

4. Set process temperature (

PV

) by pressing the

Up Arrow

or

Down Arrow

keys.

Shut Down

1. Adjust set point below 150˚ F (66˚ C).

Allow unit to stabilize.

2. Push ON/OFF rocker switch to the OFF

( 0 ) position to de-energize the unit.

Standard Controller

Other Sterling Models

• Sterling 2000
  • Manual
• Sterling S1201-0
  • Manual
• Sterling SSE-2
  • Manual
• Sterling CFP05-30W
  • Manual
• Sterling 7210-B
  • Manual
• Sterling E045200
  • Manual
• Sterling BB122430
  • Manual
• Sterling 131
  • Manual
• Sterling STT 500
  • Manual
• Sterling C711FST
  • Manual